The performance of perovskite solar cells (PSCs) can be improved by optimizing the perovskite film quality and electron transfer layers (ETLs). In this study, high-efficient PSCs with multi-cation hybrid electron transport layer (SnO2@Na:Cs ETL) were fabricated using continuous spin-coating. Compared to the pristine SnO2, the power conversion efficiency (PCE) of device based on SnO2@Na:Cs ETL have reached 22.06% (with an open circuit voltage of 1.13 V), up approximately 21%. The photovoltaic performance of the device is enhanced due to the increase in the transmission rate, electrical conductivity, electron mobility and surface state owing to the multi-cation hybrid. In addition, because SnO2@Na:Cs ETL can significantly improve interface contact with the perovskite film and improve its crystallinity, the transport defect state and carrier transport efficiency are significantly improved at the ETL/Perovskite interface. Therefore, the open circuit voltage (Voc) and fill factor (FF) of PSCs was significantly increased. The application of SnO2@Na:Cs ETL provides a simple and efficient method to obtain highly-efficient PSCs.
Perovskite solar cells (PSCs) have become a promising photovoltaic (PV) technology. Meanwhile, developing an electron transport layer (ETL) has been an effective way to promote the power conversion efficiency (PCE) of PSCs. Here, a 4-morpholine ethane sulfonic acid sodium salt (MES Na+) doped SnO2 ETL is utilized in planar heterojunction PSCs. The results show that the MES Na+ doped ETL can improve the crystallinity, and absorbance of perovskite films, and passivate interface defects between the perovskite film and SnO2 ETL. The doping effect accounts for the enhancement of conductivity and the decreasing work function of SnO2. When 10 mg mL-1 MES Na+ was added to the SnO2 precursor solution, the device showed the best performance Jsc, Voc, and FF of the PSCs values, which were 23.88 mA cm-2, 1.12 V and 78.69%, respectively, and the PCE was increased from 17.43% to 21.05%. This doping ETL strategy provides an avenue for defect passivation to further increase the efficiency of perovskite solar cells.
