RESUMEN
More complete recycling of plastic waste is possible only if new technologies that go beyond state-of-the-art near-infrared (NIR) sorting are developed. For example, tracer-based sorting is a new technology that explores the upconversion or down-shift luminescence of special tracers based on inorganic materials codoped with lanthanide ions. Specifically, down-shift tracers emit in the shortwave infrared (SWIR) spectral range and can be detected using a SWIR camera preinstalled in a state-of-the-art sorting machine for NIR sorting. In this study, we synthesized a very efficient SWIR tracer by codoping Li3Ba2Gd3 (MoO4)8 with Yb3+ and Er3+, where Yb3+ is a synthesizer ion (excited near 976 nm) and Er3+ emits near 1550 nm. Fine-tuning of the doping concentration resulted in a tracer (Li3Ba2Gd(3-x-y)(MoO4)8:xYb3+, yEr3+, where x = 0.2 and y = 0.4) with a high photoluminescence quantum yield for 1550 nm emission of 70% (using 976 nm excitation). This tracer was used to mark plastic objects. When the object was illuminated by a halogen lamp and a 976 nm laser, the three parts could be easily distinguished based on reflectance and luminescence spectra in the SWIR range: a plastic bottle made of polyethylene terephthalate, a bottle cap made of high-density polyethylene, and a label made of the tracer Li3Ba2Gd3(MoO4)8:Yb3+, Er3+. Importantly, the use of the tracer in sorting may require only the installation of a 976 nm laser in a state-of-the-art NIR sorting system.
RESUMEN
Quaternary tungstates with the composition Li3Ba2Gd3(WO4)8 doped with different concentrations of Dy3+ (from 0.5 to 10 at%) were prepared by the solid-state reaction method at 900 °C. Their structural, spectroscopic and optical properties were studied systematically in this work. X-ray diffraction analysis confirmed the crystallization of Li3Ba2Gd3(WO4)8 to have a monoclinic structure (sp. gr. C2/c); the lattice constants for 1 at% doping concentration of Dy3+ are a = 5.2126(2) Å, b = 12.7382(1) Å, c = 19.1884(3) Å, Vcalc = 1273,40(4) Å3 and ß = a × c = 91.890(9)°. The first principles calculations for the undoped crystal revealed a direct bandgap of 2.45 eV, which is very close to the experimental one. The identified broad, and strong excitation peak at 450 nm indicates that Li3Ba2Gd3(WO4)8:Dy3+ phosphors are suitable to be pumped by a blue laser diode (LD). Under excitation at 445 nm, the phosphor showed a stronger luminescence peak at 575 nm which corresponds to the Dy3+:4F9/2 â 6H13/2 transition, and three weaker emissions peaks at 477, 661, and 750 nm. Meanwhile, the effect of different Dy3+ contents on the luminescence properties was investigated. The optimum concentration to minimize the quenching effect was 4 at% and the critical distance is 31.209 Å. The phosphor emitted strong greenish-yellow light situated at (0.425, 0.472) in CIE coordinates with a color temperature of 3652 K. All the measured luminescence lifetime curves exhibited a single-exponential nature. Excellent thermal stability was found for this tungstate phosphor (the activation energy is 0.352 ± 0.01 eV). The measured absolute photoluminescence quantum yield was around 10.5%. The results presented in this work show that Li3Ba2Gd3(WO4)8:Dy3+ phosphors with strong yellow emission are promising candidates for white-light emitting LED (wLED) applications.
RESUMEN
Short-wave infrared (SWIR) fluorescence could become the new gold standard in optical imaging for biomedical applications due to important advantages such as lack of autofluorescence, weak photon absorption by blood and tissues, and reduced photon scattering coefficient. Therefore, contrary to the visible and NIR regions, tissues become translucent in the SWIR region. Nevertheless, the lack of bright and biocompatible probes is a key challenge that must be overcome to unlock the full potential of SWIR fluorescence. Although rare-earth-based core-shell nanocrystals appeared as promising SWIR probes, they suffer from limited photoluminescence quantum yield (PLQY). The lack of control over the atomic scale organization of such complex materials is one of the main barriers limiting their optical performance. Here, the growth of either homogeneous (α-NaYF4) or heterogeneous (CaF2) shell domains on optically-active α-NaYF4:Yb:Er (with and without Ce3+ co-doping) core nanocrystals is reported. The atomic scale organization can be controlled by preventing cation intermixing only in heterogeneous core-shell nanocrystals with a dramatic impact on the PLQY. The latter reached 50% at 60 mW/cm2; one of the highest reported PLQY values for sub-15 nm nanocrystals. The most efficient nanocrystals were utilized for in vivo imaging above 1450 nm.
RESUMEN
The search for new materials capable of efficient upconversion continues to attract attention. In this work, a comprehensive study of the upconversion luminescence in PbF2:Er3+,Yb3+ crystals with different concentrations of Yb3+ ions in the range of 2 to 7.5 mol% (Er3+ concentration was fixed at 2 mol%) was carried out. The highest value of upconversion quantum yield (ÏUC) 5.9% (at 350 W cm-2) was found in the PbF2 crystal doped with 2 mol% Er3+ and 3 mol% Yb3+. Since it is not always easy to directly measure ÏUC and estimate the related key figure of merit parameter, saturated photoluminescence quantum yield (ÏUCsat), a method to reliably predict ÏUCsat can be useful. Judd-Ofelt theory provides a convenient way to determine the radiative lifetimes of the excited states of rare-earth ions based on absorption measurements. When the luminescence decay times after direct excitation of a level are also measured, ÏUCsat for that level can be calculated. This approach is tested on a series of PbF2:Er3+,Yb3+ crystals. Good agreement between the estimates obtained as above and the directly experimentally measured ÏUCsat values is demonstrated. In addition, three methods of Judd-Ofelt calculations on powder samples were tested and the results were compared with Judd-Ofelt calculations on single crystals, which served as the source of the powder samples. Taken together, the results presented in our work for PbF2:Er3+,Yb3+ crystals contribute to a better understanding of the UC phenomena and provide a reference data set for the use of UC materials in practical applications.
RESUMEN
Lanthanide-based upconversion (UC) allows harvesting sub-bandgap near-infrared photons in photovoltaics. In this work, we investigate UC in perovskite solar cells by implementing UC single crystal BaF2:Yb3+, Er3+ at the rear of the solar cell. Upon illumination with high-intensity sub-bandgap photons at 980 nm, the BaF2:Yb3+, Er3+ crystal emits upconverted photons in the spectral range between 520 and 700 nm. When tested under terrestrial sunlight representing one sun above the perovskite's bandgap and sub-bandgap illumination at 980 nm, upconverted photons contribute a 0.38 mA/cm2 enhancement in the short-circuit current density at lower intensity. The current enhancement scales non-linearly with the incident intensity of sub-bandgap illumination, and at higher intensity, 2.09 mA/cm2 enhancement in current was observed. Hence, our study shows that using a fluoride single crystal like BaF2:Yb3+, Er3+ for UC is a suitable method to extend the response of perovskite solar cells to near-infrared illumination at 980 nm with a subsequent enhancement in current for very high incident intensity.