RESUMEN
Lead-free highly luminescent CsCu2I3 perovskite has attracted much attention recently, but agreements on basic optical properties have remained unsettled. By correlating X-ray diffraction with the photoluminescence (PL) of CsCu2I3 single-crystal wires, we first show that blue PL at 420 nm originates from CuI. We then exclude defect states as a source for the broadband emission centered at 570 nm from the lack of defect absorption, PL under sub-bandgap photoexcitation, observations of a linear dependence of PL intensity on excitation laser power, and a strong spectral blueshift under mild hydrostatic pressure. Finally, using a model of the self-trapped exciton and the associated coordinate configuration diagram, we explain pressure evolutions of PL energy, intensity, and lifetime. Single-crystal wires also enable us to obtain polarization-dependent Raman spectra down to 10 cm-1 and confirm their respective ambient crystal structure of orthorhombic Cmcm and phase transition to Pbnm at â¼5 GPa.
RESUMEN
Semiconducting cubic boron arsenide (c-BAs) has been predicted to have carrier mobility of 1400 square centimeters per volt-second for electrons and 2100 square centimeters per volt-second for holes at room temperature. Using pump-probe transient reflectivity microscopy, we monitored the diffusion of photoexcited carriers in single-crystal c-BAs to obtain their mobility. With near-bandgap 600-nanometer pump pulses, we found a high ambipolar mobility of 1550 ± 120 square centimeters per volt-second, in good agreement with theoretical prediction. Additional experiments with 400-nanometer pumps on the same spot revealed a mobility of >3000 square centimeters per volt-second, which we attribute to hot electrons. The observation of high carrier mobility, in conjunction with high thermal conductivity, enables an enormous number of device applications for c-BAs in high-performance electronics and optoelectronics.
RESUMEN
Water-ice transformation of few nm nanodroplets plays a critical role in nature including climate change, microphysics of clouds, survival mechanism of animals in cold environments, and a broad spectrum of technologies. In most of these scenarios, water-ice transformation occurs in a heterogenous mode where nanodroplets are in contact with another medium. Despite computational efforts, experimental probing of this transformation at few nm scales remains unresolved. Here, we report direct probing of water-ice transformation down to 2 nm scale and the length-scale dependence of transformation temperature through two independent metrologies. The transformation temperature shows a sharp length dependence in nanodroplets smaller than 10 nm and for 2 nm droplet, this temperature falls below the homogenous bulk nucleation limit. Contrary to nucleation on curved rigid solid surfaces, ice formation on soft interfaces (omnipresent in nature) can deform the interface leading to suppression of ice nucleation. For soft interfaces, ice nucleation temperature depends on surface modulus. Considering the interfacial deformation, the findings are in good agreement with predictions of classical nucleation theory. This understanding contributes to a greater knowledge of natural phenomena and rational design of anti-icing systems for aviation, wind energy and infrastructures and even cryopreservation systems.
RESUMEN
Photoacoustic laser streaming provides a versatile technique to manipulate liquids and their suspended objects with light. However, only gold was used in the initial demonstrations. In this work, we first demonstrate that laser streaming can be achieved with common non-plasmonic metals such as Fe and W by their ion implantations in transparent substrates. We then investigate the effects of ion dose, substrate material and thickness on the strength and duration of streaming. Finally, we vary laser pulse width, repetition rate and power to understand the observed threshold power for laser streaming. It is found that substrate thickness has a negligible effect on laser streaming down to 0.1 mm, glass and quartz produce much stronger streaming than sapphire because of their smaller thermal conductivity, while quartz exhibits the longest durability than glass and sapphire under the same laser intensity. Compared with Au, Fe and W with higher melting points show a longer lifetime although they require a higher laser intensity to achieve a similar speed of streaming. To generate a continuous laser streaming, the laser must have a minimum pulse repetition rate of 10 Hz and meet the minimum pulse width and energy to generate a transient vapor layer. This vapor layer enhances the generation of ultrasound waves, which are required for observable fluid jets. Principles of laser streaming and temperature simulation are used to explain these observations, and our study paves the way for further materials engineering and device design for strong and durable laser streaming.
