Application of 2,3-naphthalenediamine in labeling natural carbohydrates for capillary electrophoresis.

Neutral and acidic monosaccharide components in Ganoderma lucidum polysaccharide are readily labeled with 2,3-naphthalenediamine, and the resulting saccharide-naphthimidazole (NAIM) derivatives are quantified by capillary electrophoresis (CE) in borate buffer. Using sulfated-α-cyclodextrin as the chiral selector, enantiomers of monosaccharide-NAIMs are resolved on CE in phosphate buffer, allowing a simultaneous determination of the absolute configuration and sugar composition in the mucilage polysaccharide of a medicinal herb Dendrobium huoshanense. Together with the specific enzymatic reactions of various glycoside hydrolases on the NAIM derivatives of glycans, the structures of natural glycans can be deduced from the digestion products identified by CE analysis. Though heparin dissachrides could be successfully derived with the NAIM-labeling method, the heparin derivatives with the same degree of sulfation could not be separated by CE.

Bis-indole derivatives for polysaccharide compositional analysis and chiral resolution of D-, L-monosaccharides by ligand exchange capillary electrophoresis using borate-cyclodextrin as a chiral selector.

A series of aldo-bis-indole derivatives (aldo-BINs) was prepared by aromatic C-alkylation reactions of aldoses and indole in acetic acid solution. Common monosaccharides such as glucose, mannose, galactose, fucose, xylose, rhamnose, ribose, arabinose and N-acetylglucosamine were smoothly derivatized to form the UV absorbing aldo-BINs. The use of a capillary electrophoretic method to separate these novel aldo-BIN derivatives was established. The capillary electrophoresis conditions were set by using borate buffer (100 mM) at high pH (pH 9.0). The limit of determination was assessed to be 25 nM. The enantioseparation of D, L-pairs of aldo-BINs based on chiral ligand-exchange capillary electrophoresis technology was also achieved by using modified hydroxypropyl-ß-cyclodextrin as the chiral selector in the presence of borate buffer. This aldose labeling method was applied successfully to the compositional and configurational analysis of saccharides, exemplified by a rapid and efficient method to simultaneously analyze the composition and configuration of saccharides from the medicinal herbs Cordyceps sinensis and Dendrobium huoshanense.

Monosaccharide-NAIM derivatives for D-, L-configurational analysis.

The D-, L-enantiomeric pairs of common monosaccharides (xylose, ribose, rhamnose, arabinose, fucose, glucose, mannose, galactose, N-acetylgalactosamine, glucuronic acid and galacturonic acid) were derivatized with 2,3-naphthalenediamine to form the corresponding D-, L-aldo-NAIM derivatives. A simple and facile capillary electrophoretic method was established for sugar composition analysis by simultaneously determining the migration times of these aldo-NAIMs using borate buffer at high pH (100 mM, pH 9.0). The methodology is also applicable to sialic acid (ketose monosaccharides). The quantitation level of the proposed method was in the 10~500 ppm range and the LOD was 1 ppm. The enantioseparation of D, L pairs of aldo-NAIMs were also achieved by using modified sulfated-α-cyclodextrin as the chiral selector in phosphate buffer (300 mM, pH 3.0). In addition, the combination by reductive amination of amino-aldo-NAIM agent and D-, L-enantiomeric pairs of monosaccharides formed a diastereomeric pair for saccharide configuration analysis. Aldo-NAIM derivatives are thus shown to be rapid and efficient agents for analyzing saccharide compositions and configurations with good linearity and short analysis times via capillary electrophoresis.

I2-catalyzed oxidative condensation of aldoses with diamines: synthesis of aldo-naphthimidazoles for carbohydrate analysis.

A novel method for the conversion of unprotected and unmodified aldoses to aldo-imidazoles has been developed. Using iodine as a catalyst in acetic acid solution, a series of mono- and oligosaccharides, including those containing carboxyl and acetamido groups, undergo an oxidative condensation reaction with aromatic vicinal diamines at room temperature to give the corresponding aldo-imidazole products in high yields. No cleavage of the glycosidic bond occurs under the mild reaction conditions. The compositional analysis of saccharides is commonly realized by capillary electropheresis of the corresponding aldo-imidazole derivatives, which are easily synthesized by the reported iodine-promoted oxidative condensation. In addition, a series of aldo-imidazoles were determined by matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF MS) to analyze molecular weight and ion intensity. The diamine-labeled saccharides showed enhanced signals in MALDI-TOF MS. The combined use of aldoimidazole derivatization and mass spectrometric analysis thus provides a rapid method for identification of saccharides, even when less than 1 pmol of saccharide is present in the sample. These results can be further applied to facilitate the isolation and analysis of novel saccharides.

Solid-phase extraction and large-volume sample stacking with an electroosmotic flow pump in capillary electrophoresis for determination of methotrexate and its metabolites in human plasma.

This paper describes approaches for large-volume sample stacking (LVSS) with an EOF pumpin CE for the determination of methotrexate (MTX) and its metabolites in human plasma. After pretreatment of plasma through a SPE cartridge, a large sample volume was loaded by hydrodynamic injection (3 psi, 70 s) into the capillary filled with phosphate buffer (70 mM, pH 6.0) containing 0.01% polyethylene oxide. Following removal of a large plug of sample matrix from the capillary using polarity switching (-25 kV), the separation of anionic analytes was subsequently performed without changing polarity again, achieving an improvement of sensitivity of around a 100-fold. The method was applied to therapeutic drug monitoring of MTX in one acute lymphoblastic leukemia patient. This study is one of very few applications showing the feasibility of LVSS in analysis of biological samples by CE.

High-performance liquid chromatography with electrochemical detection for analysis of gliclazide in plasma.

A sensitive HPLC-electrochemical detection method was developed for the analysis of gliclazide (GL) in human plasma. After deproteination of 100 microL of plasma by acetonitrile, evaporation, and reconstitution, GL was separated on a C18 column (150 mm x 4.6 mm) by the mobile phase (70 mM disodium tetraborate, pH 7.5, containing 26.5% of acetonitrile). The regression equations were linear (r> 0.9990) over the range of 50 nM to 4.00 microM. The precision and accuracy of intra- and inter-day analysis were less than 5.3 and 0.93% for relative standard deviation and relative error, respectively. The limit of detection for plasma was 10 nM for GL (S/N = 3, 10 microL injection). This newly developed method was applied for monitoring blood levels with one healthy volunteer dosing with a GL tablet.

Micellar electrokinetic chromatography for simultaneous determination of six corticosteroids in commercial pharmaceuticals.

We have developed a micellar electrokinetic chromatography (MEKC) method using bile salts for the simultaneous determination of six corticosteroids, including betamethasone, cortisone, prednisolone, 6alpha-methylprednisolone, triamcinolone, and prednisone. The separation was performed using borate buffer containing sodium cholate and sodium deoxycholate. Several parameters were studied, including bile salt concentrations, concentrations and pH of borate buffer, and analytical voltages. In method validation, calibration curves were linear over a range of 10-100 microM for each corticosteroid. The RSD (relative standard deviation) and RE (relative error) were all less than 5% for intra- and interday assays. The limit of detection of each analyte was 5 microM. The recoveries were greater than 95%. Application of this method for quality control of commercial tablets also proved to be feasible. All analytical values fall within the labeled amount of 90-110% for betamethasone and prednisolone, and of the labeled amount of 92.5-107.5% for 6alpha-methylprednisolone, as required by the United State Pharmacopeia 25 (USP 25).

Simultaneous determination of methotrexate and its eight metabolites in human whole blood by capillary zone electrophoresis.

A simple and selective capillary electrophoretic method was established for the simultaneous determination of methotrexate (MTX), 7-hydroxymethotrexate (7-OHMTX), 2,4-diamino-N10-methylpteroic acid (DAMPA), and polyglutamate derivatives [MTX-(Glu)n, n=2-7] in whole blood. After extraction, those analytes were separated by fused-silica capillary and a running buffer containing glycine (1.2 M, pH 9.3). The quantitative ranges were 10-50 microM for each analyte. The intra- and inter-day RSD and RE values were all less than 6 and 11%, respectively. The limits of detection (S/N= 3, injection 5 s) were found to be 1 microM for MTX, 7-OHMTX, MTX-(Glu)2, MTX-(Glu)3, and MTX-(Glu)4; 3 microM for MTX-(Glu)5 and MTX-(Glu)6; 5 microM for MTX-(Glu)7, and 8 microM for DAMPA. All recoveries were greater than 94%. This method was applied to blood MTX monitoring in a patient with acute lymphoblastic leukemia.