QTL for survival to UV-C radiation in Drosophila melanogaster.

PURPOSE: The aim of this study was to investigate tolerance to UV-C (ultraviolet C, 280-100 nm) radiation in Drosophila melanogaster, implementing a quantitative trait locus (QTL) mapping approach. This is of interest to test for genetic variation in survival to UV (ultraviolet) radiation. MATERIALS AND METHODS: We performed a QTL scan in D. melanogaster recombinant inbred lines (RIL) constructed from parental stocks derived from a crossing between northern and southern hemisphere populations that segregated substantial genetic variation in thermal resistance in a previous study. Here, two experimental treatments were implemented: Continuous and cyclic UV-C radiation. RESULTS: Significant QTL were detected on all three major chromosomes. Among these, multiple trait composite interval mapping revealed a significant QTL in the pericentromeric region of chromosome 2, a genome region consistently implicated in thermotolerance in previous studies. CONCLUSIONS: This study shows substantial genetic variation for UV-C radiation resistance in D. melanogaster, with QTL for survival to UV-C radiation generally overlapping with major thermotolerance QTL. The genetic architecture of UV-C radiation resistance appears to be more complex in continuously irradiated individuals.

Survival of heat stress with and without heat hardening in Drosophila melanogaster: interactions with larval density.

Survival of a potentially lethal high temperature stress is a genetically variable thermal adaptation trait in many organisms. Organisms cope with heat stress by basal or induced thermoresistance. Here, we tested quantitative trait loci (QTL) for heat stress survival (HSS) in Drosophila melanogaster, with and without a cyclic heat-hardening pre-treatment, for flies that were reared at low (LD) or high (HD) density. Mapping populations were two panels of recombinant inbred lines (RIL), which were previously constructed from heat stress-selected stocks: RIL-D48 and RIL-SH2, derived from backcrosses to stocks of low and high heat resistance, respectively. HSS increased with heat hardening in both LD and HD flies. In addition, HSS increased consistently with density in non-hardened flies. There was a significant interaction between heat hardening and density effects in RIL-D48. Several QTL were significant for both density and hardening treatments. Many QTL overlapped with thermotolerance QTL identified for other traits in previous studies based on LD cultures only. However, three new QTL were found in HD only (cytological ranges: 12E-16F6; 30A3-34C2; 49C-50C). Previously found thermotolerance QTL were also significant for flies from HD cultures.

Quantitative trait loci for longevity in heat-stressed Drosophila melanogaster.

Longevity is a typical quantitative trait which is influenced by multiple genes. Here we explore the genetic variation in longevity of Drosophila melanogaster in both mildly heat-stressed and control flies. Quantitative trait loci (QTL) analysis for longevity was performed in a single-sex environment at 25°C with and without a mild heat-stress pre-treatment, using a previously reported set of recombinant inbred lines (RIL). QTL regions for longevity in heat-stressed flies overlapped with QTL for longevity in control flies. All longevity QTL co-localized with QTL for longevity identified in previous studies using very different sets of RIL in mixed sex environments, though the genome is nearly saturated with QTL for longevity when considering all previous studies. Heat stress decreased the number of significant QTL for longevity if compared to the control environment. Our mild heat-stress pre-treatment had a beneficial effect (hormesis) more often in shorter-lived than in longer-lived RIL.

Quantitative trait locus for starvation resistance in an intercontinental set of mapping populations of Drosophila melanogaster.

Starvation resistance (SR) is an important trait for survival of insects in the wild. We used recombinant inbred lines (RIL) to search for quantitative trait loci (QTL) in crosses between intercontinental inbred lines that were originally selected for heat-knockdown resistance. SR was measured as the time of survival under repeated events of starvation. SR was consistently higher in females than in males. Composite interval mapping identified one QTL region (cytological range 64D-66E2) on the left arm of chromosome 3 in males, and no QTL was found in females. Many candidate genes that were identified in previous studies of QTL for stress resistance are included within this QTL region. The QTL-allele that decreased SR was found in the line originating from the colder population (Denmark). We discuss our results with regard to multiple candidate genes, noncolocalization with thermotolerance QTL, and possible geographical variation.

Combined expression patterns of QTL-linked candidate genes best predict thermotolerance in Drosophila melanogaster.

Knockdown resistance to high temperature (KRHT) is a thermal adaptation trait in Drosophila melanogaster. Here we used quantitative real-time PCR (qRT-PCR) to test for possible associations between KRHT and the expression of candidate genes within quantitative trait loci (QTL) in eight recombinant inbred lines (RIL). hsp60 and hsc70-3 map within an X-linked QTL, while CG10383, catsup, ddc, trap1, and cyp6a13 are linked in a KRHT-QTL on chromosome 2. hsc70-3 expression increased by heat-hardening. Principal Components analysis revealed that catsup, ddc and trap1 were either co-expressed or combined in their expression levels. This composite expression variable (e-PC1) was positively associated to KRHT in non-hardened RIL. In heat-hardened flies, hsp60 was negatively related to hsc70-3 on e-PC2, with effects on KRHT. These results are consistent with the notion that QTL can be shaped by expression variation in combined candidate loci. We found composite variables of gene expression (e-PCs) that best correlated to KRHT. Network effects with other untested linked loci are apparent because, in spite of their associations with KRHT phenotypes, e-PCs were sometimes uncorrelated with their QTL genotype.

QTL for the thermotolerance effect of heat hardening, knockdown resistance to heat and chill-coma recovery in an intercontinental set of recombinant inbred lines of Drosophila melanogaster.

The thermotolerance effect of heat hardening (also called short-term acclimation), knockdown resistance to high temperature (KRHT) with and without heat hardening and chill-coma recovery (CCR) are important phenotypes of thermal adaptation in insects and other organisms. Drosophila melanogaster from Denmark and Australia were previously selected for low and high KRHT, respectively. These flies were crossed to construct recombinant inbred lines (RIL). KRHT was higher in heat-hardened than in nonhardened RIL. We quantify the heat-hardening effect (HHE) as the ratio in KRHT between heat-hardened and nonhardened RIL. Composite interval mapping revealed a more complex genetic architecture for KRHT without heat-hardening than for KRHT in heat-hardened insects. Five quantitative trait loci (QTL) were found for KRHT, but only two of them were significant after heat hardening. KRHT and CCR showed trade-off associations for QTL both in the middle of chromosome 2 and the right arm of chromosome 3, which should be the result of either pleiotropy or linkage. The major QTL on chromosome 2 explained 18% and 27-33% of the phenotypic variance in CCR and KRHT in nonhardened flies, respectively, but its KRHT effects decreased by heat hardening. We discuss candidate loci for each QTL. One HHE-QTL was found in the region of small heat-shock protein genes. However, HHE-QTL explained only a small fraction of the phenotypic variance. Most heat-resistance QTL did not colocalize with CCR-QTL. Large-effect QTL for CCR and KRHT without hardening (basal thermotolerance) were consistent across continents, with apparent transgressive segregation for CCR. HHE (inducible thermotolerance) was not regulated by large-effect QTL.

Knockdown resistance to heat stress and slow recovery from chill coma are genetically associated in a quantitative trait locus region of chromosome 2 in Drosophila melanogaster.

In insects, two ecologically relevant traits of thermal adaptation are knockdown resistance to high temperature (KRHT) and chill-coma recovery (CCR). Chromosome 2 of Drosophila melanogaster was tested for quantitative trait loci (QTL) affecting both CCR and KRHT in backcrosses between homosequential lines that are fixed for the standard (noninverted) sequence of this autosome. These lines were obtained by artificial selection on KRHT and subsequent inbreeding from a stock that was derived from a single wild population. Heat-induced expression of the 70KD heat-shock protein (Hsp70) was also examined for variation between the lines. Composite interval mapping was performed for each trait on each reciprocal backcross, identifying one QTL region in the middle of chromosome 2 for both KRHT and CCR. The largest estimates of additive effects were found in pericentromeric regions of chromosome 2, accounting for 10-14% (CCR) and 10-17% (KRHT) of the phenotypic variance in BC populations. No QTL was found in the region of the heat-shock factor (hsf) gene. However, the two parental lines have diverged in the heat-induced Hsp70 expression. Distribution of KRHT QTL on chromosome 2 was similar between this study based on crosses between lines selected from a single wild population and previous work based on crosses between selection lines from different continents. Colocalized QTL showed a trade-off association between CCR and KRHT, which should be the result of either multiple, tightly linked trait-specific genes or a single gene with pleiotropic effects on the traits. We discuss candidate loci contained within the QTL regions.

Heat-induced hormesis in longevity of two sibling Drosophila species.

Previous work showed that mild-heat stress induces longevity hormesis in a model organism, D. melanogaster. Here we compared the possible heat-induced hormesis in longevity of other species of Drosophila, D. buzzatii and its sibling species D. koepferae, in a single-sex environment. Possible correlations between longevity and heat-stress resistance were also tested by measuring longevity, heat-knockdown resistance and the heat-induced Hsp70 expression for each species in a common environment. D. buzzatii was longer lived than D. koepferae at benign temperature. Knockdown resistance to heat stress was positively correlated to longevity within species. However, the shorter-lived species was more resistant to knockdown by heat stress than the longer-lived species. The heat-induced Hsp70 expression was similar between species. A heat-shock treatment (37 degrees C for 1 h at 4 days of age) extended mean longevity in the longer lived species but not in the shorter lived species. In D. koepferae, the demographic rate of senescence decreased but the baseline mortality rate increased by heat-shock, resulting in no extension of mean longevity. Sympatric populations of closely related species can be differentially sensitive to temperature and exhibit different patterns of 37 degrees C-induced hormesis in demographic senescence and longevity. The results also show that positive correlations between stress resistance and life span within species can shift in sign across closely related species. Finally, this study shows that heat-induced hormesis in longevity can be found across different Drosophila species, as hormetic effects are not limited to the previously studied D. melanogaster.

Developmental time and size-related traits in Drosophila buzzatii along an altitudinal gradient from Argentina.

Clinal analysis for fitness-related traits provides a well-known approach to investigate adaptive evolution. Several fitness-related traits (developmental time, thorax length, wing length and wing loading) were measured at two laboratory generations (G7 and G33) of D. buzzatii from an altitudinal gradient from northwestern Argentina, where significant thermal differences persist. Developmental time (DT) was positively correlated with altitude of origin of population. Further, DT was negatively correlated with maximal mean temperature at the site of origin of population, and this thermal variable decreases with altitude. Wing loading tended to be larger in highland than in lowland populations, suggesting that flight performance is subject to stronger selection pressure in highland populations. Developmental time showed a significant increase with laboratory generation number. There was no significant correlation between developmental time and body size across populations along the altitudinal cline of DT. This result illustrates that developmental time and body size do not always evolve in the same direction, even though both traits are often positively and genetically correlated in a well-known tradeoff in Drosophila.