Electrochemical processes associated with changes in structure, connectivity or composition typically proceed via new phase nucleation with subsequent growth of nuclei. Understanding and controlling reactions requires the elucidation and control of nucleation mechanisms. However, factors controlling nucleation kinetics, including the interplay between local mechanical conditions, microstructure and local ionic profile remain inaccessible. Furthermore, the tendency of current probing techniques to interfere with the original microstructure prevents a systematic evaluation of the correlation between the microstructure and local electrochemical reactivity. In this work, the spatial variability of irreversible nucleation processes of Li on a Li-ion conductive glass-ceramics surface is studied with ~30 nm resolution. An increased nucleation rate at the boundaries between the crystalline AlPO4 phase and amorphous matrix is observed and attributed to Li segregation. This study opens a pathway for probing mechanisms at the level of single structural defects and elucidation of electrochemical activities in nanoscale volumes.
Crystallization/methods , Electroplating/methods , Lithium/chemistry , Lithium/radiation effects , Nanoparticles/chemistry , Electrochemistry/methods , Electrolytes/chemistry , Electrolytes/radiation effects , Electromagnetic Fields , Ions/chemistry , Ions/radiation effects , Materials Testing
Electron spin resonance (ESR) spectroscopy was used to monitor the local environment of 2,2,6,6-tetramethyl-4-piperidone N-oxide (TEMPONE) spin probe in Li(+), Ca(2+), and Al(3+) ion-exchanged Nafion 117 membranes swollen with mixed methanol/water solvent at varying compositions. The (14)N hyperfine splitting, a(N), which reflects the local polarity of the nitroxide probe, remains nearly steady at higher solvent contents but increases substantially at lower solvent contents, reflecting close contact with the ions. The rotational rate (R) of the probe increased with solvent content, depending strongly on the amount of solvent at low contents but increasing more gradually at higher solvent contents, similar to the behavior of previously measured solvent translation diffusion coefficients. The rotational rate data from water-containing membranes were fitted using the Fujita free-volume diffusion model, which indicated that multivalent ions tend to increase the free volume fraction of the polymer while decreasing that of the solvent phase. Methanol-containing membranes exhibited greater variation with different exchange ions, but the data could not be fit using the free-volume model, suggesting that the assumption of two phases underlying the free-volume model might not apply to this case. The difference in the trends of swelling between water and methanol is consistent with previous results that have indicated different patterns of penetration for the two solvents. The results are interpreted in terms of changes in membrane morphology with higher-valence ions.
The CO2 in the cathode exhaust of a liquid feed direct methanol fuel cell (DMFC) has two sources: methanol diffuses through the membrane electrode assembly (MEA) to the cathode where it is catalytically oxidized to CO2; additionally, a portion of the CO2 produced at the anode diffuses through the MEA to the cathode. The potential-dependent CO2 exhaust from the cathode was monitored by online electrochemical mass spectrometry (ECMS) with air and with H2 at the cathode. The precise determination of the crossover rates of methanol and CO2, enabled by the subtractive normalization of the methanol/air to the methanol/H2 ECMS data, shows that methanol decreases the membrane viscosity and thus increases the diffusion coefficients of sorbed membrane components. The crossover of CO2 initially increases linearly with the Faradaic oxidation of methanol, reaches a temperature-dependent maximum, and then decreases. The membrane viscosity progressively increases as methanol is electrochemically depleted from the anode/electrolyte interface. The crossover maximum occurs when the current dependence of the diffusion coefficients and membrane CO2 solubility dominate over the Faradaic production of CO2. The plasticizing effect of methanol is corroborated by measurements of the rotational diffusion of TEMPONE (2,2,6,6-tetramethyl-4-piperidone N-oxide) spin probe by electron spin resonance spectroscopy. A linear inverse relationship between the methanol crossover rate and current density confirms the absence of methanol electro-osmotic drag at concentrations relevant to operating DMFCs. The purely diffusive transport of methanol is explained in terms of current proton solvation and methanol-water incomplete mixing theories.
Electron spin resonance (ESR) was used to monitor the local environment of 2,2,6,6-tetramethyl-4-piperidone N-oxide (Tempone) spin probe in water and methanol mixtures in solution and in Li(+) ion exchanged Nafion 117 membranes. Solution spectra were analyzed using the standard fast-motion line width parameters, while membrane spectra were fitted using the microscopic order macroscopic disorder (MOMD) slow-motional line shape program of Freed and co-workers. The (14)N hyperfine splitting, aN, which reflects the local polarity of the nitroxide probe, decreases with increasing methanol concentration, consistent with the decrease in solvent polarity. The polarity depended only weakly on composition in the Nafion membrane, but was noticeably more temperature-dependent. The microviscosity of the membrane aqueous phase as reflected by the rotational correlation time (tauc) of the probe, was nearly 2 orders of magnitude longer in the membrane than in solution and varied by an order of magnitude over the composition range studied. The probe exhibits significant local ordering in the aqueous phase of Nafion membranes that is diminished with increasing methanol concentration.
