RESUMEN
Microencapsulation of paraffin with lead tungstate shell (Pn@PWO) shows the drawbacks of low wettability and poor leakage-proof property and thermal reliability, restricting the application of phase change microcapsules. Herein, a novel paraffin@lead tungstate@silicon dioxide double-shelled microcapsule (Pn@PWO@SiO2) has been successfully constructed by the emulsion-templated interfacial polycondensation and applied in the waterborne polyurethane (WPU). The results indicated that a SiO2 layer with controlled thickness was formed on the PbWO4 shell. The Pn@PWO@SiO2 microcapsules have exhibited superior leakage-proof properties and thermal reliability through double-shelled protection, and the leakage rate decreased by at least 54.11% compared to that of Pn@PWO microcapsules. The SiO2 layer with abundant polar groups ameliorated the wettability of microcapsules and the interfacial compatibility between microcapsules and the WPU matrix. The tensile strength of WPU/Pn@PWO@SiO2-2 composites reached 10.98 MPa, which was over 7 times greater than that of WPU/Pn@PWO composites. In addition, WPU/Pn@PWO@SiO2-2 composites with a latent heat capacity of over 41 J/g exhibited efficient phase change stability and γ-ray shielding properties. Also, the mass attenuation coefficients reached 1.38 cm2/g at 105.3 keV and 1.12 cm2/g at 86.5 keV, respectively. These properties will greatly promote the application of WPU/Pn@PWO@SiO2 composites into γ-ray-shielding devices with thermal regulation.
RESUMEN
A series of microencapsulated phase-change materials (MEPCMs) based on paraffin core and calcium carbonate (CaCO3) shell were synthesized, and the effect of emulsifier type and pH value on morphology, structure, and properties of paraffin@CaCO3 MEPCMs were investigated. The results showed that CaCO3 shell was formed in vaterite and calcite crystalline phase when emulsifier was sodium dodecyl benzene sulfonate and styrene-maleic anhydride (SMA), respectively. When sodium dodecyl sulfate was used as an emulsifier, both vaterite and calcite CaCO3 were formed. The forming mechanism of emulsifier type on CaCO3 crystalline phase was studied. Furthermore, phase-change enthalpy and leakage rate of MEPCMs were related with the type of emulsifier and the pH value of the emulsion. With optimum condition of SMA as emulsifier and pH value of 7, paraffin@CaCO3 MEPCMs had an encapsulation ratio at 56.6% and leakage rate at 2.88%, illustrating its considerable heat storage capability and leakage-prevention property. The 50 heating-cooling cycles test indicated that the MEPCMs owned excellent thermal reliability. The thermal conductivity of MEPCMs was significantly improved due to the existence of CaCO3 shell. In addition to excellent thermal storage ability, the paraffin@CaCO3 MEPCMs also owned good mechanical property and light-to-heat energy conversion efficiency. The characteristics of MEPCMs indicated its potential application in solar energy resource.