Catalytic Synthesis of Superlinear Alkenyl Arenes Using a Rh(I) Catalyst Supported by a "Capping Arene" Ligand: Access to Aerobic Catalysis.

Alkyl and alkenyl arenes are used in a wide range of products. However, the synthesis of 1-phenylalkanes or their alkenyl variants from arenes and alkenes is not accessible with current commercial acid-based catalytic processes. Here, it is reported that an air-stable Rh(I) complex, (5-FP)Rh(TFA)(η2-C2H4) (5-FP = 1,2-bis( N-7-azaindolyl)benzene; TFA = trifluoroacetate), serves as a catalyst precursor for the oxidative conversion of arenes and alkenes to alkenyl arenes that are precursors to 1-phenylalkanes upon hydrogenation. It has been demonstrated that coordination of the 5-FP ligand enhances catalyst longevity compared to unligated Rh(I) catalyst precursors, and the 5-FP-ligated catalyst permits in situ recycling of the Cu(II) oxidant using air. The 5-FP ligand provides a Rh catalyst that can maintain activity for arene alkenylation over at least 2 weeks in reactions at 150 °C that involve multiple Cu(II) regeneration steps using air. Conditions to achieve >13 000 catalytic turnovers with an 8:1 linear:branched (L:B) ratio have been demonstrated. In addition, the catalyst is active under aerobic conditions using air as the sole oxidant. At 80 °C, an 18:1 L:B ratio of alkenyl arenes has been observed, but the reaction rate is substantially reduced compared to 150 °C. Quantum mechanics (QM) calculations compare two predicted reaction pathways with the experimental data, showing that an oxidative addition/reductive elimination pathway is energetically favored over a pathway that involves C-H activation by concerted metalation-deprotonation. In addition, our QM computations are consistent with the observed selectivity (11:1) for linear alkenyl arene products.

Catalytic Synthesis of "Super" Linear Alkenyl Arenes Using an Easily Prepared Rh(I) Catalyst.

Linear alkyl benzenes (LAB) are global chemicals that are produced by acid-catalyzed reactions that involve the formation of carbocationic intermediates. One outcome of the acid-based catalysis is that 1-phenylalkanes cannot be produced. Herein, it is reported that [Rh(µ-OAc)(η2-C2H4)2]2 catalyzes production of 1-phenyl substituted alkene products via oxidative arene vinylation. Since C═C bonds can be used for many chemical transformations, the formation of unsaturated products provides a potential advantage over current processes that produce saturated alkyl arenes. Conditions that provide up to a 10:1 linear:branched ratio have been achieved, and catalytic turnovers >1470 have been demonstrated. In addition, electron-deficient and electron-rich substituted benzenes are successfully alkylated. The Rh catalysis provides ortho:meta:para selectivity that is opposite to traditional acid-based catalysis.

Brønsted acid-catalysed intramolecular hydroamination of unactivated alkenes: metal triflates as an in situ source of triflic acid.

Hydroamination of alkenes or alkynes is one of the most straightforward methods to form C-N bonds and nitrogen-containing heterocycles. A simple Lewis acid Al(OTf)3 was found to be an effective precatalyst for the hydroamination of unactivated primary and secondary alkenylamines between 110 and 150 °C. Subsequent studies show that other metal triflates are also effective precatalysts for the hydroamination reactions. For metal triflate salts, mechanistic studies, including kinetics, are consistent with the in situ generation of triflic acid, which likely serves as the active catalyst.

Mechanistic Studies of Single-Step Styrene Production Using a Rhodium(I) Catalyst.

The direct and single-step conversion of benzene, ethylene, and a Cu(II) oxidant to styrene using the Rh(I) catalyst (FlDAB)Rh(TFA)(η2-C2H4) [FlDAB = N,N'-bis(pentafluorophenyl)-2,3-dimethyl-1,4-diaza-1,3-butadiene; TFA = trifluoroacetate] has been reported to give quantitative yields (with Cu(II) as the limiting reagent) and selectivity combined with turnover numbers >800. This report details mechanistic studies of this catalytic process using a combined experimental and computational approach. Examining catalysis with the complex (FlDAB)Rh(OAc)(η2-C2H4) shows that the reaction rate has a dependence on catalyst concentration between first- and half-order that varies with both temperature and ethylene concentration, a first-order dependence on ethylene concentration with saturation at higher concentrations of ethylene, and a zero-order dependence on the concentration of Cu(II) oxidant. The kinetic isotope effect was found to vary linearly with the order in (FlDAB)Rh(OAc)(η2-C2H4), exhibiting no KIE when [Rh] was in the half-order regime, and a kH/kD value of 6.7(6) when [Rh] was in the first-order regime. From these combined experimental and computational studies, competing pathways, which involve all monomeric Rh intermediates and a binuclear Rh intermediate in the other case, are proposed.

Homogenous Electrocatalytic Oxygen Reduction Rates Correlate with Reaction Overpotential in Acidic Organic Solutions.

Improved electrocatalysts for the oxygen reduction reaction (ORR) are critical for the advancement of fuel cell technologies. Herein, we report a series of 11 soluble iron porphyrin ORR electrocatalysts that possess turnover frequencies (TOFs) from 3 s-1 to an unprecedented value of 2.2 × 106 s-1. These TOFs correlate with the ORR overpotential, which can be modulated by changing the E1/2 of the catalyst using different ancillary ligands, by changing the solvent and solution acidity, and by changing the catalyst's protonation state. The overpotential is well-defined for these homogeneous electrocatalysts by the E1/2 of the catalyst and the proton activity of the solution. This is the first such correlation for homogeneous ORR electrocatalysis, and it demonstrates that the remarkably fast TOFs are a consequence of high overpotential. The correlation with overpotential is surprising since the turnover limiting steps involve oxygen binding and protonation, as opposed to turnover limiting electron transfer commonly found in Tafel analysis of heterogeneous ORR materials. Computational studies show that the free energies for oxygen binding to the catalyst and for protonation of the superoxide complex are in general linearly related to the catalyst E1/2, and that this is the origin of the overpotential correlations. This analysis thus provides detailed understanding of the ORR barriers. The best catalysts involve partial decoupling of the influence of the second coordination sphere from the properties of the metal center, which is suggested as new molecular design strategy to avoid the limitations of the traditional scaling relationships for these catalysts.

Mechanistic studies of ethylene hydrophenylation catalyzed by bipyridyl Pt(II) complexes.

Cationic platinum(II) complexes [((t)bpy)Pt(Ph)(L)](+) [(t)bpy =4,4'-di-tert-butyl-2,2'-bipyridyl; L = THF, NC(5)F(5), or NCMe] catalyze the hydrophenylation of ethylene to generate ethylbenzene and isomers of diethylbenzene. Using ethylene as the limiting reagent, an 89% yield of alkyl arene products is achieved after 4 h at 120 °C. Catalyst efficiency for ethylene hydrophenylation is diminished only slightly under aerobic conditions. Mechanistic studies support a reaction pathway that involves ethylene coordination to Pt(II), insertion of ethylene into the Pt-phenyl bond, and subsequent metal-mediated benzene C-H activation. Studies of stoichiometric benzene (C(6)H(6) or C(6)D(6)) C-H/C-D activation by [((t)bpy)Pt(Ph-d(n))(THF)](+) (n = 0 or 5) indicate a k(H)/k(D) = 1.4(1), while comparative rates of ethylene hydrophenylation using C(6)H(6) and C(6)D(6) reveal k(H)/k(D) = 1.8(4) for the overall catalytic reaction. DFT calculations suggest that the transition state for benzene C-H activation is the highest energy species along the catalytic cycle. In CD(2)Cl(2), [((t)bpy)Pt(Ph)(THF)][BAr'(4)] [Ar' = 3,5-bis(trifluoromethyl)phenyl] reacts with ethylene to generate [((t)bpy)Pt(CH(2)CH(2)Ph)(η(2)-C(2)H(4))][BAr'(4)] with k(obs) = 1.05(4) × 10(-3) s(-1) (23 °C, [C(2)H(4)] = 0.10(1) M). In the catalytic hydrophenylation of ethylene, substantial amounts of diethylbenzenes are produced, and experimental studies suggest that the selectivity for the monoalkylated arene is diminished due to a second aromatic C-H activation competing with ethylbenzene dissociation.