RESUMEN
Identifying the active site of catalysts for the oxygen evolution reaction (OER) is critical for the design of electrode materials that will outperform the current, expensive state-of-the-art catalyst, RuO2. Previous work shows that mixed Mn/Ru oxides show comparable performances in the OER, while reducing reliance on this expensive and scarce Pt-group metal. Herein, X-ray photoelectron spectroscopy and X-ray absorption spectroscopy (XAS) are performed on mixed Mn/Ru oxide materials for the OER to understand structural and chemical changes at both metal sites during oxygen evolution. The results show that the Mn-content affects both the oxidation state and local coordination environment of Ru sites. Operando XAS experiments suggest that the presence of MnOx might be essential to achieve high activity likely by facilitating changes in the O-coordination sphere of Ru centers.
RESUMEN
The development of a reusable and low-cost urine glucose sensor can benefit the screening and control of diabetes mellitus. This study focused on the feasibility of employing microbial fuel cells (MFC) as a selective glucose sensor for continuous monitoring of glucose levels in human urine. Using MFC technology, a novel cylinder sensor (CS) was developed. It had a quick response time (100 s), a large detection range (0.3-5 mM), and excellent accuracy. More importantly, the CS could last for up to 5 months. The selectivity of the CS was validated by both synthetic and actual diabetes-negative urine samples. It was found that the CS's selectivity could be significantly enhanced by adjusting the concentration of the culture's organic matter. The CS results were comparable to those of a commercial glucose meter (recovery ranged from 93.6% to 127.9%) when the diabetes-positive urine samples were tested. Due to the multiple advantages of high stability, low cost, and high sensitivity over urine test strips, the CS provides a novel and reliable approach for continuous monitoring of urine glucose, which will benefit diabetes assessment and control.
Asunto(s)
Glucemia , Diabetes Mellitus Tipo 1 , Automonitorización de la Glucosa Sanguínea/métodos , Diabetes Mellitus Tipo 1/tratamiento farmacológico , Glucosa , Humanos , Sistemas de Infusión de InsulinaRESUMEN
While 2D transition metal dichalcogenides are known to be promising materials for electrocatalysis of hydrogen production, it is not clear which member of this family of materials is the most effective catalyst. Here we perform a comprehensive study, comparing the catalytic performance of electrodes consisting of porous arrays of liquid exfoliated MX2 nanosheets (M = Mo, W; X = S, Se, Te). We find a clear hierarchy with selenides > sulphides > tellurides with MoSe2 clearly out-performing the other materials. In all cases the performance, as characterised by current density at a given potential, can be improved by increasing the number of active sites (via control of the electrode thickness) and/or by adding carbon nanotubes to the electrode (i.e. increasing the electrode conductivity). While all materials formed reasonably stable electrodes, addition of nanotubes tended to improve mechanical cohesion. In an attempt to maximise performance, we prepared thick (â¼15 µm), free standing MoSe2/SWNT composite electrodes which displayed Tafel slopes of â¼77 mV per decade and exchange current densities of â¼0.1 mA cm(-2). These electrodes had low onset potentials, reaching -2 mA cm(-2) at -41 mV (vs. RHE) and generated high current densities of -35 mA cm(-2) at -200 mV (vs. RHE).
RESUMEN
This paper presents a review of the redox and electrocatalytic properties of transition metal oxide electrodes, paying particular attention to the oxygen evolution reaction. Metal oxide materials may be prepared using a variety of methods, resulting in a diverse range of redox and electrocatalytic properties. Here we describe the most common synthetic routes and the important factors relevant to their preparation. The redox and electrocatalytic properties of the resulting oxide layers are ascribed to the presence of extended networks of hydrated surface bound oxymetal complexes termed surfaquo groups. This interpretation presents a possible unifying concept in water oxidation catalysis - bridging the fields of heterogeneous electrocatalysis and homogeneous molecular catalysis.
RESUMEN
The oxygen evolution reaction at multi-cycled iron oxy-hydroxide films in aqueous alkaline solution is discussed. Steady-state Tafel plot analysis and electrochemical impedance spectroscopy have been used to elucidate the kinetics and mechanism of oxygen evolution. Tafel slopes of ca. 60 mV dec(-1) and 40 mV dec(-1) are found at low overpotentials depending on the oxide growth conditions, with an apparent Tafel slope of ca. 120 mV dec(-1) at high overpotentials. Reaction orders of ca. 0.5 and 1.0 are observed at low and high overpotentials, again depending on the oxide growth conditions. A mechanistic scheme involving the active participation of octahedrally coordinated anionic iron oxyhydroxide surfaquo complexes, which form the porous hydrous layer, is proposed. The latter structure contains considerable quantities of water molecules which facilitate hydroxide ion discharge at the metal site during active oxygen evolution. This work brings together current research in heterogeneous electrocatalysis and homogeneous molecular catalysis for water oxidation.
Asunto(s)
Técnicas Electroquímicas , Compuestos Férricos/química , Oxígeno/química , Catálisis , Espectroscopía Dieléctrica , Oxidación-Reducción , Agua/químicaRESUMEN
Outstanding issues regarding the film formation, redox switching characteristics and the oxygen evolution reaction (OER) electrocatalytic behaviour of multicycled iron oxyhydroxide films in aqueous alkaline solution have been revisited. The oxide is grown using a repetitive potential multicycling technique, and the mechanism of the latter hydrous oxide formation process has been discussed. A duplex layer model of the oxide/solution interphase region is proposed. The acid/base behaviour of the hydrous oxide and the microdispersed nature of the latter material has been emphasised. The hydrous oxide is considered as a porous assembly of interlinked octahedrally coordinated anionic metal oxyhydroxide surfaquo complexes which form an open network structure. The latter contains considerable quantities of water molecules which facilitate hydroxide ion discharge at the metal site during active oxygen evolution, and also charge compensating cations. The dynamics of redox switching has been quantified via analysis of the cyclic voltammetry response as a function of potential sweep rate using the Laviron-Aoki electron hopping diffusion model by analogy with redox polymer modified electrodes. Steady state Tafel plot analysis has been used to elucidate the kinetics and mechanism of oxygen evolution. Tafel slope values of ca. 60 mV dec(-1) and ca. 120 mV dec(-1) are found at low and high overpotentials respectively, whereas the reaction order with respect to hydroxide ion activity changes from ca. 3/2 to ca. 1 as the potential is increased. These observations are rationalised in terms of a kinetic scheme involving Temkin adsorption and the rate determining formation of a physisorbed hydrogen peroxide intermediate on the oxide surface. The dual Tafel slope behaviour is ascribed to the potential dependence of the surface coverage of adsorbed intermediates.
RESUMEN
The kinetics and mechanism of the oxygen evolution reaction at a series of RuO(2)/IrO(2) mixed oxides in aqueous acid and alkaline solution has been examined using a variety of electrochemical methods. Factors affecting the electrocatalytic activity have been elucidated and novel oxygen evolution mechanisms in terms of reactive oxyruthenium and oxyiridium surface groups are proposed.
RESUMEN
Outstanding issues regarding the redox switching characteristics and the oxygen evolution reaction (OER) electrocatalytic behaviour of multicycled iron oxyhydroxide films in aqueous alkaline solution have been examined. Charge percolation through the hydrous layer has been quantified, using cyclic voltammetry, in terms of a charge transport diffusion coefficient D(CT) which admits a value of ca. 3 x 10(-10) cm2 s(-1). Steady-state Tafel plot analysis and electrochemical impedance spectroscopy have been used to elucidate the kinetics and mechanism of oxygen evolution. Tafel slope values of ca. 60 mV dec(-1) and ca. 120 mV dec(-1) are found at low and high overpotentials respectively, whereas the reaction order with respect to hydroxide ion activity changes from ca. 3/2 to ca. 1 as the potential is increased. These observations are rationalised in terms of a kinetic scheme involving Temkin adsorption and the rate determining formation of a physisorbed hydrogen peroxide intermediate on the oxide surface. The dual Tafel slope behaviour is ascribed to the potential dependence of the surface coverage of adsorbed intermediates.
RESUMEN
The behaviour of support electrodes modified with randomly dispersed single-wall carbon nanotube meshes containing adsorbed glucose oxidase with respect to amperometric glucose detection at a low potential is demonstrated.
Asunto(s)
Técnicas Biosensibles/métodos , Enzimas Inmovilizadas/química , Glucosa/análisis , Nanotubos de Carbono/química , Electroquímica , Gluconatos/química , Glucosa/química , Glucosa Oxidasa/química , Peróxido de Hidrógeno/química , Lactonas , Oxidación-Reducción , Oxígeno/químicaRESUMEN
The biological relevance of Fe(II)/Fe(III) is becoming evermore apparent, especially in relation to its potential role in the progression of neurodegenerative diseases such as Parkinson's and Alzheimer's disease. The reported relationship between smoking and a reduced incidence of neurodegenerative disorders prompted this work. In order to investigate whether nicotine can interact with iron, we have studied the electrochemical behaviour of a Fe(II)/Fe(III) redox couple in the presence of nicotine. Solubility issues and lack of available nonreacting salts of nicotine necessitated studies being conducted at low pH values. Cyclic voltammetry experiments revealed a definite alteration in the electrochemical behaviour of the Fe(II)/Fe(III) redox couple suggesting the capability of nicotine to complex with free iron and, hence, reduce its reactivity. This is evident from a slower rate of heterogeneous electron transfer, ks, and a shift from reversible to quasi-reversible behaviour, as characterised from the diffusion coefficient (D), the full width half maximum (FWHM), DeltaEp and Ef. Additional complexation titrations, pH ranging from 1 to 7, confirm a weak complexation reaction occurring between Fe(III) and nicotine.
Asunto(s)
Electroquímica , Compuestos Férricos/química , Compuestos Ferrosos/química , Nicotina/química , Transporte de Electrón , Humanos , Concentración de Iones de Hidrógeno , Hierro , Enfermedades Neurodegenerativas/metabolismo , Oxidación-ReducciónRESUMEN
The first kinetic measurements for electron transfer (ferrocene/ferricinium reaction) at the interface between an HTSC (Tl,Pb1223) and a redox polymer (ferrocene-tagged poly-pyrrole) show that superconductivity affects electron transfer rate, which thus offers a novel probe of the superconducting state.