RESUMEN
Over the past decade, metasurfaces (MTSs) have emerged as a highly promising platform for the development of next-generation, miniaturized, planar devices across a wide spectrum of microwave frequencies. Among their various applications, the concept of MTS-based antennas, particularly those that are based on surface wave excitation, represents a groundbreaking advancement with significant implications for communication technologies. However, existing literature primarily focuses on MTS configurations printed on traditional substrates, largely overlooking the potential benefits of employing photosensitive substrates. This paper endeavors to pioneer this novel path. We present a specialized design of a modulated MTS printed on a silicon substrate, which acts as a photosensitive Ka-band surface wave antenna. Remarkably, the gain of this antenna can be time-modulated, achieving a variance of up to 15 dB, under low-power (below 1 W/cm²) optical illumination at a wavelength of 971 nm. This innovative approach positions the antenna as a direct transducer, capable of converting an optically modulated signal into a microwave-modulated radiated signal, thus offering a new dimension in antenna technology and functionality.
RESUMEN
We study the behavior of Fabry-Perot micro-optical resonators based on cylindrical reflectors, optionally combined with cylindrical lenses. The core of the resonator architecture incorporates coating-free, all-silicon, Bragg reflectors of cylindrical shape. The combined effect of high reflectance and light confinement produced by the reflectors curvature allows substantial reduction of the energy loss. The proposed resonator uses curved Bragg reflectors consisting of a stack of silicon-air wall pairs constructed by micromachining. Quality factor Q ~1000 was achieved on rather large cavity length L = 210 microns, which is mainly intended to lab-on-chip analytical experiments, where enough space is required to introduce the analyte inside the resonator. We report on the behavioral analysis of such resonators through analytical modeling along with numerical simulations supported by experimental results. We demonstrate selective excitation of pure longitudinal modes, taking advantage of a proper control of mode matching involved in the process of coupling light from an optical fiber to the resonator. For the sake of comparison, insight on the behavior of Fabry-Perot cavity incorporating a Fiber-Rod-Lens is confirmed by similar numerical simulations.