Mesoporous matrices for the delivery of the broad spectrum bacteriocin, nisin A.

Mesoporous matrices of different pore size and chemical composition were explored as potential delivery matrices for the broad spectrum bacteriocin, nisin A. The adsorption of nisin A onto two mesoporous silicates (MPS - SBA-15, MCM-41) and two periodic mesoporous organosilanes (PMO - MSE, PMO-PA) was examined. It was found that hydrophobic interactions dominated in the adsorption of this peptide to the matrices, lending the highest adsorption to MCM-41 with a small pore size of 2.8 nm. The hydrophobic ethylene-bridged MSE (6 nm pore) improved the loading and protection of nisin A from degradation by a non-specific protease pepsin, over un-functionalised SBA-15 which had a slightly larger pore size and less hydrophobic moieties. Nisin A did not adsorb onto an amine-functionalised PMO. Upon suspension in modified fasted state simulated gastric fluid (pH 1.6), the highest release of nisin A was observed from MCM-41, with a lower release from SBA-15 and MSE, with release following Higuchi release kinetics. No release was detected into modified fasted state simulated intestinal fluid (pH 6.5) but despite this, the suspended matrices loaded with nisin A remained active against Staphylococcus aureus.

Protecting bactofencin A to enable its antimicrobial activity using mesoporous matrices.

There is huge global concern surrounding the emergence of antimicrobial resistant bacteria and this is resulting in an inability to treat infectious diseases. This is due to a lack of new antimicrobials coming to the market and irresponsible use of traditional antibiotics. Bactofencin A, a novel antimicrobial peptide which shows potential as an antibiotic, is susceptible to enzyme degradation. To improve its solution stability and inherent activity, bactofencin A was loaded onto a traditional silica mesoporous matrix, SBA-15, and a periodic mesoporous organosilane, MSE. The loading of bactofencin A was considerably higher onto SBA-15 than MSE due to the hydrophilic nature of SBA-15. While there was no detectable peptide released from SBA-15 into phosphate buffered saline and only 20% of the peptide loaded onto MSE was released, the loaded matrices showed enhanced activity compared to the free peptide during in vitro antimicrobial assays. In addition, the mesoporous matrices were found to protect bactofencin A against enzymatic degradation where results showed that the SBA-15 and MSE with loaded bactofencin A exposed to trypsin inhibited the growth of S. aureus while a large decrease in activity was observed for free bactofencin upon exposure to trypsin. Thus, the activity and stability of bactofencin A can be enhanced using mesoporous matrices and these matrices may enable its potential development as a novel antibiotic. This work also shows that in silico studies looking at surface functional group and size complementarity between the peptide and the protective matrix could enable the systemic selection of a mesoporous matrix for individual bacteriocins with potential antimicrobial therapeutic properties.

Co-reductive fabrication of carbon nanodots with high quantum yield for bioimaging of bacteria.

A simple and straightforward synthetic approach for carbon nanodots (C-dots) is proposed. The strategy is based on a one-step hydrothermal chemical reduction with thiourea and urea, leading to high quantum yield C-dots. The obtained C-dots are well-dispersed with a uniform size and a graphite-like structure. A synergistic reduction mechanism was investigated using Fourier transform infrared spectroscopy and X-ray photoelectron spectroscopy. The findings show that using both thiourea and urea during the one-pot synthesis enhances the luminescence of the generated C-dots. Moreover, the prepared C-dots have a high distribution of functional groups on their surface. In this work, C-dots proved to be a suitable nanomaterial for imaging of bacteria and exhibit potential for application in bioimaging thanks to their low cytotoxicity.