Simulating the Entire Clinical Process for an Implant-Supported Fixed Prosthesis: In Vitro Study on the Vertical Implications of Implant-Abutment Connections and Rotational Freedom.

OBJECTIVES: The aim of this in vitro study was to investigate whether and to what extent different scenarios of rotational freedom in different IAC designs affect the vertical dimension of a three-part fixed partial denture (FPD). At the same time, the experimental setup should simulate all clinical and laboratory steps of the implementation of such an FPD as accurately as possible. MATERIAL AND METHODS: Twenty identical pairs of jaw models were fabricated from aluminum, each lower-jaw model holding two implants with conical or flat IACs. Three impressions of each model were taken to fabricate stone casts and three-unit FPDs. Three assembly scenarios were compared for the vertical position stability they offered for these FPDs, differing by how the sequential implant components (impression posts > laboratory analogs > abutments 1 > abutments 2) were aligned with the positional index of the IAC. In this way, a total of 60 stone casts and FPDs were fabricated and statistically analyzed for changes in vertical dimension (p < 0.05). RESULTS: Regardless of whether a conical/flat IAC was used (p > 0.05), significantly greater mean changes in vertical dimension were consistently (all comparisons p < 0.0001) found in a "worst-case scenario" of component alignment alternating between the left- and right-limit stop of the positional index (0.286/0.350 mm) than in a "random scenario" of 10 dentists and 10 technicians with varying levels of experience freely selecting the alignment (0.003/0.014 mm) or in a "best-case scenario" of all components being aligned with the right-limit stop (-0.019/0.005 mm). CONCLUSIONS: The likelihood of integrating a superstructure correctly in terms of vertical dimension appears to vary considerably more with assembly strategies than with IAC designs. Specifically, our findings warrant a recommendation that all implant components should be aligned with the right-limit stop of the positioning index.

Forced surgical extrusion using an axial tooth extraction system as a practicable technique for preserving severely destroyed teeth? - Clinical outcomes up to 4.8 years.

OBJECTIVE: Several extrusion techniques have been described to restore teeth with insufficient coronal tooth structure and to avoid their extraction. Still, there is little evidence for a treatment concept combining surgical extrusion using an atraumatic axial extraction system. MATERIALS AND METHODS: A total of nine patients, each with an iso- or subgingival fractured tooth, were retrospectively examined. Treatment of the damaged tooth comprised an atraumatic forced surgical extrusion performed with an axial tooth extraction system and a more coronal positioning within the socket. The teeth were initially splinted and subsequently restored. The follow-up period was up to 57.1 months and averaged 36.5 (SD: ±13.5) months. RESULTS: All nine teeth were still in situ, without signs of inflammation. During the period of the provisional restoration, six prosthetic complications occurred, which were resolved with little effort, whereas, success rate for the definitive restoration was 100%. No biological complications were observed concerning the root apex or soft tissue. The radiographically measured mean extrusion distance was 3.4 (SD: ±1.0) mm, so that a sufficient prosthetic ferrule could be reestablished. CONCLUSIONS: Surgical extrusions using an axial tooth extraction system demonstrate low biological and prosthetic complications rates over observation time. CLINICAL SIGNIFICANCE: The presented extrusion approach preserves soft and hard tissue and is an efficient treatment option for severely destroyed teeth. Saving hopeless teeth by this relatively predictable and feasible procedure has hardly any disadvantages for patients, and in case of failure, an implant or fixed partial denture are still an option.