RESUMEN
Block copolymers based on ethylene (E) and butadiene (B) were prepared using the ansa-bis(fluorenyl) complex {Me2 Si(C13 H8 )2 Nd(BH4 )2 Li(THF)}2 in combination with (n-Bu)(n-Oct)Mg (BOMAG) as a chain-transfer agent. The diblock copolymers incorporating a soft poly(ethylene-co-butadiene) segment, called ethylene butadiene rubber (EBR), and a hard polyethylene (PE) one were obtained by simply adjusting the different feeds of monomers during the polymerization. The soluble EBR block was formed first by feeding the catalytic system dissolved in toluene at 70 °C with a mixture of ethylene and butadiene (E/B molar ratio 80 : 20). Then the feeding was stopped leading to the consumption of a large part of the residual monomers. The reactor was finally fed with ethylene to form the PE block. By varying the molar mass of the latter, it is shown that the resulting soft-b-hard block copolymers can self-assemble simultaneously to the growth of the PE block in agreement with a polymerization-induced self-assembly (PISA) mechanism. The self-assembly is discussed considering the reaction conditions, the crystallization of the PE block, and the polymerization mechanism involved.
RESUMEN
Anionic polymerization of butadiene or/and styrene is performed with lithium initiators, functional or not. The polymer chains are subsequently transferred to magnesium. The resulting polymeryl-magnesium compounds were combined with {(Me2 Si(C13 H8 )2 )Nd(µ-BH4 )[(µ-BH4 )Li(THF)]}2 metallocene complex to act as macromolecular chain transfer agents (macroCTAs) in coordinative chain transfer polymerization (CCTP) of ethylene (E) or its copolymerization (CCTcoP) with butadiene (B). Block copolymers were produced for the first time by this switch from anionic polymerization to CCTP. Hard and soft blocks such as PB, polystyrene (PS), poly(styrene-co-butadiene) (SBR) obtained by anionic polymerization and PE or poly(ethylene-co-butadiene) (EBR) produced by CCT(co)P were combined and the corresponding structures were characterized.