Insitu synthesis of Al- MgAl2O4 composites and parametric optimization of tribological characteristics.

In this research, multiobjective optimization of tribological characteristics of Al-4Mg/in-situ MgAl2O4 composites fabricated via ultrasonic cavitation treatment assisted stir casting technique was carried out. Al-4Mg alloy dispersed with 0.5, 1 and 2 wt% in-situ MgAl2O4 was prepared and the microstructural and mechanical characterisation of the same has been carried out. Reinforcement addition, load and sliding velocity at 3 different levels was considered to attain the responses wear rate and friction coefficient. To identify optimised process condition for the developed composites to attain reduced friction coefficient and wear rate condition, grey analysis is tried out. Experimental results analysed via Grey relation and analysis of variance (ANOVA) proved wt.% of MgAl2O4 particles as significant parameter trailed by load and speed. Based on grey relational grade, minimal wear loss at lowest frictional coefficient can be attained for the composite dispersed with 2 wt% of in-situ MgAl2O4 at 20 N load and 2 m/s sliding velocity. Mechanisms behind the wear loss was analysed from worn out surface micrographs.

Optimizing the selection of natural fibre reinforcement and polymer matrix for plastic composite using LS-SVM technique.

The manufacturing sector is paying close attention to plastic matrix composites (PMCs) reinforced with natural fibres for improving their products. Due to the fact that PMC reinforced with naturally occurring fibres is more affordable and has superior mechanical qualities. Based on the application material requirements, An important step in the production of PMC is choosing the right natural fibres for reinforcing and determining how much of each. This investigation aimed that Artificial Intelligence (AI) or soft computing based approaches are used to determine the right amount of natural fibres in PMCs to make the manufacturing process simpler. However, techniques in the literature are not concentrated on finding suitable material. Hence in this investigation, a local search with support vector machine (LS-SVM) optimization technique is proposed for the optimal selection of appropriate proportions of suitable fibres. Modelling of the Proposed LS-SVM Optimization was demonstrated. In this proposed technique around four kinds of polymers/plastics and 14 natural fibres are considered, which are optimized in various proportions. The optimization performance is evaluated based on the tensile strength, flexural yield strength and flexural yield modulus. The proposed LS-SVM Optimization was evacuated by developing solutions for medical applications (Case 1), Transportation applications (Case 2) and other notable applications (Case 3) in terms of tensile and flexural properties of the material. The maximum flexure stress in case 1, case 2, and case 3 is observed as 53 MPa, 45 MPa and 26 MPa respectively. Similarly, the maximum flexure stress in case 1, case 2, and case 3 is observed as 53 MPa, 45 MPa and 26 MPa respectively. Hence the proposed method recommended for choosing optimal decision on the choice of fiber and their quantity in the composite matrix.