Effect of single and double hemitenotomy on equine deep digital flexor tendon length and strength in experimental load challenges.

OBJECTIVE: To evaluate a double hemitenotomy (DHT) technique as an alternative to complete deep digital flexor (DDFT) tenotomy. STUDY DESIGN: Experimental ex vivo study. SAMPLE POPULATION: Isolated DDFTs (n = 30) and cadaveric forelimbs (n = 16). METHODS: In part 1, 15 isolated DDFT pairs were used. Two hemitenotomies were created in 1 DDFT while the other served as reference. Monotonic tensile load was applied. Tendon lengthening, load reduction, and load at failure were recorded. In part 2, 16 cadaveric forelimb pairs were subjected to DHT followed by complete tenotomy (CT) under monotonic compressive load. Differences between DHT and controls were assessed with Wilcoxon signed rank tests or Friedman tests. RESULTS: In isolated tendons and cadaveric forelimbs, DHT resulted in DDFT lengthening (median, +1.9 mm and + 3.05 mm) and load reduction (median, -16.7 and -11.2 kg). Less lengthening was achieved with DHT compared to CT (P = .008). Load reduction did not occur between DHT and CT was observed during compressive testing (P = 1). Load reduction following the first hemitenotomy incision was smaller when compared to the second (P = .022). Isolated DHT tendons failed at a tensile load of 195 kg, while no intact tendons failed (P = .0001). CONCLUSION: Double hemitenotomy was comparable to CT in load reduction. It reduced tensile strength, but load at failure was similar or exceeded the estimated DDFT load at stance. CLINICAL SIGNIFICANCE: Hemitenotomy may be a useful alternative for surgical management of horses with laminitis, but in vivo studies are needed to confirm these findings.

Tensile strength and early healing of self-locking and surgeon's knots.

OBJECTIVE: To compare the biomechanical properties and healing of ventral midline celiotomies (VMC) closed with a self-locking knot combination and forwarder start and Aberdeen end (F-A) vs a traditional knot combination and surgeon's start and end (S-S). STUDY DESIGN: In vivo, experimental. ANIMALS: Twenty-one horses. METHODS: Fourteen horses underwent VMC, which was closed with either an F-A (n = 7) or an S-S (n = 7) knot combination. Incisions were subjectively graded by masked evaluators for dehiscence, edema, and drainage. Biomechanical testing was performed on three abdominal segments, and histology was performed on one segment from each animal after humane euthanasia 10 days post-VMC. The abdominal wall of control horses (n = 7, no celiotomy) was collected for biomechanical testing. RESULTS: Forwarder start and Aberdeen end and S-S horses had less tensile strength compared with control horses (P ≤ .001). No differences were detected between treatment groups for any variable evaluated, including tensile strength (P = .975), location of failure (P = .240), and histologic healing at the knot (P = .600). CONCLUSION: Closure of VMC with self-locking knots resulted in biomechanical and healing features similar to those with a traditional closure technique, with neither restoring the tensile strength of the linea alba. CLINICAL SIGNIFICANCE: Results of this study provide evidence to support a clinical trial to evaluate long-term performance of the F-A self-locking knot closure in horses.

In vitro evaluation of the knot-holding capacity and security, weight, and volume of forwarder knots tied with size-3 polyglactin 910 suture exposed to air, balanced electrolyte solution, or equine abdominal fat.

OBJECTIVE: To evaluate the effect of exposure to a balanced electrolyte solution (BES), or equine abdominal fat on the knot-holding capacity (KHC), relative knot security (RKS), weight, and volume of forwarder knots versus surgeon's knots. SAMPLE: 315 knots tied and tested in vitro. PROCEDURES: United States Pharmacopeia size-3 polyglactin 910 suture exposed to air (dry [control]), equine abdominal fat (fat-exposed), or BES (BES-exposed) was used to tie forwarder knots with 2, 3, and 4 throws and surgeon's knots with 5, 6, 7, and 8 throws. A universal materials testing machine was used to test the tensile strength of suture and knots to failure, and the KHC, RKS, weight, and volume of knots were determined. RESULTS: Forwarder knots had significantly higher KHC and RKS and lower volume, compared with surgeons' knots. Forwarder knots tied with fat-exposed suture had greater weight, but not volume, than did forwarder knots tied with dry or BES-exposed suture with the same number of throws. CONCLUSIONS AND CLINICAL RELEVANCE: Results indicated that forwarder knots were superior to surgeon's knots when configured as start knots intended for continuous lines of suture. Exposure to media did not negatively affect mechanical or physical properties of forwarder knots and may improve specific biomechanical functions, including KHC and RKS.

In vitro evaluation of square and surgeon's knots in large gauge suture.

OBJECTIVE: To investigate the strength and size of surgeon's and square knots for starting and ending continuous suture lines using large gauge suture. STUDY DESIGN: In vitro mechanical study. STUDY POPULATION: Knotted suture. METHODS: Surgeon's and square knots were tested using 2 and 3 USP polyglactin 910 and 2 USP polydioxanone under linear tension on a universal testing machine. Failure mode and knot holding capacity (KHC) were recorded, and relative knot security (RKS) was calculated as a percentage of KHC. Comparisons were made between number of throws, suture size, suture type, and knot types. Knot volume and weight were assessed by a digital micrometer and balance, respectively. RESULTS: There were no significant differences in KHC (P = .295), RKS (P = .307), volume (P = .128), or weight (P = .310) between square and surgeon's knots at the start or end of suture lines with the same number of throws and suture type. A minimum of 6 throws were required for start knots and 7 throws at end knots to prevent unraveling. Knots tied with 3 polyglactin 910 were strongest (P < .001) and 2 polyglactin 910 produced knots with higher KHC and RKS than 2 polydioxanone (P < .001). CONCLUSION: No consistent differences were detected between knots types tied with the same suture material; however, number of throws affected KHC and RKS up to 6 throws in start or 7 throws in end knots. The configuration of square and surgeon's knots performed at the end of a continuous line alters their KHC, supporting the use of additional throws for knot security.

Effect of fluid media on the mechanical properties of continuous pattern-ending surgeon's, square, and Aberdeen knots in vitro.

OBJECTIVE: To investigate the knot holding capacity (KHC) of pattern-ending square, surgeon's and Aberdeen knots each tied in 4 throw combinations using large gauge suture after exposure to media commonly found in equine abdominal surgery. STUDY DESIGN: In vitro mechanical study. SAMPLE POPULATION: Knotted suture strands (n = 10/group). METHODS: Strands of 2 polydioxanone or 3 polyglactin 910 were exposed to 1 of 4 media for 15 minutes. Control suture strands remained dry. Media used included balanced electrolyte solution, 1% sodium carboxymethylcellulose, equine serum, or equine fat. Pattern-ending knots for the 3 knot configurations were loaded to failure in a linear fashion on a materials testing machine to determine KHC. RESULTS: Surgeon's knots tied using media-exposed 3 polyglactin 910 had a significantly higher KHC than the same dry knots with 5 and 6 throws. Square knots tied using media-exposed to 3 polyglactin 910 had a significantly higher KHC than the same dry knots at 5 throws. Aberdeen knots tied with either media-exposed 2 polydioxanone or 3 polyglactin 910 had a significantly higher KHC than their equivalent dry knots. Aberdeen knots had a superior KHC, while requiring less suture than both surgeon's and square knots. CONCLUSION: Media exposure either had no effect on KHC or significantly improved the KHC of all knots investigated. Based on KHC and knot volume, Aberdeen knots tied using media-exposed 3 polyglactin 910 with 3 throws and 1 turn are recommended to end a continuous suture pattern.

Biomechanical comparison of two ostectomy configurations for partial mandibulectomy.

OBJECTIVE: To determine the stiffness and load to failure of two different ostectomy configurations using canine mandibles. STUDY DESIGN: Cadaveric biomechanical assessment. ANIMALS: Paired mandibles (n = 30). METHODS: Standardized partial ostectomies were created on the alveolar surface of 30 mandibles. Samples were randomly assigned to right-angled (n = 15) or crescentic ostectomy (n = 15). Excision spanned the mesial aspect of the fourth premolar tooth to the distal aspect of first molar tooth. Mandibles were loaded to failure in three-point bending. The stiffness, displacement at maximum load, and load to failure were measured. RESULTS: There was no significant difference in stiffness (p = 0.59), displacement at maximum load (p = 0.16) and load to failure (p = 0.76) between right-angled or crescentic ostectomy. Right-angled and crescentic ostectomy failed mostly by fracture through an empty alveolus (11/15 and 13/15, respectively). CLINICAL RELEVANCE: No significant differences in load to failure or stiffness between ostectomy techniques were observed. Crescentic ostectomy did not improve the acute load to failure for partial mandibulectomy. The empty alveolus served as a focal stress concentration point eliminating the potential mechanical advantage of a crescentic ostectomy.

In Vitro Evaluation of the Aberdeen Knot for Continuous Suture Patterns with Large Gauge Suture.

OBJECTIVE: To evaluate the strength, size, and holding capacity of the Aberdeen knot compared to surgeon's and square knots using large gauge suture. STUDY DESIGN: In vitro mechanical study. STUDY POPULATION: Knotted suture. METHODS: Aberdeen, surgeon's, and square knots were tested using 2 and 3 USP polyglactin 910 and 2 USP polydioxanone under linear tension on a universal testing machine. Mode of failure and knot holding capacity (KHC) were recorded and relative knot security (RKS) was calculated as a percentage of KHC. Knot volume and weight were quantified by a digital micrometer and balance, respectively. Strength between number of throws, suture, suture size, and knot type were compared by ANOVA and post hoc testing. P≤.05 was considered significant. RESULTS: Aberdeen knots had higher KHC and RKS than surgeon's or square knots for all suture types and number of throws (P<.001). For all suture materials, none of the Aberdeen knots unraveled, but a portion of square and surgeon's knots with <7 throws did unravel (P=.101). Aberdeen knots had a smaller volume and weight than both surgeon's and square knots with equal numbers of throws (P<.001). The knot with the combined highest RKS and smallest size and weight was an Aberdeen knot with 4 throws using 3 USP polyglactin 910. CONCLUSION: The Aberdeen knots were stronger, more secure, and smaller than surgeon's and square knots for ending a continuous suture pattern. Clinically, the Aberdeen knot may be a useful alternative for completion of continuous patterns using large gauge suture, without sacrificing knot integrity.