RESUMEN
Fume hoods are one of the most common types of equipment applied to reduce the potential of particle exposure in laboratory environments. A number of previous studies have shown particle release during work with nanomaterials under fume hoods. Here, we assessed laboratory workers' inhalation exposure during synthesis and handling of CuO, TiO2 and ZnO in a fume hood. In addition, we tested the capacity of a fume hood to prevent particle release to laboratory air during simulated spillage of different powders (silica fume, zirconia TZ-3Y and TiO2). Airborne particle concentrations were measured in near field, far field, and in the breathing zone of the worker. Handling CuO nanoparticles increased the concentration of small particles (< 58 nm) inside the fume hood (up to 1 × 105 cm-3). Synthesis, handling and packaging of ZnO and TiO2 nanoparticles did not result in detectable particle release to the laboratory air. Simulated powder spills showed a systematic increase in the particle concentrations inside the fume hood with increasing amount of material and drop height. Despite powder spills were sometimes observed to eject into the laboratory room, the spill events were rarely associated with notable release of particles from the fume hood. Overall, this study shows that a fume hood generally offers sufficient exposure control during synthesis and handling of nanomaterials. An appropriate fume hood with adequate sash height and face velocity prevents 98.3% of particles release into the surrounding environment. Care should still be made to consider spills and high cleanliness to prevent exposure via resuspension and inadvertent exposure by secondary routes.
RESUMEN
Exposure assessment for nano-objects, and their aggregates and agglomerates (NOAA), has evolved from explorative research toward more comprehensive exposure assessment, providing data to further develop currently used conservative control banding (CB) tools for risk assessment. This study aims to provide an overview of current knowledge on emission potential of NOAA across the occupational life cycle stages by a systematic review and subsequently use the results in a data analysis. Relevant parameters that influence emission were collected from peer-reviewed literature with a focus on the four source domains (SD) in the source-receptor conceptual framework for NOAA. To make the reviewed exposure data comparable, we applied an approach to normalize for workplace circumstances and measurement location, resulting in comparable "surrogate" emission levels. Finally, descriptive statistics were performed. During the synthesis of nanoparticles (SD1), mechanical reduction and gas phase synthesis resulted in the highest emission compared to wet chemistry and chemical vapor condensation. For the handling and transfer of bulk manufactured nanomaterial powders (SD2) the emission could be differentiated for five activity classes: (1) harvesting; (2) dumping; (3); mixing; (4) cleaning of a reactor; and (5) transferring. Additionally, SD2 was subdivided by the handled amount with cleaning further subdivided by energy level. Harvesting and dumping resulted in the highest emissions. Regarding processes with liquids (SD3b), it was possible to distinguish emissions for spraying (propellant gas, (high) pressure and pump), sonication and brushing/rolling. The highest emissions observed in SD3b were for propellant gas spraying and pressure spraying. The highest emissions for the handling of nano-articles (SD4) were found to nano-sized particles (including NOAA) for grinding. This study provides a valuable overview of emission assessments performed in the workplace during the occupational handling of NOAA. Analyses were made per source domain to derive emission levels which can be used for models to quantitatively predict the exposure.
Asunto(s)
Monitoreo del Ambiente/métodos , Nanoestructuras/análisis , Exposición Profesional , Salud Laboral , Lugar de TrabajoRESUMEN
An important step in building a computational model is its documentation; a comprehensive and structured documentation can improve the model applicability and transparency in science/research and for regulatory purposes. This is particularly crucial and challenging for environmental and/or human exposure models that aim to establish quantitative relationships between personal exposure levels and their determinants. Exposure models simulate the transport and fate of a contaminant from the source to the receptor and may involve a large set of entities (e.g. all the media the contaminants may pass though). Such complex models are difficult to be described in a comprehensive, unambiguous and accessible way. Bad communication of assumptions, theory, structure and/or parameterization can lead to lack of confidence by the user and it may be source of errors. The goal of this paper is to propose a standard documentation protocol (SDP) for exposure models, i.e. a generic format and a standard structure by which all exposure models could be documented. For this purpose, a CEN (European Committee for Standardisation) workshop was set up with objective to agree on minimum requirements for the amount and type of information to be provided on exposure models documentation along with guidelines for the structure and presentation of the information. The resulting CEN workshop agreement (CWA) was expected to facilitate a more rigorous formulation of exposure models description and the understanding by users. This paper intends to describe the process followed for defining the SDP, the standardisation approach, as well as the main components of the SDP resulting from a wide consultation of interested stakeholders. The main outcome is a CEN CWA which establishes terms and definitions for exposure models and their elements, specifies minimum requirements for the amount and type of information to be documented, and proposes a structure for communicating the documentation to different users.
Asunto(s)
Documentación/normas , Exposición a Riesgos Ambientales , Monitoreo del Ambiente/métodos , Medición de Riesgo/métodos , Humanos , Modelos TeóricosRESUMEN
The biodiversity in South Africa provides more than 30,000 higher plants, of which more than 3000 are used by traditional healers to treat diseases. Typha capensis (bulrush) is one of the medicinal plants used in South Africa to treat male fertility problems. Considering that South African traditional healers have been recognised by Law and the health benefits of T. capensis have not been scientifically investigated yet, this study aimed at investigating the in vitro effects of aqueous extracts from this plant on male reproductive functions. Both leaves and rhizomes of T. capensis were dried, infused with distilled water and freeze-dried. Motile sperm from 50 men were isolated by swim-up and incubated with 1 µg ml(-1) aqueous extract of Typha rhizome for 1 h at 37 °C. Vitality, motility, sperm production of reactive oxygen species and mitochondrial membrane potential were analysed in the test sample, a control and in the pellet from the swim-up. Results showed that the rhizome extract had significant (P < 0.0001) negative effects on all parameters. The extracts from the leaves and rhizomes revealed dose-dependent inhibitory activity for collagenase and free radical formation. No inhibitory activity for elastase was found. The inhibitory activity for collagenase might indicate possible anti-cancer effects.
Asunto(s)
Inhibidores Enzimáticos/farmacología , Depuradores de Radicales Libres/farmacología , Inhibidores de la Metaloproteinasa de la Matriz , Potenciales de la Membrana/efectos de los fármacos , Mitocondrias/efectos de los fármacos , Extractos Vegetales/farmacología , Motilidad Espermática/efectos de los fármacos , Typhaceae/química , Humanos , Masculino , Proyectos PilotoRESUMEN
PURPOSE: Published case-control studies of risks of leukaemia following low exposures to benzene in the distribution of petroleum (gasoline) have not all identified the same level of risk, but the studies have had differences in cohort inclusion, case determination and availability of occupational and lifestyle data. We reviewed the quality and comparability of the data from three (of four) studies. METHODS: Through site visits, discussions with the investigators and reading study reports, we reviewed and audited the methods used for selecting cases and controls, for estimating individual exposures and for analysing and interpreting the data. Case-control comparisons of exposures were examined using customized graphs. RESULTS: We found that there were no issues of subject selection, methods or general data quality that were likely to have distorted their internal comparisons; we could not check in detail whether the metric for exposure assessments was the same across the studies; the exposure assessments for the Australian study required the least backward estimation, and the Canadian, which also had fewest cases, the most; evidence of an increased risk at higher exposures in Australia was convincing. CONCLUSIONS: The findings are consistent with some effect of benzene at higher lifetime exposures. A proposed pooled analysis should improve quantification of any exposure-response relationship.
Asunto(s)
Benceno/toxicidad , Industria Procesadora y de Extracción , Leucemia/inducido químicamente , Exposición Profesional/análisis , Petróleo , Estudios de Casos y Controles , Humanos , Proyectos de InvestigaciónRESUMEN
OBJECTIVES: The objectives were (i) to identify occupational populations outside hospitals working with antineoplastic drugs, (ii) to determine the size of the populations 'at risk', (iii) to identify major determinants and routes of exposure outside hospitals and (iv) to estimate exposure levels and frequencies relative to levels found in hospitals. METHODS: The survey consisted of two phases; (i) identification of activities with potential exposure to antineoplastic drugs by literature review, interviews, questionnaires and workplace visits, (ii) exploratory measurements of exposure and surface contamination in selected sectors. RESULTS: Eight sectors were identified with potential exposure to antineoplastic drugs: pharmaceutical industry, pharmacies, universities, veterinary medicine, nursing homes, home care, laundry facilities, and waste treatment. Four sectors were of primary concern: veterinary medicine, home care, nursing homes and industrial laundries. The populations potentially exposed in these sectors vary considerably (from several tens to thousands of workers), as do their levels of exposure. Exposure measurements collected in the veterinary medicine sector showed that workers are indeed exposed to antineoplastic drugs and, in some cases (on gloves after administration), levels were 15 times higher than levels measured during administration in hospitals. Workers sorting contaminated hospital laundry in industrial laundry facilities were exposed to antineoplastic drugs through inhalation. For the home care and nursing homes sectors the highest exposure levels were found when cleaning toilets and washing treated patients. These two sectors are expected to have the largest exposed population (5,000-10,000 individuals). CONCLUSIONS: This study has resulted in a comprehensive overview of populations with potential exposure to antineoplastic drugs. Exposure levels can potentially be high compared with the hospital environment, because exposure routes are complex and awareness of the hazard (and therefore use of protective measures) is low. The number of individuals outside hospitals in The Netherlands exposed to antineoplastic drugs is estimated to be between 5,000 and 15,000.
Asunto(s)
Antineoplásicos/administración & dosificación , Exposición Profesional/análisis , Monitoreo del Ambiente/métodos , Servicios de Atención de Salud a Domicilio/estadística & datos numéricos , Humanos , Lavandería/estadística & datos numéricos , Países Bajos , Casas de Salud/estadística & datos numéricos , Exposición Profesional/estadística & datos numéricos , Medicina Veterinaria/estadística & datos numéricosRESUMEN
OBJECTIVE: The main goal was to investigate the potential of a probabilistic approach for exposure assessment and use this information to evaluate the impact of a complex of policy actions/interventions on dermal exposure to antineoplastic agents among oncology nurses. The central theme of this study was to make optimal use of existing data, supplemented only with limited additional information from a questionnaire survey. METHODS: A task based exposure model was used to estimate dermal exposure of the hands among oncology nurses in non-academic hospitals in the Netherlands. Monte Carlo simulation was used to integrate information from available (exposure) studies and generate exposure distributions for the total population of oncology nurses in both pre- and post-intervention situation. Graphs and descriptive statistics of the simulated exposure distributions were used to evaluate trends in population exposure. RESULTS: The inventory showed that important intervention occurred in the preparation and administering of antineoplastic agents and in the handling of urine. Hardly any changes were identified in de nursing tasks. The use of gloves seemed to have decreased for a number of tasks. The results of the analysis show that the interventions did not affect the median exposure. However frequencies of occurrence of individuals with very high and very low total dermal exposures decreased substantially in the post-intervention situation. Analysis of the effect of pregnancy showed that pregnancy is very unlikely to influence exposure or any of the key input variables. CONCLUSIONS: The present study shows that the probabilistic approach adds valuable information to deterministic exposure assessment, especially when extrapolating data on a subpopulation to populations of individuals at large. The results show that the identified changes in the past decade in Dutch non-academic hospitals resulted in changes in the exposure distribution of antineoplastic agents among oncology nurses.
Asunto(s)
Antineoplásicos/toxicidad , Exposición Profesional/efectos adversos , Enfermería Oncológica , Política de Salud , Humanos , Método de Montecarlo , Países Bajos , Probabilidad , PielRESUMEN
BACKGROUND: The authors recently developed a Dermal Exposure Assessment Method (DREAM), an observational semiquantitative method to assess dermal exposures by systematically evaluating exposure determinants using pre-assigned default values. AIM: To explore the accuracy of the DREAM method by comparing its estimates with quantitative dermal exposure measurements in several occupational settings. METHODS: Occupational hygienists observed workers performing a certain task, whose exposure to chemical agents on skin or clothing was measured quantitatively simultaneously, and filled in the DREAM questionnaire. DREAM estimates were compared with measurement data by estimating Spearman correlation coefficients for each task and for individual observations. In addition, mixed linear regression models were used to study the effect of DREAM estimates on the variability in measured exposures between tasks, between workers, and from day to day. RESULTS: For skin exposures, spearman correlation coefficients for individual observations ranged from 0.19 to 0.82. DREAM estimates for exposure levels on hands and forearms showed a fixed effect between and within surveys, explaining mainly between-task variance. In general, exposure levels on clothing layer were only predicted in a meaningful way by detailed DREAM estimates, which comprised detailed information on the concentration of the agent in the formulation to which exposure occurred. CONCLUSIONS: The authors expect that the DREAM method can be successfully applied for semiquantitative dermal exposure assessment in epidemiological and occupational hygiene surveys of groups of workers with considerable contrast in dermal exposure levels (variability between groups >1.0). For surveys with less contrasting exposure levels, quantitative dermal exposure measurements are preferable.
Asunto(s)
Monitoreo del Ambiente/normas , Sustancias Peligrosas/análisis , Exposición Profesional/análisis , Piel/química , Encuestas y Cuestionarios/normas , Vestuario , Monitoreo del Ambiente/métodos , Antebrazo , Humanos , Pierna , Observación , Variaciones Dependientes del Observador , Sensibilidad y Especificidad , TóraxRESUMEN
Workplace dermal exposure assessment is a complex task that aims to understand the dynamic interaction between the skin and the hazardous substances present in the surrounding environment. A European project known as RISKOFDERM gathered dermal exposure data in 85 workplaces (industrial and other types) in five countries in Europe. In order to optimize data collection and to develop a representative picture of dermal exposure, scenarios (tasks made up of a series of activities) were grouped together into dermal exposure operation units (DEOs). The allocation of scenarios to relevant DEOs was achieved on the basis of similarities of exposure routes, tasks and professional judgement. Sampling and quantification procedures were based on the approaches recommended by the OECD protocol. The laboratories involved in the analysis of the samples participated in quality assurance programmes. This exercise resulted in 419 body measurements and 437 measurements on hands expressed in terms of formulation (product) in use. Exposures for a given scenario varied by several orders of magnitude. The extent and patterns of exposure were found to be dependent on various exposure determinants, including inter- and intra-scenario variations. Hands were found to be the most contaminated parts of the body. Exposure patterns for liquid and solid contaminants were different. On the basis of the analysis of the data presented here, the averaged results (median and 95th percentile) for a given DEO unit should not be used as a representative measure of dermal exposure for all scenarios within that DEO without taking the exposure determinants into account. However, the data could be used to develop an exposure matrix (indicative exposure distributions) for different types of scenario and workplace, using determinants of exposure and a Bayesian approach to integrating expert opinion.