Antimicrobial Activity of Positively Charged Oligopeptides with Theoretical High α-Helix Content against Cutibacterium acnes.

Cutibacterium acnes is abundant and commonly exists as a superficial bacteria on human skin. Recently, the resistance of C. acnes to antimicrobial agents has become a serious concern, necessitating the development of alternative pharmaceutical products with antimicrobial activity against C. acnes. To address this need, we evaluated the antimicrobial activity of CKR-13-a mutant oligopeptide of FK-13 with increased net charge and theoretical α-helical content-against C. acnes in modified Gifu Anaerobic Medium broth by determining the minimum inhibitory concentration (MIC). CKR-13 exerted greater antimicrobial activity against C. acnes than FK-13 in the broth at pH 7.0. The antimicrobial activity of CKR-13 with RXM against C. albicans was pH-dependent. The ionization of CKR-13 and pH-dependent growth delay of C. albicans was suggested to be associated with the increase in CKR-13 antimicrobial activity.

Synthesis and Photophysical Characterization of Fluorescent Naphtho[2,3-d]thiazole-4,9-Diones and Their Antimicrobial Activity against Staphylococcus Strains.

The chemical reaction of 2-(methylsulfinyl)naphtho[2,3-d]thiazole-4,9-dione (3) using different amines, including benzylamine (4a), morpholine (4b), thiomorpholine (4c), piperidine (4d), and 4-methylpiperazine (4e), produced corresponding new tricyclic naphtho[2,3-d]thiazole-4,9-dione compounds (5a-e) in moderate-to-good yields. The photophysical properties and antimicrobial activities of these compounds (5a-e) were then characterized. Owing to the extended π-conjugated system of naphtho[2,3-d]thiazole-4,9-dione skeleton and substituent effect, 5a-e showed fluorescence both in solution and in the solid state. The introduction of nitrogen-containing heterocycles at position 2 of the thiazole ring on naphtho[2,3-d]thiazole-4,9-dione led to large bathochromic shifts in solution, and 5b-e exhibited orange-red fluorescence with emission maxima of over 600 nm in highly polar solvents. Staphylococcus aureus (S. aureus) is a highly pathogenic bacterium, and infection with its antimicrobial-resistant pathogen methicillin-resistant S. aureus (MRSA) results in serious clinical problems. In this study, we also investigated the antimicrobial activities of 5a-e against S. aureus, MRSA, and S. epidermidis. Compounds 5c with thiomorpholine group and 5e with 4-methylpiperazine group showed potent antimicrobial activity against these bacteria. These results will lead to the development of new fluorescent dyes with antimicrobial activity in the future.

Antimicrobial Activity of 2-(Piperazin-1-yl)naphtho[2,3-d]thiazole-4,9-dione against Staphylococcus Strains.

There is an urgent need to discover and develop novel antibacterial agents. Accordingly, we synthesised 2-(piperazin-1-yl)naphtho[2,3-d]thiazole-4,9-dione (PNT), which exhibits antimicrobial activity. The aim of this study was to characterise PNT as an effective antimicrobial agent. Fluorescence microscopy was used to measure PNT's uptake into microbial cells (strains of Staphylococcus epidermidis, Staphylococcus aureus, and methicillin-resistant S. aureus (MRSA)), transmission electron microscopy (TEM) was used to investigate the influence of PNT on the configuration of microbial cells, and a DNA gyrase supercoiling assay was used to investigate whether PNT inhibits DNA gyrase. PNT was taken up by more than 50% of microbial cells within 30 min. Using TEM, hollowed-out bacterial cytoplasms were observed in the specimen treated with PNT, although there was no disintegration of the bacterial membrane. In the DNA gyrase supercoiling assay, a dose-dependent reduction in fluorescence intensity was observed as the concentration of PNT increased. This suggests that PNT is taken up by microbial cells, resulting in cell disruption, and it reveals that one of the mechanisms underlying the antimicrobial activity of PNT is the inhibition of DNA gyrase.

Quality improvement of gluten-free rice flour bread through the addition of high-temperature water during processing.

Recently, there has been an increase in the demand for gluten-free bread due to health reasons. One of the flours used to produce gluten-free bread is rice flour; flour characteristics are very important for breadmaking. Although a study has shown that the addition of high-temperature water can improve the quality of rice flour bread, studies are yet to consider different rice properties. Therefore, the aim of this study was to investigate the effect of adding high-temperature water and rice flour characteristics on the quality of rice flour bread using six commercially available rice flours. The rice flours used in the sample had amylose content from 12.1% to 24.5%, damaged starch content from 2.4% to 5.5%, mode diameter from 16.3 to 63.3 µm, protein content from 5.4% to 6.1%, and moisture content in the range of 12.0%-15.0%. The results showed that regardless of the rice characteristics, breads prepared at the optimum watering temperature were puffier and softer than those prepared using cold water (5°C). For rice flours with similar particle size, the optimal water temperature and degree of gelatinization for breadmaking increased with rice flours with lower amylose content. Furthermore, the rheological properties of dough prepared at the optimum water addition temperature were stable, with loss modulus (G″) being dominant over the entire frequency range in the frequency sweep test. Since the water temperature added to the dough affects breadmaking properties more than the characteristics of the rice flour, adjusting the water temperature may enable the production of high-quality bread even with rice flour unsuitable for making. PRACTICAL APPLICATION: Presently, the addition of high-temperature water to rice flour has been shown to improve the bread quality. In this study, we investigated the effects of high-temperature water addition on the quality of rice flour bread using rice flour varieties with different flour characteristics. Even in rice flour with small particle size and low amylose content, which is not suitable for breadmaking, bread quality can be improved by adding hot water at around 70°C. This is a simple and practical method to improve the quality of gluten-free rice flour bread without adding thickeners.

Effect of the addition of high-temperature water on the properties of batter and bread made from gluten-free rice flour.

Increasing number of individuals worldwide are consuming gluten-free products, for example, bread, for health and other reasons. However, gluten-free products are currently expensive and/or their preparation involves the use of specialist machinery or food additives. In this study, we focused on the thickening effect of starch gelatinization and attempted to develop a novel method for gluten-free rice flour bread production without the use of additives. We aimed to determine the effect of adding high-temperature water to gluten-free rice flour on the properties of the resulting batter, primarily gelatinization. The water was tested at temperatures between 50 and 80°C, in 2°C increments. For comparison, control bread from gluten-free rice flour was made using cold (5°C) water. The addition of water at a temperature between 66 and 70°C significantly improved the specific volume and firmness of bread (p < 0.05, Dunnett's test; compared with control). Additionally, maintaining the gelatinization temperature of the bread batter for approximately 1-10 s and the degree of gelatinization of batter, approximately 5%-10%, were crucial for obtaining good-quality bread. Further, the addition of water at a temperature above 78°C adversely affected the bread-making properties. This simple method developed for making high-quality bread from gluten-free rice flour will make gluten-free bread products more widely available to and acceptable by the consumers. PRACTICAL APPLICATION: Currently, making high-quality bread from gluten-free rice flour involves the use of food additives or special rice flour. Here, we present a simple method for producing high-quality bread by manipulating the temperature of water added during the preparation of rice flour batter. We optimized the method by analyzing the gelatinization properties of the batter and determined the optimal water temperature suitable for bread making. This method yields high-quality gluten-free bread and is cost-effective and simple to implement.

Targeted Delivery of Miconazole Employing LL37 Fragment Mutant Peptide CKR12-Poly (Lactic-Co-Glycolic) Acid Polymeric Micelles.

We previously reported that conjugates of antimicrobial peptide fragment analogues and poly (lactic-co-glycolic) acid (PLGA) enhance antimicrobial activity and that the conjugated micelle structure is an effective tool for antimicrobial drug delivery. In recent years, the delivery of antimicrobial peptides to targets for antimicrobial activity has attracted attention. In this study, we targeted Candida albicans, a causative organism of catheter-related bloodstream infections, which is refractory to antimicrobial agents and is currently a problem in medical practice. We evaluated the antifungal activity of CKR12 (a mutant fragment of the human cathelicidin peptide, LL-37)-PLGA-miconazole (MCZ) micelles using nanotechnology with MCZ delivery. The prepared CKR12-PLGA-MCZ micelles were characterised by measuring dynamic light scattering, zeta potential, dilution stability, and drug release. CKR12-PLGA-MCZ micelles showed higher antifungal activity than CKR12-PLGA micelles and MCZ solution. Furthermore, scanning and transmission electron microscopy suggested that CKR12-PLGA-MCZ micelles disrupted both cell wall and cell membrane of C. albicans. Our results revealed a synergistic effect of antifungal activity using a combination of antimicrobial peptide fragment analogues and MCZ, and that MCZ is a promising tool for the delivery to target microorganisms.

Antimicrobial Activities of LL-37 Fragment Mutant-Poly (Lactic-Co-Glycolic) Acid Conjugate against Staphylococcus aureus, Escherichia coli, and Candida albicans.

Various peptides and their derivatives have been reported to exhibit antimicrobial activities. Although these activities have been examined against microorganisms, novel methods have recently emerged for conjugation of the biomaterials to improve their activities. Here, we prepared CKR12-PLGA, in which CKR12 (a mutated fragment of human cathelicidin peptide, LL-37) was conjugated with poly (lactic-co-glycolic) acid (PLGA), and compared the antimicrobial and antifungal activities of the conjugated peptide with those of FK13 (a small fragment of LL-37) and CKR12 alone. The prepared CKR12-PLGA was characterized by dynamic light scattering and measurement of the zeta potential, critical micellar concentration, and antimicrobial activities of the fragments and conjugate. Although CKR12 showed higher antibacterial activities than FK13 against Staphylococcus aureus and Escherichia coli, the antifungal activity of CKR12 was lower than that of FK13. CKR12-PLGA showed higher antibacterial activities against S. aureus and E. coli and higher antifungal activity against Candida albicans compared to those of FK13. Additionally, CKR12-PLGA showed no hemolytic activity in erythrocytes, and scanning and transmission electron microscopy suggested that CKR12-PLGA killed and disrupted the surface structure of microbial cells. Conjugation of antimicrobial peptide fragment analogues was a successful approach for obtaining increased microbial activity with minimized cytotoxicity.

Enzyme-free quinone crosslinking reaction for proteins: a macromolecular characterization study using gelatin.

To mimic the quinone hardening of extracellular proteins in invertebrates, we investigated an enzyme-free crosslinking of gelatin by HQ in a neutral aqueous phase. The mixture was rapidly transformed to a yellowish brown, thermally and mechanically stable hydrogel in the presence of a simple copper(II) salt. A dehydrated thin film made of the mixture was flexible, tough, and showed a large ultimate breaking force. Physicochemical examination of the gel suggested that the basic amino acid residues (lysine, hydroxylysine, and histidine) of the protein were modified by the quinone ring to form 2-6 crosslinks per protein. The enzyme-free crosslinking reaction is discussed with consideration of a copper(II) ion-catalyzed oxidation of HQ and the hydroquinone/protein adducts.

Formation of metal nanoparticles on the surface of polymer particles incorporating polysilane by UV irradiation.

Polystyrene particles incorporating poly(methylphenylsilane) (PMPS) were synthesized by miniemulsion polymerization. UV irradiation of the emulsion under air in the presence of metal salts such as HAuCl4.4H2O, AgNO3, and Na2PdCl4 led to the formation of metal nanoparticles on the surface of polymer particles; thus, metal nanoparticle/polymer hybrid particles were obtained. The structures of the hybrid particles were confirmed by the surface plasmon resonance band and transmission electron microscopy images. The formation of metal nanoparticles depended on the functional groups and charge on the surface of the polymer particle. The metal nanoparticles were formed due to the reduction of metal ions, accompanied by the oxidation of PMPS. The interaction between the surface of the polymer particle and the metal ions plays an important role in the formation of the metal nanoparticle.

Synergistic fungicidal activities of amphotericin B and N-methyl-N"-dodecylguanidine: a constituent of polyol macrolide antibiotic niphimycin.

The synergy between the alkylguanidinium chain of niphimycin (NM), a polyol macrolide antibiotic, and polyene macrolide amphotericin B (AmB) without such an alkyl side chain was examined using N-methyl-N"-alkylguanidines as its synthetic analogs. Among the analogs, N-methyl-N"-dodecylguanidine (MC12) most strongly inhibited the growth of Saccharomyces cerevisiae cells and those of other fungal strains in synergy with AmB. MC12 itself was not lethal but the analog could be a cause of a rapid cell death progression of yeast cells in the presence of AmB at a nonlethal concentration. Their combined actions resulted in the generation of NM-like fungicidal activity that depended on plasma membrane disability and cellular reactive oxygen species production. We also found an aberrant vacuolar morphogenesis and an associated vacuolar membrane disability in cells treated simultaneously with MC12 and AmB, as in the case of NM-treated cells. These findings support the idea that the alkylguanidinium chain plays a major role in the fungicidal activity of NM in cooperation with the polyol lactone ring as its enhancer.