Effect of Bonding Agents on the Shear Bond Strength of Tooth-colored Restorative Materials to Dentin: An In Vitro Study.

AIM: The aim of the study is to determine the difference in the shear bond strengths to dentin among dental composite (Filtek Z350®, 3M), compomer (Dyract Flow®, Dentsply) and Giomer (Beautifil®, Shofu) with 3MTM Single BondTM Universal Adhesive (SBU) (7th generation, self-etch, single solution adhesive) and AdperTM Single Bond 2 Adhesive (ASB) (5th generation, total-etch, two solution adhesive). MATERIALS AND METHODS: Sixty extracted human permanent teeth were collected, cleansed of debris, and placed in distilled water. The samples were segregated into two groups depicting the two bonding agents-AdperTM (ASB) and 3MTM Single Bond Universal (SBU) and sub-grouped into three groups depicting the three restorative materials (Composite, Giomer, and Compomer) used. Groups were respresented as follows: Group I-ASB + Composite; Group II-ASB + Giomer; Group III-ASB + Compomer; Group IV-SBU + Giomer; Group V-SBU + Compomer; Group VI-SBU + Composite. After applying the bonding agent as per the manufacturer's instructions, following which the restorative material was placed. A Universal Testing Machine (Instron 3366, UK) was employed to estimate the shear bond strength of the individual restorative material and shear bond strengths were calculated. RESULTS: Composite bonded with SBU (group VI) displayed the greatest shear strength (11.16 ± 4.22 MPa). Moreover, Giomers and flowable compomers displayed better bond strengths with ASB compared with their SBU-bonded counterparts. CONCLUSION: These results mark the importance of careful material selection in clinical practice and the bonding agent used to achieve optimal bond strength and enhance the clinical longevity and durability of dental restorations. CLINICAL SIGNIFICANCE: From a clinical perspective, to avoid a compressive or a shear failure, it would be preferrable to use a direct composite restorative material with SBU (Single bond universal adhesive, 7th generation) to achieve maximum bond strength. How to cite this article: Kuchibhotla N, Sathyamoorthy H, Balakrishnan S, et al. Effect of Bonding Agents on the Shear Bond Strength of Tooth-colored Restorative Materials to Dentin: An In Vitro Study. J Contemp Dent Pract 2024;25(3):245-249.

Utility of Panoramic Radiographs in the Screening of Individuals with Edentulous Arches: A Need-Analysis Study

Abstract Objective: To evaluate the utility of panoramic radiographs in pre-prosthetic screening of edentulous arches. Material and Methods: Panoramic radiographs taken for three years were retrospectively analyzed. Observations from the radiographs shall be categorized and classified into either of the two categories, namely: 'findings with minimal impact on denture fabrication' and 'findings which affect denture fabrication and require further evaluation.' Anatomic variations, jaw pathologies, and residual ridge resorption patterns were assessed. Results: This study included the initial screening of 23,020 panoramic radiographs, out of which 505 (showing either one or both edentulous arches) were included for the study purpose. The age range of the subjects was from 21 to 94 years. 52.6% of the radiographs showed positive findings. More than half of the radiographs belonged to the males (52.5%). Hyperpneumatization of the maxillary sinus, crestal position of the mental foramen, and retained root fragments were the most common entities noted in the radiographs. Changes in the mental foramen were significantly higher in males than females (p=0.002). Conclusion: Observations from this study showed that panoramic radiographs have high utility for screening edentulous arches, and they should be used in routine clinical practice before denture fabrication.