RESUMEN
Recent direct measurements of the growth kinetics of individual carbon nanotubes revealed abrupt changes in the growth rate of nanotubes maintaining the same crystal structure. These stochastic switches call into question the possibility of chirality selection based on growth kinetics. Here, we show that a similar average ratio between fast and slow rates of around 1.7 is observed largely independent of the catalyst and growth conditions. A simple model, supported by computer simulations, shows that these switches are caused by tilts of the growing nanotube edge between two main orientations, close-armchair or close-zigzag, inducing different growth mechanisms. The rate ratio of around 1.7 then simply results from an averaging of the number of growth sites and edge configurations in each orientation. Beyond providing insights on nanotube growth based on classical crystal growth theory, these results point to ways to control the dynamics of nanotube edges, a key requirement for stabilizing growth kinetics and producing arrays of long, structurally selected nanotubes.
RESUMEN
The Ag/Co nanoalloy system is a model system situated energetically at the limit of stability of the core-shell chemical ordering with respect to a simple phase separation behavior. This makes the system highly susceptible to effects of the environment, such as interaction with a substrate. However, kinetic effects may also be exploited by careful atom-by-atom particle growth that allows to lock in certain out-of-equilibrium configurations, such as off-center, quasi-Janus and even Janus type particles. In this contribution, we explore to what extent out-of-equilibrium structures are due to kinetic effects and the influence of the interaction of the particles with an amorphous carbon substrate by a joint experimental and molecular dynamics study. The simulation set up performed at 300 K and 600 K mimicks the experimental growth process. The substrate deforms the particles, but has also an ordering effect on particle orientation and particle structure. In the case of growth of Ag on Co seeds, particles assume close to equilibrium quasi-Janus structures, while for the deposition of Co on Ag seeds, highly out-of-equilibrium structures with several subsurface Co clusters are obtained.
RESUMEN
While alloy, core-shell and Janus binary nanoclusters are found in more and more technological applications, their formation mechanisms are still poorly understood, especially during synthesis methods involving physical approaches. In this work, we employ a very simple model of such complex systems using Lennard-Jones interactions and inert gas quenching. After demonstrating the ability of the model to well reproduce the formation of alloy, core-shell or Janus nanoparticles, we studied their temporal evolution from the gas via droplets to nanocrystalline particles. In particular, we showed that the growth mechanisms exhibit qualitative differences between these three chemical orderings. Then, we determined how the quenching rate can be used to finely tune structural characteristics of the final nanoparticles, including size, shape and crystallinity.
RESUMEN
Nanoparticles formed within an ablation plume produced by the impact of a nanosecond laser pulse on the surface of an aluminum target have been directly measured using small-angle x-ray scattering. The target was immersed in an oxygen-nitrogen gas mixture at atmospheric pressure with the O_{2}/N_{2} ratio being precisely controlled. The results for an increasing oxygen content reveal remarkable effects on the morphology of the generated particles, which include a decrease in the particle volume but a marked increase in its surface ruggedness. Molecular dynamics simulations using a reactive potential and performed under similar conditions as the experiment reproduce the experimental trends and show in detail how the shape and surface structure of the nanoparticles evolve with increasing oxygen content. This good agreement between in situ observations in the plume and atomistic simulations emphasizes the key role of chemical reactivity together with thermodynamic conditions on the morphology of the particles thus produced.
