Selection for Phytophthora Root Rot Resistance in Chickpea Crosses Affects Yield Potential of Chickpea × Cicer echinospermum Backcross Derivatives.

Phytophthora root rot (PRR) of chickpea (Cicer arietinum) caused by Phytophthora medicaginis is an important disease. Partial resistance to PRR is sourced from Cicer echinospermum. In this study, we evaluated if lines with low levels of PRR foliage symptoms in two contrasting recombinant inbred line (RIL) populations parented by chickpea cultivars (Yorker and Rupali) and 04067-81-2-1-1 (C. echinospermum, interspecific breeding line) had a significant drag on yield parameters. For the Yorker × 04067-81-2-1-1 population with the highest level of PRR resistance, in the absence of PRR, low foliage symptom RIL had significantly later flowering and podding, lower grain yields, and lighter seed and shorter plant phenotypes than high foliage symptom RIL. A quantitative trait locus analysis identified significant QTL for flowering, height, 100-seed weight, and yield, and there was a significantly higher frequency of alleles for the negative agronomic traits (i.e., drag) from the 04067-81-2-1-1 parent in low foliage symptom RIL than in high foliage symptom RIL. For the Rupali × 04067-81-2-1-1 population with lower levels of PRR resistance, in the absence of PRR, low foliage symptom RIL had significantly lighter seed and shorter plants than high foliage symptom RIL. Significant QTL were detected, the majority were for the timing of flowering and podding (n = 18), others were for plant height, yield, and 100-seed weight. For this second population, the frequency of alleles for the negative agronomic traits from the 04067-81-2-1-1 parent did not differ between low and high foliage symptom RIL. The 100 seed weight of RIL under moderate PRR disease pressure showed some promise as a yield component trait to identify phenotypes with both high levels of PRR resistance and grain yield potential for further seed number evaluations. We identified that large population sizes are required to enable selection among chickpea × C. echinospermum crosses for high levels of PRR resistance without a significant drag on yield.

Inoculum production of Phytophthora medicaginis can be used to screen for partial resistance in chickpea genotypes.

Phytophthora root rot caused by Phytophthora medicaginis is an important disease of chickpeas (Cicer arietinum) in Australia with limited management options, increasing reliance on breeding for improved levels of genetic resistance. Resistance based on chickpea-Cicer echinospermum crosses is partial with a quantitative genetic basis provided by C. echinospermum and some disease tolerance traits originating from C. arietinum germplasm. Partial resistance is hypothesised to reduce pathogen proliferation, while tolerant germplasm may contribute some fitness traits, such as an ability to maintain yield despite pathogen proliferation. To test these hypotheses, we used P. medicaginis DNA concentrations in the soil as a parameter for pathogen proliferation and disease assessments on lines of two recombinant inbred populations of chickpea-C. echinospermum crosses to compare the reactions of selected recombinant inbred lines and parents. Our results showed reduced inoculum production in a C. echinospermum backcross parent relative to the C. arietinum variety Yorker. Recombinant inbred lines with consistently low levels of foliage symptoms had significantly lower levels of soil inoculum compared to lines with high levels of visible foliage symptoms. In a separate experiment, a set of superior recombinant inbred lines with consistently low levels of foliage symptoms was tested for soil inoculum reactions relative to control normalised yield loss. The in-crop P. medicaginis soil inoculum concentrations across genotypes were significantly and positively related to yield loss, indicating a partial resistance-tolerance spectrum. Disease incidence and the rankings for in-crop soil inoculum were correlated strongly to yield loss. These results indicate that soil inoculum reactions may be useful to identify genotypes with high levels of partial resistance.

Genetic variation for fusarium crown rot tolerance in durum wheat.

Tolerance to the cereal disease Fusarium crown rot (FCR) was investigated in a set of 34 durum wheat genotypes, with Suntop, (bread wheat) and EGA Bellaroi (durum) as tolerant and intolerant controls, in a series of replicated field trials over four years with inoculated (FCR-i) and non-inoculated (FCR-n) plots of the genotypes. The genotypes included conventional durum lines and lines derived from crossing durum with 2-49, a bread wheat genotype with the highest level of partial resistance to FCR. A split plot trial design was chosen to optimize the efficiency for the prediction of FCR tolerance for each genotype. A multi-environment trial (MET) analysis was undertaken which indicated that there was good repeatability of FCR tolerance across years. Based on an FCR tolerance index, Suntop was the most tolerant genotype and EGA Bellaroi was very intolerant, but some durum wheats had FCR tolerance indices which were comparable to Suntop. These included some conventional durum genotypes, V101030, TD1702, V11TD013*3X-63 and DBA Bindaroi, as well as genotypes from crosses with 2-49 (V114916 and V114942). The correlation between FCR tolerance and FCR-n yield predictions was moderately negative indicating it could be somewhat difficult to develop FCR-tolerant genotypes that are high yielding under low disease pressure. However, FCR tolerance showed a positive correlation with FCR-i yield predictions in seasons of high disease expression indicating it could be possible to screen for FCR tolerance using only FCR-i treatments. These results are the first demonstration of genetic diversity in durum germplasm for FCR tolerance and they provide a basis for breeding for this trait.