Utilising the Nanozymatic Activity of Copper-Functionalised Mesoporous C3 N5 for Sensing Biomolecules.

Designing unique nanomaterials for the selective sensing of biomolecules is of significant interest in the field of nanobiotechnology. In this work, we demonstrated the synthesis of ordered Cu nanoparticle-functionalised mesoporous C3 N5 that has unique peroxidase-like nanozymatic activity for the ultrasensitive and selective detection of glucose and glutathione. A nano hard-templating technique together with the in-situ polymerisation and self-assembly of Cu and high N-containing CN precursor was adopted to introduce mesoporosity as well as high N and Cu content in mesoporous C3 N5 . Due to the ordered structure and highly dispersed Cu in the mesoporous C3 N5 , a large enhancement of the peroxidase mimetic activity in the oxidation of a redox dye in the presence of hydrogen peroxide could be obtained. Additionally, the optimised Cu-functionalised mesoporous C3 N5 exhibited excellent sensitivity to glutathione with a low detection limit of 2.0 ppm. The strong peroxidase activity of the Cu-functionalised mesoporous C3 N5 was also effectively used for the sensing of glucose with a detection limit of 0.4 mM through glucose oxidation with glucose oxidase. This unique Cu-functionalised mesoporous C3 N5 has the potential for detecting various molecules in the environment as well as for next-generation glucose and glutathione diagnostic devices.

Fluoride-assisted detection of glutathione by surface Ce3+/Ce4+ engineered nanoceria.

Nanoceria has evolved as a promising nanomaterial due to its unique enzyme-like properties, including excellent oxidase mimetic activity, which significantly increases in the presence of fluoride ions. However, this significant increase in oxidase activity has never been utilised as a signal enhancer for the detection of biological analytes partly because of the lack of understanding of the mechanism involved in this process. In this study, we show that the surface oxidation state of cerium ions plays a very crucial role in different enzymatic activities, especially the oxidase mimetic activity by engineering nanoceria with three different surface Ce4+/Ce3+ compositions. Using DFT calculations combined with Bader charge analysis, it is demonstrated that stoichiometric ceria registers a higher oxidase mimetic activity than oxygen-deficient ceria with a low Ce4+/Ce3+ ratio due to a higher charge transfer from a substrate, 3,3',5,5' tetramethylbenzidine (TMB), to the ceria surface. We also show that the fluoride ions can significantly increase the charge transfer from the TMB surface to ceria irrespective of the surface Ce4+/Ce3+ ratio. Using this knowledge, we first compare the fluoride sensing properties of nanoceria with high Ce4+ and mixed Ce4+/Ce3+ oxidation states and further demonstrate that the linear detection range of fluoride ions can be extended to 1-10 ppm for nanoceria with mixed oxidation states. Then, we also demonstrate an assay for fluoride assisted detection of glutathione, an antioxidant with elevated levels during cancer, using nanoceria with a high surface Ce4+/Ce3+ ratio. The addition of fluoride ions in this assay allows the detection of glutathione in the linear range of 2.5-50 ppm with a limit of detection (LOD) of 3.8 ppm. These studies not only underpin the role of the surface Ce4+/Ce3+ ratio in tuning the fluoride assisted boost in the oxidase mimetic activity of nanoceria but also its strategic application in designing better colourimetric assays.

Nanomaterials-based sensors for the detection of COVID-19: A review.

With the threat of increasing SARS-CoV-2 cases looming in front of us and no effective and safest vaccine available to curb this pandemic disease due to its sprouting variants, many countries have undergone a lockdown 2.0 or planning a lockdown 3.0. This has upstretched an unprecedented demand to develop rapid, sensitive, and highly selective diagnostic devices that can quickly detect coronavirus (COVID-19). Traditional techniques like polymerase chain reaction have proven to be time-inefficient, expensive, labor intensive, and impracticable in remote settings. This shifts the attention to alternative biosensing devices that can be successfully used to sense the COVID-19 infection and curb the spread of coronavirus cases. Among these, nanomaterial-based biosensors hold immense potential for rapid coronavirus detection because of their noninvasive and susceptible, as well as selective properties that have the potential to give real-time results at an economical cost. These diagnostic devices can be used for mass COVID-19 detection to understand the rapid progression of the infection and give better-suited therapies. This review provides an overview of existing and potential nanomaterial-based biosensors that can be used for rapid SARS-CoV-2 diagnostics. Novel biosensors employing different detection mechanisms are also highlighted in different sections of this review. Practical tools and techniques required to develop such biosensors to make them reliable and portable have also been discussed in the article. Finally, the review is concluded by presenting the current challenges and future perspectives of nanomaterial-based biosensors in SARS-CoV-2 diagnostics.

Tuning the enzyme-like activities of cerium oxide nanoparticles using a triethyl phosphite ligand.

Cerium oxide nanoparticles (CeNPs) exhibit excellent in vitro and in vivo antioxidant properties, determined by the redox switching of surface cerium ions between their two oxidation states (Ce3+ and Ce4+). It is known that ligands such as triethyl phosphite (TEP) can tune the redox behavior of CeNPs and change their biological enzyme-mimetic activities; however, the corresponding mechanism for such a behavior is completely unknown. Herein, we have studied the effect of TEP in promoting the SOD-enzyme-like activity in CeNPs with high and low Ce3+/Ce4+ ratio, which were synthesized by wet chemical and thermal hydrolysis methods, respectively, and incubated with varying concentrations of TEP. X-ray diffraction, UV-visible, photoluminescence, X-ray photoelectron spectroscopy, and Raman spectroscopy combined with DFT calculations were used to investigate the interaction of TEP on the surface of CeNPs. We observed a clear correlation between TEP concentration and the formation of surface oxygen vacancies. XPS analysis confirmed the increase in Ce3+ concentration after interaction with TEP. Moreover, we show that TEP's influence depends on the surface Ce3+/Ce4+ ratio. The superoxide dismutase-, catalase-, and oxidase-like activities of CeNPs with high Ce3+/Ce4+ ratio are not affected by TEP interaction, whereas catalase- and oxidase-like activities of CeNPs with low Ce3+/Ce4+ ratio decrease and the SOD-like activity is found to increase upon incubation with different concentrations of TEP. We also demonstrate that TEP interaction does not affect the regeneration of the CeNP surface, while the DFT calculations show that TEP facilitates the formation of defects on the surface of stoichiometric cerium oxide by reducing the oxygen vacancy formation energy. CeNPs with low Ce3+/Ce4+ ratio incubated with TEP also exhibited good antibacterial activity as compared to the CeNPs or TEP alone.

Egg-yolk core-shell mesoporous silica nanoparticles for high doxorubicin loading and delivery to prostate cancer cells.

Mesoporous silica-based nanoparticles (MSNs) have gained rapid interest as a drug delivery system (DDS) and demonstrated their versatility in delivering drugs for the treatment of various cancers. However, the drug loading efficiency of MSNs is low and is usually improved by improving textural properties through complicated synthesis methods or by post synthesis modification of the surface that can result in the loss of surface area and modify its drug release properties. In this study, we report a direct single-step synthesis of MSNs with a unique egg-yolk core-shell morphology, large pore volume and a hydrophilic surface, decorated with nitrogen rich surface functionalities for increasing its drug loading capacity. This combination of excellent textural properties and surface functionalisation was achieved by a simple soft templating method using dual surfactants and the silica sources assisted by employing either triethylamine (TEA) or triethanolamine (TEO) as the hydrolysis agent. The morphology and well-ordered mesoporous structure can simply be tuned by changing the pH of the synthesis medium that affects the self-assembly mechanism of the micelles. HRTEM image of samples clearly revealed an egg-yolk core-shell morphology with a thin mesoporous silica shell. The optimised MSN samples synthesized at a pH of 11 using either TEA or TEO depicted a higher doxorubicin (Dox) loading capacity of 425 µg mg-1 and 481 µg mg-1 respectively, as compared to only 347 µg mg-1 for MSN samples due to the uniform distribution of nitrogen functionalities. The anticancer activity of Dox loaded MSNs evaluated in two different prostate cancer cell lines (PC-3 and LNCaP) showed a higher cytotoxicity of the drug loaded on optimised MSN samples as compared to pristine MSNs without affecting the cellular uptake of the particles. These results suggest that the unique single-step synthesis and functionalisation method resulted in successfully achieving higher drug loading in egg-yolk core-shell nitrogen functionalised MSNs and could be implemented as an effective carrier of chemotherapeutic drugs.

Unusual Stability and Catalytic Activity of Gold Nanoparticles in Polyoxyethylene Cholesteryl Ether.

We report a simple and spontaneous method for creation of extremely stable and catalytically active gold nanoparticles (AuNPs) from polyoxyethylene cholesteryl ether (ChEO15) and sodium tetrachloroaurate (III) dihydrate (Na[AuCl4] · 2H2O). AuNPs with uniform size and distribution were prepared at 27 °C (AuNPs were formed in <3 h) and at 50 °C (AuNPs were formed in <1 h). Our elucidations propose that creation of well-defined AuNPs is assisted by reductive ChEO15 surfactant solution via complexation and in-situ reduction of AuCl-4 ions in which ChEO15 acts both as a reducing and consequently a stabilizing (capping) moiety. AuNPs size can be altered by suitably choosing the Au precursor concentration. The resulting AuNPs reveal outstanding catalytic activity for conversion of nitrophenols to aminophenol in the presence of NaBH4 and also exhibit synthetic peroxidase-like activity. This simple yet effective synthesis technique opens prospect for creation of stable and active AuNPs.

Ligand-mediated reversal of the oxidation state dependent ROS scavenging and enzyme mimicking activity of ceria nanoparticles.

Nanoceria is considered as a potent antioxidant (free radical scavenger) and its enzymatic activity is reported to be a function of the oxidation state of surface cerium ions. Here we demonstrate phosphine ligand-dependent enzymatic activity of nanoceria irrespective of its as-synthesized oxidation state.