RESUMEN
Automobile exhaust releases different types of pollutants that are at great risk to the air quality of the environment and incidental distress to the nature of roadside plants. Mimusops elengi L. is an evergreen medicinal tree cultivated along the roadside of Lahore City. This research aimed to investigate physiological, morphological and genomorphic characteristics of M. elengi under the influence of air pollution from vehicles. Healthy and mature leaves were collected from trees on Canal Bank and Mall roads of Lahore as the experimental sites and control sites were 20 km away from the experimental site. Different physiochemical, morphological, air pollution tolerance index (APTI) and molecular analysis for the detection of DNA damage were performed through comet assay. The results demonstrated the mean accumulated Cd, Pb, Cu and Ni heavy metal contents on the leaves were higher than the control plants (1.27, 3.22, 1.32 and 1.46 µg mg-1). APTI of trees was 9.04. Trees in these roads significantly (p < 0.01) had a lower leaf area, petiole length and leaf dry matter content in comparison to control site. Increased comet tail showed that DNA damage was higher for roadside trees than trees in the control area. For tolerance of air pollution, it necessary to check the APTI value for the M. elengi at the polluted road side of Lahore city. For long-term screening, the source and type of pollutants and consistent monitoring of various responses given by the trees should be known.
RESUMEN
With the growth of the manufacturing industry, the demand for alloy materials with high hardness, toughness, and impact strength has increased. Since products from such alloy materials are extremely difficult to manufacture with high accuracy and reduced surface roughness using traditional machining techniques, wire electric discharge machining can be used to machine such complex parts with more precision. In this case-study-based research, machining factors such as current, pulse-on time, and voltage are studied to determine their effects on the material removal rate for AISI 1045 medium carbon steel. The Taguchi L9 orthogonal array is used in the design of experiments for optimization. Statistical techniques such as analysis of variance and signal-to-noise ratio are used to identify the control parameters that matter most in bringing about optimal results. Based on the results, the current is the most crucial control variable in this investigation. Moreover, the maximum material removal rate obtained was 0.7112 mm3/min with the obtained optimized values of current (I) = 16 A, voltage (V) = 50 V, and pulse-on time (Ton) = 100 µs.