Bile duct cancer is the second most common primary liver cancer, with most diagnoses occurring in the advanced stages. This leads to a poor survival rate, which means a technique capable of reliably detecting pre-cancer in the bile duct is urgently required. Unfortunately, radiological imaging lacks adequate accuracy for distinguishing dysplastic and benign biliary ducts, while endoscopic techniques, which can directly assess the bile duct lining, often suffer from insufficient sampling. Here, we report an endoscopic optical light scattering technique for clinical evaluation of the malignant potential of the bile duct. This technique employs an ultraminiature spatial gating fiber optic probe compatible with cholangioscopes and endoscopic retrograde cholangiopancreatography (ERCP) catheters. The probe allowed us to investigate the internal cellular composition of the bile duct epithelium with light scattering spectroscopy (LSS) and phenotypic properties of the underlying connective tissue with diffuse reflectance spectroscopy (DRS). In a pilot in vivo double-blind prospective study involving 29 patients undergoing routine ERCP procedures, the technique detected malignant transformation with 97% accuracy, showing that biliary duct pre-cancer can be reliably identified in vivo non-invasively.
Bile Duct Neoplasms , Cholangiocarcinoma , Humans , Prospective Studies , Cholangiopancreatography, Endoscopic Retrograde/methods , Bile Ducts/diagnostic imaging , Bile Duct Neoplasms/diagnostic imaging , Bile Ducts, Intrahepatic , Spectrum Analysis
The mirror tunnel is a component used to extend the depth of focus for compact imaging probes used in endoscopic optical coherence tomography (OCT). A fast and accurate method for mirror tunnel probe simulation, characterization, and optimization is needed, with the aim of reconciling wave- and ray-optics simulation methods and providing a thorough description of the physical operating principle of the mirror tunnel. BeamLab software, employing the beam propagation method, was used to explore the parameter space and quantify lateral resolution and depth of focus extension. The lateral resolution performance was found to depend heavily on the metric chosen, implying that care should be taken in the interpretation of optimization and simulation results. Interpreting the mirror tunnel exit face as an extended object gives an understanding of the probe operation, decoupling it from the focusing optics and potentially helping to reduce the parameter space for future optimization.
Lenses , Tomography, Optical Coherence , Endoscopy , Equipment Design , Optics and Photonics , Tomography, Optical Coherence/methods
The observation of biological structures in live cells beyond the diffraction limit with super-resolution fluorescence microscopy is limited by the ability of fluorescence probes to permeate live cells and the effect of these probes, which are often toxic, on cellular behavior. Here we present a coherent confocal light scattering and absorption spectroscopic microscopy that for the first time enables the use of large numerical aperture optics to characterize structures in live cells down to 10 nm spatial scales, well beyond the diffraction limit. Not only does this new capability allow high resolution microscopy with light scattering contrast, but it can also be used with almost any light scattering spectroscopic application which employs lenses. We demonstrate that the coherent light scattering contrast based technique allows continuous temporal tracking of the transition from non-cancerous to an early cancerous state in live cells, without exogenous markers. We also use the technique to sense differences in the aggressiveness of cancer in live cells and for label free identification of different grades of cancer in resected tumor tissues.
OCT tethered capsule endomicroscopy (TCE) is an emerging noninvasive diagnostic imaging technology for gastrointestinal (GI) tract disorders. OCT measures tissue reflectivity that provides morphologic image contrast, and thus is incapable of ascertaining molecular information that can be useful for improving diagnostic accuracy. Here, we introduce an extension to OCT TCE that includes a fluorescence (FL) imaging channel for attaining complementary, co-registered molecular contrast. We present the development of an OCT-FL TCE capsule and a portable, plug-and-play OCT-FL imaging system. The technology is validated in phantom experiments and feasibility is demonstrated in a methylene blue (MB)-stained swine esophageal injury model, ex vivo and in vivo.
Organoids formed from human induced pluripotent stem cells (hiPSCs) could be a limitless source of functional tissue for transplantations in many organs. Unfortunately, fine-tuning differentiation protocols to form large quantities of hiPSC organoids in a controlled, scalable, and reproducible manner is quite difficult and often takes a very long time. Recently, we introduced a new approach of rapid organoid formation from dissociated hiPSCs and endothelial cells using microfabricated cell-repellent microwell arrays. This approach, when combined with real-time label-free Raman spectroscopy of biochemical composition changes and confocal light scattering spectroscopic microscopy of chromatin transition, allows for monitoring live differentiating organoids without the need to sacrifice a sample, substantially shortening the time of protocol fine-tuning. We used this approach to both culture and monitor homogeneous liver organoids that have the main functional features of the human liver and which could be used for cell transplantation liver therapy in humans.
Induced Pluripotent Stem Cells , Organoids , Cell Differentiation , Chromatin , Endothelial Cells , Humans , Microscopy
Pancreatic cancer has one of the worst survival rates of all major cancers, with pancreatic cystic lesions accounting for one in three pancreatic surgeries. The current gold-standard for diagnosis of pancreatic cyst malignancy is based on the endoscopic ultrasound guided fine-needle aspiration (EUS-FNA) procedure, which suffers from a low accuracy in detecting malignancy. Here we present the design and two-photon polymerization based fabrication of refractive and reflective non-contact probes, capable of rapid surveillance of the entire internal cyst surface-an advance over the contact probe we recently developed that allowed, for the first time, reliable evaluation of pancreatic cyst malignant potential in vivo. We employed a novel two-photon polymerization technique, which allows direct laser-writing to an accuracy of tens of nanometers, to fit the probe within the 540 micrometer internal diameter EUS-FNA needle. The newly constructed probes show excellent separation of the illumination and collection beams, essential for proper operation of the spatial gating method. These probes can be used clinically to perform rapid "optical biopsy", ultimately eliminating unnecessary pancreatic surgeries on benign cysts and dangerous delays in surgical removal of malignant cysts, improving patient prognosis and quality of life.
Extended depth of field (EDoF) imaging remains desirable in the consumer market due to its reduced cost through omission of refocusing hardware. This paper describes the study of a heated plastic plate and its effect on EDoF imaging. It is shown that the depth of field of an imaging device can be extended by heating either the periphery or core of a homogeneous element-solving the heat equation for a parallel plate generates a radial gradient index structure, which can be modeled in Zemax ray-tracing software. For an F/2 system with the dimensions of a typical mobile-device camera, the heating arrangement shifts the peak value of the modulation transfer function (MTF) at Nyquist/2 from object distance 1350 to 750 mm. This study suggests the possibility of a fixed-focus camera with distinct modes: a "high-quality" mode operational over the standard depth of field when the plate is not heated; a "macro" mode triggered by heating the plate periphery; and a "wide-focus" mode triggered by heating the lens core. Importantly, the reduction in MTF generally associated with EDoF solutions is not present when the plate is unheated. The plate, having no optical power when unheated, can be added to existing off-the-shelf lens designs. Such a heating arrangement could provide a very-low-cost refocusing alternative where moving parts are not desirable.
The accommodating volume-constant age-dependent optical (AVOCADO) model of the crystalline lens is used to explore the age-related changes in ocular power and spherical aberration. The additional parameter m in the GRIN lens model allows decoupling of the axial and radial GRIN profiles, and is used to stabilise the age-related change in ocular power. Data for age-related changes in ocular geometry and lens parameter P in the axial GRIN profile were taken from published experimental data. In our age-dependent eye model, the ocular refractive power shows behaviour similar to the previously unexplained "lens paradox". Furthermore, ocular spherical aberration agrees with the data average, in contrast to the proposed "spherical aberration paradox". The additional flexibility afforded by parameter m, which controls the ratio of the axial and radial GRIN profile exponents, has allowed us to study the restructuring of the lens GRIN medium with age, resulting in a new interpretation of the origin of the power and spherical aberration paradoxes. Our findings also contradict the conceptual idea that the ageing eye is similar to the accommodating eye.
The purpose of this manuscript is to introduce a new age-dependent model of the human lens with two GRIN power distributions (axial and radial) that allow decoupling of its refractive power and axial optical path length. The aspect ratio of the lens core can be held constant under accommodation, as well as the lens volume by varying the asphericity of the lens external surfaces. The spherical aberration calculated by exact raytracing is shown to be in line with experimental data. The proposed model is compared to previous GRIN models from the literature, and it is concluded that the features of the new model will be useful for GRIN reconstruction in future experimental studies; in particular, studies of the accommodation-dependent properties of the ageing human eye. A proposed logarithmic model of the lens core enables decoupling of three fundamental optical characteristics of the lens, namely axial optical path length, optical power and third-order spherical aberration, without changing the external shape of the lens. Conversely, the near-surface GRIN structure conforms to the external shape of the lens, which is necessary for accommodation modelling.
We present an analytical method to describe the accommodative changes in the human crystalline lens. The method is based on the geometry-invariant lens model, in which the gradient-index (GRIN) iso-indicial contours are coupled to the external shape. This feature ensures that any given number of iso-indicial contours does not change with accommodation, which preserves the optical integrity of the GRIN structure. The coupling also enables us to define the GRIN structure if the radii and asphericities of the external lens surfaces are known. As an example, the accommodative changes in lenticular radii and central thickness were taken from the literature, while the asphericities of the external surfaces were derived analytically by adhering to the basic physical conditions of constant lens volume and its axial position. The resulting changes in lens geometry are consistent with experimental data, and the optical properties are in line with expected values for optical power and spherical aberration. The aim of the paper is to provide an anatomically and optically accurate lens model that is valid for 3 mm pupils and can be used as a new tool for better understanding of accommodation.
