Field enhancement induced by surface defects in two-dimensional ReSe2 field emitters.

The field emission properties of rhenium diselenide (ReSe2) nanosheets on Si/SiO2 substrates, obtained through mechanical exfoliation, have been investigated. The n-type conduction was confirmed by using nano-manipulated tungsten probes inside a scanning electrode microscope to directly contact the ReSe2 flake in back-gated field effect transistor configuration, avoiding any lithographic process. By performing a finite element electrostatic simulation of the electric field, it is demonstrated that the use of a tungsten probe as anode, at a controlled distance from the ReSe2 emitter surface, allows the collection of emitted electrons from a reduced area that furtherly decreases by reducing the tip-sample distance, i.e. allowing a local characterization of the field emission properties. Experimentally, it is shown that the turn-on voltage can be linearly reduced by reducing the cathode-anode separation distance. By comparing the measured current-voltage characteristics with the numerical simulations, it is also shown that the effective field enhancement on the emitter surface is larger than expected because of surface defects. Finally, it is confirmed that ReSe2 nanosheets are suitable field emitters with high time stability and low current fluctuations.

Memory effect and coexistence of negative and positive photoconductivity in black phosphorus field effect transistor for neuromorphic vision sensors.

Black phosphorus (BP) field-effect transistors with ultrathin channels exhibit unipolar p-type electrical conduction over a wide range of temperatures and pressures. Herein, we study a device that exhibits mobility up to 100 cm2 V-1 s-1 and a memory window up to 1.3 µA. Exposure to a supercontinuum white light source reveals that negative photoconductivity (NPC) and positive photoconductivity (PPC) coexist in the same device. Such behavior is attributed to the chemisorbed O2 molecules, with a minor role of physisorbed H2O molecules. The coexistence of NPC and PPC can be exploited in neuromorphic vision sensors, requiring the human eye retina to process the optical signals through alerting and protection (NPC), adaptation (PPC), followed by imaging and processing. Our results open new avenues for the use of BP and other two-dimentional (2D) semiconducting materials in transistors, memories, and neuromorphic vision sensors for advanced applications in robotics, self-driving cars, etc.

Temperature-Dependent Conduction and Photoresponse in Few-Layer ReS2.

The electrical behavior and the photoresponse of rhenium disulfide field-effect transistors (FETs) have been widely studied; however, only a few works have investigated the photocurrent as a function of temperature. In this paper, we perform the electrical characterization of few-layer ReS2-based FETs with Cr-Au contacts over a wide temperature range. We exploit the temperature-dependent transfer and output characteristics to estimate the effective Schottky barrier at the Cr-Au/ReS2 interface and to investigate the temperature behavior of parameters, such as the threshold voltage, carrier concentration, mobility, and subthreshold swing. Through time-resolved photocurrent measurements, we show that the photocurrent increases with temperature and exhibits a linear dependence on the incident light power at both low and room temperatures and a longer rise/decay time at higher temperatures. We surmise that the photocurrent is affected by the photobolometric effect and light-induced desorption of adsorbates which are facilitated by the high temperature and the low pressure.

Electric Transport in Gold-Covered Sodium-Alginate Free-Standing Foils.

The electric transport properties of flexible and transparent conducting bilayers, realized by sputtering ultrathin gold nanometric layers on sodium-alginate free-standing films, were studied. The reported results cover a range of temperatures from 3 to 300 K. In the case of gold layer thicknesses larger than 5 nm, a typical metallic behavior was observed. Conversely, for a gold thickness of 4.5 nm, an unusual resistance temperature dependence was found. The dominant transport mechanism below 70 K was identified as a fluctuation-induced tunneling process. This indicates that the conductive region is not continuous but is formed by gold clusters embedded in the polymeric matrix. Above 70 K, instead, the data can be interpreted using a phenomenological model, which assumes an anomalous expansion of the conductive region upon decreasing the temperature, in the range from 300 to 200 K. The approach herein adopted, complemented with other characterizations, can provide useful information for the development of innovative and green optoelectronics.

Iron-Based Superconducting Nanowires: Electric Transport and Voltage-Noise Properties.

The discovery of iron-based superconductors paved the way for advanced possible applications, mostly in high magnetic fields, but also in electronics. Among superconductive devices, nanowire detectors have raised a large interest in recent years, due to their ability to detect a single photon in the visible and infrared (IR) spectral region. Although not yet optimal for single-photon detection, iron-based superconducting nanowire detectors would bring clear advantages due to their high operating temperature, also possibly profiting of other peculiar material properties. However, there are several challenges yet to be overcome, regarding mainly: fabrication of ultra-thin films, appropriate passivation techniques, optimization of nano-patterning, and high-quality electrical contacts. Test nanowire structures, made by ultra-thin films of Co-doped BaFe2As2, have been fabricated and characterized in their transport and intrinsic noise properties. The results on the realized nanostructures show good properties in terms of material resistivity and critical current. Details on the fabrication and low temperature characterization of the realized nanodevices are presented, together with a study of possible degradation phenomena induced by ageing effects.

Vortex lattice instability at the nanoscale in a parallel magnetic field.

In superconducting materials a dynamical rearrangement of the vortex lattice occurs by forcing vortices at high velocities, until the system can become unstable. This phenomenon is known as vortex lattice instability, in which a sudden transition drives the superconducting system abruptly to the normal state. We present an experimental study on submicron bridges of NbN and NbTiN ultra-thin films with a thickness of few nanometers. The nanoscale effect on vortex lattice instability is investigated not only by the ultra-thin thickness in wide bridges, but also by changing the direction of the external magnetic field applied parallel and perpendicular to the c-axis epitaxial films. Indeed, measurements are performed for both orientations and show the vortex lattice instability, regardless of the superconducting material. Critical currents I c as well as instability currents I* have been compared. However, only in the parallel configuration an unusual 'flying birds' feature appears in the magnetic field dependence of current switching, as a consequence of the ratio I*/I c that is approaching 1. This amazing tendency becomes relevant for practical applications involving nanostructures, since by scaling down sample thickness and rotating the external field towards the in-plane orientation, the ultra-thin film geometry can mimic the bridge narrowing down to the nanoscale.

Environmental Effects on the Electrical Characteristics of Back-Gated WSe2 Field-Effect Transistors.

We study the effect of polymer coating, pressure, temperature, and light on the electrical characteristics of monolayer WSe 2 back-gated transistors with Ni / Au contacts. Our investigation shows that the removal of a layer of poly(methyl methacrylate) (PMMA) or a decrease of the pressure change the device conductivity from p- to n-type. From the temperature behavior of the transistor transfer characteristics, a gate-tunable Schottky barrier at the contacts is demonstrated and a barrier height of ~ 70 meV in the flat-band condition is measured. We also report and discuss a temperature-driven change in the mobility and the subthreshold swing that is used to estimate the trap density at the WSe 2 / SiO 2 interface. Finally, from studying the spectral photoresponse of the WSe 2 , it is proven that the device can be used as a photodetector with a responsivity of ~ 0.5   AW - 1 at 700   nm and 0.37   mW / cm 2 optical power.

I-V and C-V Characterization of a High-Responsivity Graphene/Silicon Photodiode with Embedded MOS Capacitor.

We study the effect of temperature and light on the I-V and C-V characteristics of a graphene/silicon Schottky diode. The device exhibits a reverse-bias photocurrent exceeding the forward current and achieves a photoresponsivity as high as 2.5 A / W . We show that the enhanced photocurrent is due to photo-generated carriers injected in the graphene/Si junction from the parasitic graphene/SiO2/Si capacitor connected in parallel to the diode. The same mechanism can occur with thermally generated carriers, which contribute to the high leakage current often observed in graphene/Si junctions.

Contact Resistance and Channel Conductance of Graphene Field-Effect Transistors under Low-Energy Electron Irradiation.

We studied the effects of low-energy electron beam irradiation up to 10 keV on graphene-based field effect transistors. We fabricated metallic bilayer electrodes to contact mono- and bi-layer graphene flakes on SiO2, obtaining specific contact resistivity ρ c ≈ 19 k Ω · µ m 2 and carrier mobility as high as 4000 cm²·V-1·s-1. By using a highly doped p-Si/SiO2 substrate as the back gate, we analyzed the transport properties of the device and the dependence on the pressure and on the electron bombardment. We demonstrate herein that low energy irradiation is detrimental to the transistor current capability, resulting in an increase in contact resistance and a reduction in carrier mobility, even at electron doses as low as 30 e-/nm². We also show that irradiated devices recover their pristine state after few repeated electrical measurements.