High-density grids for efficient data collection from multiple crystals.

Higher throughput methods to mount and collect data from multiple small and radiation-sensitive crystals are important to support challenging structural investigations using microfocus synchrotron beamlines. Furthermore, efficient sample-delivery methods are essential to carry out productive femtosecond crystallography experiments at X-ray free-electron laser (XFEL) sources such as the Linac Coherent Light Source (LCLS). To address these needs, a high-density sample grid useful as a scaffold for both crystal growth and diffraction data collection has been developed and utilized for efficient goniometer-based sample delivery at synchrotron and XFEL sources. A single grid contains 75 mounting ports and fits inside an SSRL cassette or uni-puck storage container. The use of grids with an SSRL cassette expands the cassette capacity up to 7200 samples. Grids may also be covered with a polymer film or sleeve for efficient room-temperature data collection from multiple samples. New automated routines have been incorporated into the Blu-Ice/DCSS experimental control system to support grids, including semi-automated grid alignment, fully automated positioning of grid ports, rastering and automated data collection. Specialized tools have been developed to support crystallization experiments on grids, including a universal adaptor, which allows grids to be filled by commercial liquid-handling robots, as well as incubation chambers, which support vapor-diffusion and lipidic cubic phase crystallization experiments. Experiments in which crystals were loaded into grids or grown on grids using liquid-handling robots and incubation chambers are described. Crystals were screened at LCLS-XPP and SSRL BL12-2 at room temperature and cryogenic temperatures.

MAD phasing with krypton.

Experiments demonstrating the feasibility of Kr-edge MAD on frozen crystals as a routine method for structure determination are reported. Approximately 50% of protein crystals can be successfully derivatized by pressurization with the noble gases xenon or krypton. While Xe has produced many useful derivatives for MIR phasing over the last several years, the Xe edges (K edge = 34.6 keV, L(I) = 5.5 keV) are not easily accessible for MAD studies. As the Kr K edge (14.3 keV) is accessible on most MAD beamlines, Kr derivatization provides the additional opportunity to conduct a MAD experiment and obtain phases using only a single crystal. This paper describes the phasing of two proteins using Kr MAD: the 17 kDa Fe protein myoglobin (Mb) from sperm whale (Physeter catodon) and an 18 kDa protein (SP18) from green abalone (Haliotis fulgens). Three-wavelength data were collected at SSRL beamline 9-2 from crystals of Mb and SP18 incubated in 2.76 MPa of Kr gas for 2 min, depressurized and then flash-frozen in a stream of nitrogen gas at 100 K. MAD phases were calculated using the program SHARP and the resulting density improved with wARP. The final maps for both Mb and SP18 were of excellent quality.

Structure of a thioredoxin-like [2Fe-2S] ferredoxin from Aquifex aeolicus.

The 2.3 A resolution crystal structure of a [2Fe-2S] cluster containing ferredoxin from Aquifex aeolicus reveals a thioredoxin-like fold that is novel among iron-sulfur proteins. The [2Fe-2S] cluster is located near the surface of the protein, at a site corresponding to that of the active-site disulfide bridge in thioredoxin. The four cysteine ligands are located near the ends of two surface loops. Two of these ligands can be substituted by non-native cysteine residues introduced throughout a stretch of the polypeptide chain that forms a protruding loop extending away from the cluster. The presence of homologs of this ferredoxin as components of more complex anaerobic and aerobic electron transfer systems indicates that this is a versatile fold for biological redox processes.

The 0.78 A structure of a serine protease: Bacillus lentus subtilisin.

Ultrahigh-resolution X-ray diffraction data from cryo-cooled, B. lentus subtilisin crystals has been collected to a resolution of 0.78 A. The refined model coordinates have a rms deviation of 0.22 A relative to the same structure determined at room temperature and 2.0 A resolution. Several regions of main-chain and side-chain disorder have been identified for 21 out of 269 residues in one polypeptide chain. Hydrogen atoms appear as significant peaks in the Fo - Fc difference electron density map, and carbon, nitrogen, and oxygen atoms can be differentiated. The estimated standard deviation (ESD) for all main-chain non-hydrogen bond lengths is 0.009 A and 0.5 degrees for bond angles based on an unrestrained full-matrix least-squares refinement. Hydrogen bonds are resolved in the serine protease catalytic triad (Ser-His-Asp). Electron density is observed for an unusual, short hydrogen bond between aspartic acid and histidine in the catalytic triad. The hydrogen atom, identified by NMR in numerous serine proteases, appears to be shared by the heteroatoms in the bond. This represents the first reported correlation between detailed chemical features identified by NMR and those in a cryo-cooled crystallographic structure determination at ultrahigh resolution. The short hydrogen bond, designated "catalytic hydrogen bond", occurs as part of an elaborate hydrogen bond network, involving Asp of the catalytic triad. While unusual, these features appear to have conserved analogues in other serine protease families although specific details differ from family to family.

Structure at 0.85 A resolution of an early protein photocycle intermediate.

Protein photosensors from all kingdoms of life use bound organic molecules, known as chromophores, to detect light. A specific double bond within each chromophore is isomerized by light, triggering slower changes in the protein as a whole. The initial movements of the chromophore, which can occur in femtoseconds, are tightly constrained by the surrounding protein, making it difficult to see how isomerization can occur, be recognized, and be appropriately converted into a protein-wide structural change and biological signal. Here we report how this dilemma is resolved in the photoactive yellow protein (PYP). We trapped a key early intermediate in the light cycle of PYP at temperatures below -100 degrees C, and determined its structure at better than 1 A resolution. The 4-hydroxycinnamoyl chromophore isomerizes by flipping its thioester linkage with the protein, thus avoiding collisions resulting from large-scale movement of its aromatic ring during the initial light reaction. A protein-to-chromophore hydrogen bond that is present in both the preceding dark state and the subsequent signalling state of the photosensor breaks, forcing one of the hydrogen-bonding partners into a hydrophobic pocket. The isomerized bond is distorted into a conformation resembling that in the transition state. The resultant stored energy is used to drive the PYP light cycle. These results suggest a model for phototransduction, with implications for bacteriorhodopsin, photoactive proteins, PAS domains, and signalling proteins.

Light-induced structural changes in photosynthetic reaction center: implications for mechanism of electron-proton transfer.

High resolution x-ray diffraction data from crystals of the Rhodobacter sphaeroides photosynthetic reaction center (RC) have been collected at cryogenic temperature in the dark and under illumination, and the structures were refined at 2.2 and 2.6 angstrom resolution, respectively. In the charge-separated D+QAQB- state (where D is the primary electron donor (a bacteriochlorophyll dimer), and QA and QB are the primary and secondary quinone acceptors, respectively), QB- is located approximately 5 angstroms from the QB position in the charge-neutral (DQAQB) state, and has undergone a 180 degrees propeller twist around the isoprene chain. A model based on the difference between the two structures is proposed to explain the observed kinetics of electron transfer from QA-QB to QAQB- and the relative binding affinities of the different ubiquinone species in the QB pocket. In addition, several water channels (putative proton pathways) leading from the QB pocket to the surface of the RC were delineated, one of which leads directly to the membrane surface.

Redox-dependent structural changes in the nitrogenase P-cluster.

The structure of the nitrogenase MoFe-protein from Azotobacter vinelandii has been refined to 2.0 A resolution in two oxidation states. EPR studies on the crystals indicate that the structures correspond to the spectroscopically assigned oxidized (P(OX)/M(OX)) and the native or dithionite-reduced (P(N)/M(N)) forms of the enzyme. Both MoFe-protein structures are essentially identical, with the exception of the P-cluster. The MoFe-protein P-cluster in each state is found to contain eight Fe and seven S atoms. Interconversion between the two redox states involves movement of two Fe atoms and an exchange of protein coordination for ligands supplied by a central S atom. In the oxidized P(OX) state, the cluster is coordinated by the protein through six cysteine ligands, Ser-beta188 O gamma, and the backbone amide of Cys-alpha88. In the native P(N) state, Ser-beta188 O gamma and the amide N of Cys-alpha88 no longer coordinate the cluster due to movement of their coordinated Fe atoms toward the central sulfur. Consequently, this central sulfur adopts a distorted octahedral environment with six surrounding Fe atoms. A previously described model of the P-cluster containing 8Fe-8S likely reflects the inappropriate modeling of a single structure to a mixture of these two P-cluster redox states. These observed redox-mediated structural changes of the P-cluster suggest a role for this cluster in coupling electron transfer and proton transfer in nitrogenase.

Laue diffraction study on the structure of cytochrome c peroxidase compound I.

BACKGROUND: Cytochrome c peroxidase from yeast is a soluble haem-containing protein found in the mitochondrial electron transport chain where it probably protects against toxic peroxides. The aim of this study was to obtain a reliable structure for the doubly oxidized transient intermediate (termed compound I) in the reaction of cytochrome c peroxidase with hydrogen peroxide. This intermediate contains a semistable free radical on Trp191, and an oxyferryl haem group. RESULTS: Compound I was produced in crystals of yeast cytochrome c peroxidase by reacting the crystalline enzyme with hydrogen peroxide in a flow cell. The reaction was monitored by microspectrophotometry and Laue crystallography in separate experiments. A nearly complete conversion to compound I was achieved within two minutes of the addition of hydrogen peroxide, and the concentration of the intermediate remained at similar levels for an additional half an hour. The structure of the intermediate was determined by Laue diffraction. The refined Laue structure for compound I shows clear structural changes at the peroxide-binding site but no significant changes at the radical site. The photographs were processed with a new software package (LEAP), overcoming many of the former problems encountered in extracting structural information from Laue exposures. CONCLUSIONS: The geometry of the haem environment in this protein allows structural changes to be extremely small, similar in magnitude to those observed for the Fe2+/Fe3+ transition in cytochrome c. The results suggest that these molecules have evolved to transfer electrons with a minimal need for structural adjustment.