Efficacy of 233 nm LED far UV-C-radiation against clinically relevant bacterial strains in the phase 2/ step 2 in vitro test on basis of EN 14561 and on an epidermis cell model.

INTRODUCTION: Healthcare-acquired infections and overuse of antibiotics are a common problem. Rising emergence of antibiotic and antiseptic resistances requires new methods of microbial decontamination or decolonization as the use of far-UV-C radiation. METHODS: The microbicidal efficacy of UV-C radiation (222 nm, 233 nm, 254 nm) was determined in a quantitative carrier test and on 3D-epidermis models against Staphylococcus (S.) aureus, S.epidermidis, S.haemolyticus, S.lugdunensis, Klebsiella pneumoniae, and Pseudomonas aeruginosa. To mimic realistic conditions, sodium chloride solution, mucin, albumin, artificial saliva, artificial wound exudate and artificial sweat were used. RESULTS: In sodium chloride solution, irradiation with a dose of 40 mJ/cm2 (233 nm) was sufficient to achieve 5 lg reduction independent of bacteria genus or species. In artificial sweat, albumin and artificial wound exudate, a reduction >3 lg was reached for most of the bacteria. Mucin and artificial saliva decreased the reduction to <2 lg. On 3D epidermis models, reduction was lower than in the carrier test. CONCLUSION: UV-C radiation at 233 nm was proven to be efficient in bacteria inactivation independent of genus or species thus being a promising candidate for clinical use in the presence of humans and on skin/mucosa.

A comparison of consistent UV treatment versus inconsistent UV treatment in horticultural production of lettuce.

UV radiation is an underrated radiation currently missing in many horticultural production systems of vegetables in protected cultivation. It can be added e.g., in LED light sources. Using lettuce as a model plant, this study determined whether the use of UVB LEDs is suitable (1) for use in consistent systems (indoor farming) or (2) inconsistent systems (greenhouse). Blue and red LEDs were selected as additional artificial lighting to UVB LEDs. Both approaches led to a reproducible increase of desired flavonol glycosides, such as quercetin-3-O-(6''-O-malonyl)-glucoside or quercetin-3-O-glucuronide and the anthocyanin cyanidin-3-O-(6''-O-malonyl)-glucoside in lettuce. The impact of the consistent UVB treatment is higher with up to tenfold changes than that of the inconsistent UVB treatment in the greenhouse. Varying natural light and temperature conditions in greenhouses might affect the efficiency of the artificial UVB treatment. Here, UVB LEDs have been tested and can be recommended for further development of lighting systems in indoor farming and greenhouse approaches.

Skin tolerant inactivation of multiresistant pathogens using far-UVC LEDs.

Multiresistant pathogens such as methicillin-resistant Staphylococcus aureus (MRSA) cause serious postoperative infections. A skin tolerant far-UVC (< 240 nm) irradiation system for their inactivation is presented here. It uses UVC LEDs in combination with a spectral filter and provides a peak wavelength of 233 nm, with a full width at half maximum of 12 nm, and an irradiance of 44 µW/cm2. MRSA bacteria in different concentrations on blood agar plates were inactivated with irradiation doses in the range of 15-40 mJ/cm2. Porcine skin irradiated with a dose of 40 mJ/cm2 at 233 nm showed only 3.7% CPD and 2.3% 6-4PP DNA damage. Corresponding irradiation at 254 nm caused 15-30 times higher damage. Thus, the skin damage caused by the disinfectant doses is so small that it can be expected to be compensated by the skin's natural repair mechanisms. LED-based far-UVC lamps could therefore soon be used in everyday clinical practice to eradicate multiresistant pathogens directly on humans.

Noninvasive measurement of the 308 nm LED-based UVB protection factor of sunscreens.

The current method for determining the sun protection factor (SPF) requires erythema formation. Noninvasive alternatives have recently been suggested by several groups. Our group previously developed a functional sensor based on diffuse reflectance measurements with one UVB LED, which was previously evaluated on pig ear skin. Here we present the results of a systematic in vivo study using 12 sunscreens on 10 volunteers (skin types [ST] I-III). The relationship of the UVB-LED reflectance of unprotected skin and melanin index was determined for each ST. The spatial variation of the reflectance signal of different positions was analyzed and seems to be mainly influenced by sample inhomogeneity except for high-protection factors (PFs) where signal levels are close to detection noise. Despite the low-signal levels, a correlation of the measured LED-based UVB PF with SPF reference values from test institutes with R2 = 0.57 is obtained, suggesting a strong relationship of SPF and LED-based UVB-PF. Measured PFs tend to be lower for increasing skin pigmentation. The sensor design seems to be suitable for investigations where a fast measurement of relative changes of PFs, such as due to inhomogeneous application, bathing and sweating, is of interest.