Wide-range and accurate modeling of linear alkylbenzene sulfonate (LAS) adsorption/desorption on agricultural soil.

In this paper, rigorous data and adequate models about linear alkylbenzene sulfonate (LAS) adsorption/desorption on agricultural soil are presented, contributing with a substantial improvement over available adsorption works. The kinetics of the adsorption/desorption phenomenon and the adsorption/desorption equilibrium isotherms were determined through batch studies for total LAS amount and also for each homologue series: C10, C11, C12 and C13. The proposed multiple pseudo-first order kinetic model provides the best fit to the kinetic data, indicating the presence of two adsorption/desorption processes in the general phenomenon. Equilibrium adsorption and desorption data have been properly fitted by a model consisting of a Langmuir plus quadratic term, which provides a good integrated description of the experimental data over a wide range of concentrations. At low concentrations, the Langmuir term explains the adsorption of LAS on soil sites which are highly selective of the n-alkyl groups and cover a very small fraction of the soil surface area, whereas the quadratic term describes adsorption on the much larger part of the soil surface and on LAS retained at moderate to high concentrations. Since adsorption/desorption phenomenon plays a major role in the LAS behavior in soils, relevant conclusions can be drawn from the obtained results.

Evaluation of Linear Alkylbenzene Sulfonate (LAS) behaviour in agricultural soil through laboratory continuous studies.

The behaviour of Linear Alkylbenzene Sulfonate (LAS) in agricultural soil is investigated in the laboratory using continuous-flow soil column studies in order to simultaneously analyze the three main underlying phenomena (adsorption/desorption, degradation and transport). The continuous-flow soil column experiments generated the breakthrough curves for each LAS homologue, C10, C11, C12 and C13, and by adding them up, for total LAS, from which the relevant retention, degradation and transport parameters could be estimated, after proposing adequate models. Several transport equations were considered, including the degradation of the sorbate in solution and its retention by soil, under equilibrium and non-equilibrium conditions between the sorbent and the sorbate. In general, the results obtained for the estimates of those parameters that were common to the various models studied (such as the isotherm slope, first order degradation rate coefficient and the hydrodynamic dispersion coefficient) were rather consistent, meaning that mass transfer limitations are not playing a major role in the experiments. These three parameters increase with the length of the LAS homologue chain. The study will provide the underlying conceptual framework and fundamental parameters to understand, simulate and predict the environmental behaviour of LAS compounds in agricultural soils.

A new procedure of determination of alcohol sulfates and alcohol ethoxysulfates in agricultural soils.

The number of analytical methodologies that focus in the determination of alcohol sulfates (AS) and alcohol ethoxysulfates (AES) in terrestrial environment is very limited. In the present work, a new methodology to improve the extraction and determination of AS and AES in agricultural soil samples has been developed. Prior to instrumental analysis, an extraction procedure using pressurized liquid extraction with methanol (PLE) was carried out in order to obtain the highest recoveries and improve sensitivity. The most influential variables affecting the PLE procedure were optimized. Then, the separation and quantification of analytes were performed by liquid chromatography coupled to tandem mass spectrometry (LC-MS/MS). The limits of detection (LOD) ranged from 0.03 to 0.08µgg(-1) for AS homologues and in the case of AES ethoxymers from 0.03 to 0.09µgg(-1) for AES-C12Ex and from 0.03 to 0.08µgg(-1) for AES-C14Ex. Matrix-matched calibration was used. Trueness was evaluated by using a spike recovery assay with spiked blank samples, and the recoveries ranged from 98.3% to 101.0% for AS and from 99.9% to 100.1% for AES. The method was satisfactorily applied in a field study designed to evaluate the environmental behavior of these compounds in agricultural soil.

Validation of a method for the determination of tributyltin in seawater by stir bar sorptive extraction-liquid chromatography tandem mass spectrometry.

The main objective of this work is to develop an accurate, sensitive, simple and cost-effective method for the determination of tributyltin species (as cationic form) in seawater at ultra-trace levels. The method is based on the use of stir bar sorptive extraction (SBSE) followed by solvent desorption and liquid chromatography tandem mass spectrometry (SD-LC-MS/MS (QqQ)) analysis, operating in positive electrospray ionisation (ESI) and in the selected reaction monitoring (SRM) mode. Extraction and LC-MS/MS parameters were accurately optimised to achieve the highest recoveries and to enhance the analytical characteristics of the method. The different parameters that affect the extraction procedure, the chromatographic and spectrometric conditions, and the surrogate selection were evaluated. In contrast with previously proposed methods, the proposed method involves a simplified sample treatment. Quality parameters such as linearity, accuracy in terms of trueness and precision, uncertainty and specificity were examined with good results. The evaluation of two surrogates (tri-n-propyltin chloride and tripentyltin chloride) was also carried out. The limit of detection (LOD) and limit of quantification (LOQ) obtained were 0.8 and 2.5 ngL(-1), respectively. Precision, expressed as relative standard deviation (%RSD), was lower than 16%, and the determination coefficient (R(2)) was higher than 0.990 with a residual deviation for each calibration point lower than ±25%. Mean recoveries were between 92% and 102%. The accuracy of the method was also studied by participating in an external proficiency testing scheme. After validation, the method was applied to the analysis of all tributyltin species found in natural seawater samples. The method meets the requirements of the United States Environmental Protection Agency (US-EPA).

UNE-EN ISO/IEC 17025:2005-accredited method for the determination of pesticide residues in fruit and vegetable samples by LC-MS/MS.

A rapid, simple and sensitive multi-residue method was developed and validated for the simultaneous quantification and confirmation of 69 pesticides in fruit and vegetables using liquid chromatography-tandem mass spectrometry (LC-MS/MS). The samples were extracted following the quick, easy, cheap, effective, rugged and safe method known as QuEChERS. Mass spectrometric conditions were individually optimised for each analyte in order to achieve maximum sensitivity in multiple reaction monitoring (MRM) mode. Using the developed chromatographic conditions, 69 pesticides can be separated in less than 17 min. Two selected reaction monitoring (SRM) assays were used for each pesticide to obtain simultaneous quantification and identification in one run. With this method in SRM mode, more than 150 pesticides can be analysed and quantified, but their confirmation is not possible in all cases according to the European regulations on pesticide residues. Nine common representative matrices (zucchini, melon, cucumber, watermelon, tomato, garlic, eggplant, lettuce and pepper) were selected to investigate the effect of different matrices on recovery and precision. Mean recoveries ranged from 70% to 120%, with relative standard deviations (RSDs) lower than 20% for all the pesticides. The proposed method was applied to the analysis of more than 2000 vegetable samples from the extensive greenhouse cultivation in the province of Almeria, Spain, during one year. The methodology combines the advantages of both QuEChERS and LC-MS/MS producing a very rapid, sensitive, accurate and reliable procedure that can be applied in routine analytical laboratories. The method was validated and accredited according to UNE-EN-ISO/IEC 17025:2005 international standard (accreditation number 278/LE1027).