Polysaccharide-based structured lipid carriers for the delivery of curcumin: An in vitro digestion study.

The present work aimed at studying the in vitro digestion fate of κ-carrageenan (KC) or agar (AG) emulsion gels (EG), and KC oil-filled aerogels (OAG) in terms of their structural changes, lipolysis kinetics and curcumin bioaccessibility. On the one hand, both EG and aerogels showed large (70-200 µm) and heterogeneous particles after gastric conditions, indicating the release of bulk oil and gelled material. Nonetheless, this material release in the stomach phase was lower in the case of EG-AG and OAG-KC compared to EG-KC. After small intestinal conditions, EG and oil-filled aerogels presented a wide range of particle sizes probably due to the presence of undigested lipid material, gelled structures, as well as lipid digestion products. For the most part, adding curcumin to the structures' lipid phase did not cause of the structural modifications that occurred at the different in vitro digestion phases. On the other hand, the lipolysis kinetics was different depending on the type of structure. Amongst emulsion-gels, those formulated with κ-carrageenan presented a slower and lower lipolysis kinetics compared to those formulated with agar, which could be attributed to their higher initial hardness. Overall, the addition of curcumin in the lipid phase decreased the lipolysis in all the structures, which evidenced its interference in the lipid digestion process. The curcumin bioaccessibility reached high values (≈ 100 %) for all the studied structures, presenting a high solubility in intestinal fluids. This work unravels the implications of microstructural changes of emulsion-gels and oil-filled aerogels during digestion and their impact on their digestibility and subsequent functionality.

Nanostructural changes in Polysaccharide-Casein Gel-Like structures upon in vitro gastrointestinal digestion.

This work reports on the nanostructural changes taking place during the in vitro gastrointestinal digestion of polysaccharide-casein gel-like structures through the use of small angle X-ray scattering (SAXS). The results indicated that during the gastric phase, the hydrolysis of casein led to a swelling of the micellar structure, yielding peptide clusters. The presence of sulphated polysaccharides such as agar and κ-carrageenan was seen to limit the hydrolysis of casein during the gastric phase, hence decreasing the size of the formed clusters. After the intestinal phase, the produced peptidic fragments appeared to interact with the bile salts present in the digestion medium, yielding a mixture of bile salt lamellae/micelles and vesicular structures. However, in the presence of polysaccharides, which can interact with bile salts, the formation of vesicular structures was limited. Interestingly, the inclusion of casein within hybrid gel-like structures led to the formation of strong polysaccharide-protein interactions, especially in the case of κ-carrageenan. As a result, in some of the formulations, polysaccharide-peptide complexes were released towards the liquid medium, which formed larger vesicular structures. This was related to the greater protective effect of these particular gel-like structures. Furthermore, κ-carrageenan hindered the formation of bile salt lamellae/micelles. These results are of high relevance to understand the intestinal transport mechanism of the digestion products from protein-based ingredients and will allow a rational design of novel products with optimum nutritional and functional properties.

Physicochemical and functional properties of pectin extracted from the edible portions of jackfruit at different stages of maturity.

BACKGROUND: The physicochemical and functional properties of pectin (JFP) extracted from edible portions (including pericarp and seed) of raw jackfruit (an underutilized tropical fruit) at four different maturity stages (referred to as stages I, II, III, and IV) were characterized in terms of extraction yields, chemical composition, molecular weight, and antioxidant properties to evaluate its potential use in foods. RESULT: The JFP yield increased from 9.7% to 21.5% with fruit maturity, accompanied by an increase in the galacturonic acid content (50.1%, 57.1%, 63.6%, and 65.2%) for stages I-IV respectively. The molecular weight increased from 147 kDa in stage I to 169 kDa in stage III, but decreased to 114 kDa in stage IV, probably due to cell-wall degradation during maturation. The JFP was of the high methoxyl type and the degree of esterification increased from 65% to 87% with fruit maturity. The functional properties of JFP were similar to or better than those reported for commercial apple pectin, thus highlighting its potential as a food additive. Although the phenolics and flavonoids content of JFP decreased with fruit maturity, their antioxidant capacity increased, which may be correlated with the increased content of galacturonic acid upon fruit development. Gels prepared from JFP showed viscoelastic behavior. Depending on the maturity stage in which they were obtained, different gelation behavior was seen. CONCLUSION: The study confirmed the potential of pectin extracted from edible parts of jackfruit as a promising source of high-quality gelling pectin with antioxidant properties, for food applications. © 2022 Society of Chemical Industry.

Emulsion gels and oil-filled aerogels as curcumin carriers: Nanostructural characterization of gastrointestinal digestion products.

Agar and κ-carrageenan emulsion gels and oil-filled aerogels were investigated as curcumin carriers and their structure and mechanical properties, as well as their structural changes upon in vitro gastrointestinal digestion were characterized. Agar emulsion gels presented stiffer behaviour, with smaller and more homogeneous oil droplets (ϕ âˆ¼ 12 µm) than those from κ-carrageenan (ϕ âˆ¼ 243 µm). The structure of κ-carrageenan gels was characterized by the presence of rigid swollen linear chains, while agar produced more branched networks. After simulated gastrointestinal digestion bile salt lamellae/micelles (∼5 nm) and larger vesicles of partially digested oil (Rg âˆ¼ 20-50 nm) were the predominant structures, being their proportion dependent of the polysaccharide type and the physical state of the gel network. The presence of curcumin induced the formation of larger vesicles and limited the formation of mixed lamellae/micelles.

Maximizing the oil content in polysaccharide-based emulsion gels for the development of tissue mimicking phantoms.

Formulations based on agar and κ-carrageenan were investigated for the production of emulsion gels applicable as tissue mimicking phantoms. The effects of the polysaccharide matrix, the oil content and the presence of surfactants on the micro-/nanostructure, rheology, and mechanical and dielectric properties were investigated. Results showed a high capacity of the agar to stabilize oil droplets, producing gels with smaller (10-21 µm) and more uniform oil droplets. The addition of surfactants allowed increasing the oil content and reduced the gel strength and stiffness down to 57 % and 34 %, respectively. The permittivity and conductivity of the gels were reduced by increasing the oil content, especially in the agar gels (18.8 and 0.05 S/m, respectively), producing materials with dielectric properties similar to those of low-water content tissues. These results evidence the suitability of these polysaccharides to design a variety of tissue mimicking phantoms with a broad range of mechanical and dielectric properties.