RESUMEN
Mixed-mode chromatography was investigated for the purification of the recombinant allergen rBet v 1a expressed in Escherichia coli (E. coli) and used as an active principle for specific immunotherapy (SIT) treatment against birch pollen allergy. The screening of micro-volumes of three mixed-mode sorbents established that rBet v 1a could be captured without any pre-treatment of the crude feedstock on HEA or PPA HyperCel sorbents equilibrated in "physiological-like" conditions. On a mini-column pre-packed with PPA HyperCel sorbent, rBet v 1a was recovered at pH 4, partially separated from a major methionine Bet v 1 contaminant and purified approximately 9-fold in a single step (85% purity).
Asunto(s)
Alérgenos/aislamiento & purificación , Betula/química , Cromatografía Liquida/métodos , Polen/química , Resinas Sintéticas/química , Alérgenos/química , Alérgenos/genética , Cromatografía Liquida/instrumentación , Humanos , Proteínas Recombinantes/química , Proteínas Recombinantes/genética , Proteínas Recombinantes/aislamiento & purificación , Rinitis Alérgica Estacional/inmunologíaRESUMEN
Protein purification development is the bottleneck of recombinant protein production therefore there is a need to shorten process development and monitoring. Surface enhanced laser desorption/ionization-mass spectrometry (SELDI-MS) was evaluated to optimize the expression and to develop the purification of a recombinant mouse protein: a transmembrane adaptor involved in T cell receptor signaling named "linker for activation of T cells" (LAT). The protein was expressed as a soluble form (S-LAT) in three strains of Escherichia coli: BL21 (DE3), Rosetta (DE3), and BL21 (DE3) pLys S. The expression of S-LAT was monitored on immobilized metal affinity chromatography (IMAC) ProteinChip arrays. The highest level of expression was found in Rosetta (DE3) with a C-terminal construct after induction at 37 degrees C. The purification scheme was elucidated using SELDI-MS: S-LAT was efficiently captured on an IMAC ProteinChip array saturated with nickel ions (Ni(2+)) and then fractionated on a Q ProteinChip array. These conditions were directly transferred to IMAC-Ni(2+) HyperCel and Q Ceramic HyperD F chromatography sorbents. After these two purification steps, S-LAT was estimated to be more than 80% pure, confirming a very good match between array and sorbent. Finally, a peptide mapping was performed on a hydrophobic array after in gel trypsin digest, verifying that the purified protein was the mouse LAT. This is the first report of a protocol for the production and purification of S-LAT. The selection of the best expression and purification strategy along with the identification were enabled in 5 days with less than 5 mL of soluble fraction of crude culture samples.
Asunto(s)
Proteínas Adaptadoras Transductoras de Señales/biosíntesis , Proteínas Adaptadoras Transductoras de Señales/aislamiento & purificación , Escherichia coli , Proteínas de la Membrana/biosíntesis , Proteínas de la Membrana/aislamiento & purificación , Fosfoproteínas/biosíntesis , Fosfoproteínas/aislamiento & purificación , Proteínas Recombinantes/biosíntesis , Proteínas Recombinantes/aislamiento & purificación , Proteínas Adaptadoras Transductoras de Señales/química , Animales , Cromatografía Liquida , Proteínas de la Membrana/química , Ratones , Mapeo Peptídico , Fosfoproteínas/química , Análisis por Matrices de Proteínas , Ingeniería de Proteínas , Proteínas Recombinantes/química , Espectrometría de Masa por Láser de Matriz Asistida de Ionización DesorciónRESUMEN
A synthetic ligand called 2-mercapto-5-benzimidazolesulfonic acid has been successfully used for the specific chromatographic capture of antibodies from a cell culture supernatant. Adsorption occurred at physiological ionic strength and pH range between 5.0 and 6.0, with some binding capacity variations within this pH range: antibody uptake increased when the pH decreased. With very dilute feedstocks, as was the case with the cell culture supernatant under investigation, it was found that the pH had to be slightly lowered to get a good antibody sorption capacity. To optimize separation conditions, a preliminary study was made using ProteinChip Arrays that displayed the same chemical functionalities as the resin. Arrays were analyzed using SELDI-MS. By this mean, it was possible to cross-over simultaneously different pH conditions at the adsorption and the desorption steps. Best conditions were implemented for preparative separation using regular lab-scale columns. At pH 5.2, antibody adsorption was not complete, while at pH 5.0 the antibody was entirely captured. pH 9 was selected at elution, rather than pH 8.0 or 10.0, and resulted in a complete desorption of antibodies from the column. Benefits of the prediction of separation conditions of antibodies on MBI beads using SELDI-MS were a significant reduction in analysis time and in sample volume. This was possible because the separation of IgG on the chip surface did mimic very well the separation on beads.