Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 5 de 5
Filtrar
Más filtros










Base de datos
Intervalo de año de publicación
1.
J Dairy Sci ; 104(12): 12600-12615, 2021 Dec.
Artículo en Inglés | MEDLINE | ID: mdl-34419272

RESUMEN

The objective of this study was to investigate the effects of partial substitution of corn silage (CS) with sweet sorghum silage (SS) in the diets of lactating dairy cows on dry matter (DM) intake, milk yield and composition, blood biochemistry, and ruminal fermentation and microbial community. Thirty mid-lactation Holstein dairy cows [mean ± standard deviation; 639 ± 42.0 kg of body weight; 112 ± 24.0 d in milk (DIM)] were assigned to 3 groups (n = 10/treatment) by considering parity, milk yield, and DIM. The cows were fed ad libitum total mixed rations containing 55% forage and 45% concentrate, with only the proportion of CS and SS varying in 3 treatments (DM basis): SS0 (0% substitution of CS), 40% CS and 0% SS; SS25 (25% substitution of CS), 30% CS and 10% SS; and SS50 (50% substitution of CS), 20% CS and 20% SS. Dry matter intake and milk protein concentration tended to linearly decrease with increasing proportion of SS in the diet. Yields of milk (mean ± standard deviation, 30.9 ± 1.12 kg/d), 4% fat-corrected milk (30.0 ± 0.81 kg/d), energy-corrected milk, milk protein, lactose, and total solids, concentrations of milk fat, lactose, somatic cell counts, and milk efficiency did not differ among diets. The concentrations in blood of urea nitrogen, phosphorus, aspartate aminotransferase, and malondialdehyde linearly increased with increasing SS proportion. Blood IgA decreased with increasing SS substitution rate, but blood IgG and IgM were not different among diets. Ruminal pH did not differ among diets, whereas ruminal NH3-N concentration quadratically changed such that it was greater for SS50 than for SS0 and SS25. Molar proportions of propionate and acetate to propionate ratio were less for SS25 than for SS0. Although the diversity and general ruminal microbial community structure were not altered by partially replacing CS with SS, the relative abundances of predominant bacteria were affected by diets at the phylum and genus levels. Firmicutes and Bacteroidetes were dominant phyla in the ruminal bacterial community for all diets, and their relative abundance linearly decreased and increased, respectively, with increasing SS substitution rate. Prevotella_1 and Ruminococcaceae_NK4A214_group were detected as the most and the second most abundant genera, with their relative abundance linearly increased and decreased, respectively, with increasing SS substitution rate. The relative abundance of Fibrobacter linearly increased with increasing dietary SS proportion, with greater abundance observed for SS25 and SS50 than for SS0. These results suggest that substitution of CS with SS altered the relative abundances of some predominant bacteria; however, these changes had little effect on ruminal fermentation and milk yield. Under the current experimental conditions, substituting up to 50% of CS with SS had no negative effects on milk yield, indicating that SS can partially replace CS in the diets of high-producing lactating dairy cows without adding extra grain, when diets are fed for a short time. As the effects of substituting CS with SS depend upon the chemical composition and digestibility of these silages and the nutrient requirements of the cows, additional grain may be required in some cases to compensate for the lower starch content of SS.


Asunto(s)
Alimentación Animal , Microbiota , Ensilaje , Sorghum , Zea mays , Animales , Bovinos , Industria Lechera , Dieta/veterinaria , Digestión , Ingestión de Alimentos , Femenino , Fermentación , Lactancia , Rumen/metabolismo , Ensilaje/análisis
2.
Rev Sci Instrum ; 92(4): 043542, 2021 Apr 01.
Artículo en Inglés | MEDLINE | ID: mdl-34243412

RESUMEN

Stray laser light is a serious problem that interrupts the measurement of electron temperature and density in Thomson scattering (TS) systems. This paper presents a ray-tracing simulation of stray laser light in HL-2M TS systems. A model including (i) a simplified laser-beam injection system, (ii) the scattered-light collection systems for central-point TS (CPTS) and edge TS (ETS), and (iii) the HL-2M vessel is built using the TracePro and CATIA software packages based on measurements of the bidirectional scattering distribution function at a wavelength of 532 nm. The simulation results show that no stray laser light reaches the injection surface of the collection lens of the CPTS system, and only a few stray laser rays of all the rays reaching the injection surface of the collection lens of the ETS system can be collected when the energy threshold per ray is 1 × 10-16. The stray laser rays that reach the scattered-light collection systems are mainly from the first and second parts of the slides of the beam dump, so decreasing the roughness of those parts could be effective in reducing the level of stray laser light.

3.
Rev Sci Instrum ; 89(10): 10C116, 2018 Oct.
Artículo en Inglés | MEDLINE | ID: mdl-30399663

RESUMEN

Some progress has been made to develop the multipoint Thomson scattering (TS) diagnostic for the HL-2A tokamak physics experiments. Hardware of silicon avalanche photodiode detector electronics is improved, which provides two output signal channels. In one channel, only the rapid TS signal is the output after deducting the influence of the background slow-varying plasma light. In the other, both the rapid TS signal and the plasma background signal are the output. In the latest HL-2A experiment campaign, the newly developed electronics are tested and TS signals can be obtained from each of the two channels, where the signal is digitized by 12-bit transient recorder sampled at 1 GS/s. Laser beam alignment is fulfilled by using motorized stages to control the laser beam passing through ∼10 mm-wide narrow throats of the lower and upper closed divertors with small movements and then the stray laser light is reduced. New modules of fast digitizers with more than 100 channels are installed and will be used to record TS pulse signals. On the basis of these achievements, about 15-point measurements of plasma electron temperature and density by Thomson scattering diagnostic will come into operation in the upcoming HL-2A experiment campaign.

4.
Sci Rep ; 7(1): 515, 2017 03 31.
Artículo en Inglés | MEDLINE | ID: mdl-28364119

RESUMEN

We report experimental observation of large anomalous Hall effect exhibited in non-collinear triangular antiferromagnet D019-type Mn3Ga with coplanar spin structure at temperatures higher than 100 K. The value of anomalous Hall resistivity increases with increasing temperature, which reaches 1.25 µΩ · cm at a low field of ~300 Oe at room temperature. The corresponding room-temperature anomalous Hall conductivity is about 17 (Ω · cm)-1. Most interestingly, as temperature falls below 100 K, a temperature-independent topological-like Hall effect was observed. The maximum peak value of topological Hall resistivity is about 0.255 µΩ · cm. The appearance of the topological Hall effect is attributed to the change of spin texture as a result of weak structural distortion from hexagonal to orthorhombic symmetry in Mn3Ga. Present study suggests that Mn3Ga shows promising possibility to be antiferromagnetic spintronics or topological Hall effect-based data storage devices.

5.
Rev Sci Instrum ; 87(11): 11E555, 2016 Nov.
Artículo en Inglés | MEDLINE | ID: mdl-27910507

RESUMEN

The edge tangential Thomson scattering system (ETTSS) was developed for the first time on a HL-2A tokamak. A Nd:YAG laser with a 1064 nm wavelength, 4 J energy, and 30 Hz repetition rate is employed on the ETTSS. The laser beam injects the plasma in the tangential direction on the mid-plane of the machine, and the angles between the laser injection direction and the scattered light collection direction are in the range from 157.5° to 162.8°. The scattered light collection optics with 0.21-0.47 magnification is utilized to collect the scattered light of measurement range from R = 1900 mm to 2100 mm (the normalized radius is from r/a = 0.625 to 1.125). Spatial resolution of the preliminary design could be up to Δr/a = 0.016. The measurement requirements could be achieved: 10 eV < Te < 1.5 keV, and 0.5 × 1019 m-3 < ne < 3 × 1019 m-3 with errors less than 15% and 10%, respectively.

SELECCIÓN DE REFERENCIAS
DETALLE DE LA BÚSQUEDA
...