Pre-Slaughter Stunning Methods Influence the Meat Quality of Arapaima gigas Fillets.

The aim of this study was to evaluate the influence of different stunning methods on the meat quality of Arapaima gigas fillets from fish farming. A total of 48 specimens of A. gigas in the weight class 11.1 to 14.0 kg were investigated; these fish were subjected to different stunning methods for slaughter: ice asphyxia (IA), air asphyxia (AA), electronarcosis (EE) and hypothermia followed by bleeding (HB). Then, data were obtained from the analysis of pH, rigor mortis index (RI), water activity (Aw), instrumental texture (compression strength, firmness and adhesiveness) and blood glucose and via instrumental colourimetry. During the study, for up to 15 days of refrigerated storage, the methods provided pH values below 6.0. A. gigas submitted to EE and HB remained longer in the pre-rigor status. In addition, they expressed lower percentages of Aw. The EE method resulted in better texture assignments in the fillets. The blood glucose values indicated that the fish subjected to EE were less stressed. Concerning instrumental colourimetry, the fillets submitted to EE and HB showed greater luminosity; the fillets subjected to AA showed greater red-green colour intensity, while the fillets subjected to EE showed greater yellow-blue colour intensity. Therefore, the fish did not suffer stress with electronarcosis, and the fillets showed better preservation, juiciness, and tenderness.

Monitoring of Mycotoxigenic Fungi in Fish Farm Water and Fumonisins in Feeds for Farmed Colossoma macropomum.

This study aimed to evaluate the occurrence of mycotoxigenic fungi in fish farm water and mycotoxins in feeds for farmed tambaqui (Colossoma macropomum). A total of 40 samples of freshwater from fish farms and 16 samples of feed were collected and analyzed for microbiology. A total of five species of free-living fungi were identified in fish farms: Aspergillus fumigatus, Penicillium citrinum, P. implicatum, Fusarium oxysporum and Alternaria alternata. These fungi species were counted in water samples at 35.14 CFU mL-1 and 24.69 CFU mL-1 in the dry seasons. In all fish farms, there was a higher abundance of fungi species in the rainy season. During visits to the fish farmers, it was possible to verify poor feed storage conditions. Concerning mutations in blood cells, in tambaqui (C. macropomum), a total of 159 anomalies were found, and in Leptodactylus petersii, 299 anomalies were found, with higher incidences in conditions above 1.0 CFU mL-1 in log10(x+1) fungi and in the rainy season. The occurrence of mycotoxicological contamination was confirmed in 81.25% of the analyzed samples. The quantified mycotoxin was Fumonisins B1 + B2 (375 to 1418 µg kg-1). Pearson's correlation analysis showed a significant positive correlation between Fumonisins and feed samples (r = 0.83). There was also a significant positive correlation between the abundance of fungi in water and the quantification of Fumonisins (r = 0.79). Based on the results obtained, it can be concluded that free-living fungi can be used as bioindicators of water quality in fish farms. Consequently, the lack of good management practices caused microbiological contamination of the aquatic environment.

First monitoring of cyanobacteria and cyanotoxins in freshwater from fish farms in Rondônia state, Brazil.

The main aimed of this study was to evaluate the physicochemical parameters, abundance and density of cyanobacteria, determine their blooms and the ecotoxicological risk of their cyanotoxins in fish ponds water. This study was conducted out in 20 fish farms in Rondônia state (Brazilian Amazon), samplings were carried out in the rainy and dry seasons. The experiment was developed in a completely randomized factorial design 20 × 3 x 3 (20 fish farms, 3 ponds and 3 replications). Regarding the composition of qualitative samples, horizontal and vertical hauls were carried out on the water surface, quantitative samples was obtained using a plankton net (50 µm mesh opening). Meanwhile, with the use of a multiparametric probe, physicochemical analyzes in fish ponds water were carried out. Furthermore, the cyanobacteria found were classified taxonomically and its blooms were recorded. Finally, blood was collected from 60 Colossoma macropomum. Concerning the higher averages in the rainy season 6.13 mg L⁻1 of dissolved oxygen, 40.02 cm of transparency, 0.35 NO31⁻ of nitrate, 0.15 NO21⁻ of nitrite, 44.55 mg L⁻1 CaCO3 of alkalinity and 50.10 mg L⁻1 CaCO3 of hardness, while higher averages of pH, phosphate and phosphorus were found in the dry season. A total of 15 families and 29 species of cyanobacteria were identified in the different seasons. The families that showed the highest densities (rainy and dry seasons) were Microcystaceae (356 and 760 cells mL⁻1), Leptolyngbyaceae (126 and 287 cells mL⁻1) and Microcoleaceae (111 and 405 cells mL⁻1). The species that showed the highest densities were Microcystis aeruginosa (356 and 697 cells mL⁻1), Planktolyngbya limnetica (98 and 257 cells mL⁻1) and Planktothrix sp. (111 and 239 cells mL⁻1). There were significant Pearson's correlations (r > 0.85; p < 0.05) between family abundances and cyanotoxin volume between physicochemical water variables and seasonality. A total of 20 cyanobacteria blooms were recorded, all of which in the dry season showed an ecotoxicological risk. Concerning the assessment mutagenicity in fish blood cells, a total of 78 abnormalities per slide were observed. In the dry season, the expected volume of cyanotoxins in the ponds from fish farms F1 and F4 were above the quantification limit (>QL). Abundance and density of cyanobacteria and their blooms and cyanotoxins can be used as bioindicators of eutrophication and/or water quality and ecotoxicological risk in fish ponds.

First evidence of microplastics in freshwater from fish farms in Rondônia state, Brazil.

The main aimed of this study was to provide information on microplastics present in the freshwater of fish farm ponds. In addition, the study showes a relationship between the seasonal, spatial distribution and the amount of microplastics found. This study was conducted in 35 fish farms located in the Rondônia state, Brazil, the sample collects were carried out in the two Amazonian hydrological seasons (dry and rainy). The study was developed in a completely randomized factorial scheme 35 × 3 x 3 (35 fish farms, 3 ponds and 3 repetitions per ponds). Microplastic sampling was performed following a modified method based on National Oceanic and Atmospheric Administration (NOAA). Samples of 250 mL freshwater collected, which were deionized and pre-filtered through 6.0 mm mesh granulometric sieves. The average abundances of the different hydrological seasons were compared by Student's t-test, with differences statistically significant at p < 0.05. The microplastics were morphological categorized into fibers and colors blue, red or transparent. Microplastic contamination was confirmed in freshwater of 9 fish farming, with greater abundance of blue fibers and greater quantification in the rainy season. Fish farms P3, P4 and P6 had the highest quantifications of blue fiber in the two seasons (6 and 43, 19 and 56, 11 and 88 items mL-1, respectively). Almost all fish farms had a higher abundance of microplastics in the rainy season. It is important to highlight the prominence of microplastics in the blue fiber rainy season (286 items mL-1) compared to the dry season (58 items mL-1). Fish farms P3, P4 and P6 showed a strong positive correlation between the factors distance from the nearest urban area (r = 0.94, 0.79 and 0.97, respectively) and seasonality (r = 0.98, 0.77 and 0.96, respectively). Rainfall variations influenced the abundance of microplastics, especially of blue fibers. Fish farms are supplied with fresh water by rivers or streams, so it is possible that microplastics originate outside the fish farm, perhaps they were introduced due to high soil occupation, although surface runoff (of water contaminated by sewage) caused by heavy rains the most important factor. Therefore, one factor must be considered, surface runoff and groundwater contaminated by urban, agricultural and urban effluents may have contaminated rivers and streams and then contaminated the water in the fish farm ponds.

Quality of Oreochromis niloticus and Cynoscion virescens fillets and their by-products in flours make for inclusion in instant food products.

The production of fish flour is an alternative for better use of the raw material, although it is rarely used in instant food. Thus, the aimed of this study was to evaluate Oreochromis niloticus (Nile tilapia) and Cynoscion virescens (croaker) fillets and the elaboration of flour with filleting by-products for inclusion in food products. Carcasses and heads of the two fish species were cooked, pressed, ground, subjected to drying and re-grinding to obtain standardized flours. These carcass flours were seasoned (sweet and salted). This study was organized into two experimental tests: Test 1: Yield, physicochemical and microbiological analyzes of fillets and flours made from carcass and head of Nile tilapia and croaker; Test 2: Seasoned flours made from Nile tilapia carcasses. There was a difference in fillets yield, where the croaker demonstrated 46.56% and the Nile tilapia 32.60%. Nile tilapia fillets had higher protein content (17.08%) and lower lipid content (0.89%) compared to croaker fillets (14.21 and 4.45%). Nile tilapia backbone flour had the highest protein content (55.41%) and the croaker the highest ash (45.55%) and the lowest Nile tilapia (28.38%). The head flours had lower protein contents (39.86%). Flours produced with croaker backbone had higher levels of calcium and phosphorus (9.34 and 9.27%). However, Nile tilapia backbone flour showed higher contents of essential amino acids. These flours demonstrated a fine granulometry (0.23 to 0.56 mm). Seasoned flours demonstrated interaction between fish species and flavors for moisture, ash, carbohydrates, calcium and phosphorus. The highest protein content (29.70%) was for Nile tilapia flour sweet flours (31.28%) had higher protein content, while salted lipids (8.06%). Nile tilapia has a lower fillet yield, although with a high protein content and low lipid content. Comparing the flours made from filleting by-products, the backbone flour has better nutritional quality, with Nile tilapia being superior to that of croaker, especially in terms of protein and amino acids.

Characterization and Strength Quality of the Oryctolagus cuniculus Leather Compared to Oreochromis niloticus Leather.

This study aimed to compare the resistance of the Oryctolagus cuniculus L. (rabbit) and Oreochromis niloticus L. (Nile tilapia) skins, as well as to observe the design of the flower of these skins and the morphology of the dermis. Tilapia and rabbit skins were placed inside the same equipment (tannery machine) for the chromium salt tanning process. The flower design of the fish leather distinguishes it from the rabbit leather, the latter being constituted by the opening of the hair follicles and pores, while the fish leather is constituted by the presence of protective lamellae and insertion of the scales. The dermis of rabbit skin consists of thick bundles of collagen fibers arranged in all directions, which differs from the morphology observed in the dermis of fish skin. However, in the Nile tilapia skin dermis, overlapping and parallel layers of longitudinal collagen fiber bundles are observed, these layers are interspersed with fiber bundles crossing the sking surface (transversely), tying the fibers together and providing greater strength, which can be proven by the strength test. The fish leathers, despite having less thickness (1.0 mm), demonstrated significantly greater tensile strength (13.52 ± 1.86 N mm-2) and tear strength (53.85 ± 6.66 N mm-2) than rabbit leathers, that is, (8.98 ± 2.67 N mm-2) and (24.25 ± 4.34 N mm-2). However, rabbit leather demonstrated higher elasticity (109.97 ± 13.52%) compared to Nile tilapia leather (78.97 ± 8.40%). It can be concluded that although the rabbit leather is thicker due to the histological architecture of the dermis (thick bundles of collagen fibers arranged in all directions with no pattern of organization of collagen fibers), it shows less resistance than Nile tilapia leather, which demonstrates an organization of overlapping and parallel layers and intercalating collagen fiber bundles transversally to the surface, functioning as tendons for the swimming process. It is recommended to use a piece of fabric (lining) together with the fleshy side of the rabbit leather, to increase resistance when used in clothing and footwear, as these products require greater tensile strength. Thus, it minimizes this restriction for the use of rabbit leather in the aforementioned purposes.

Tanned leather of the paiche Arapaima gigas Schinz, 1822 (Arapaimidae) with extracts of vegetable origin to replace chromium salts.

With the intensification of fish farming, the amount of residues also increased. One of the by-products generated is leather. However, several factors influence its quality, among them, the types of tanning used. Paiche (Arapaima gigas) is the largest freshwater fish in the world, and therefore has great potential in the use of leather, in addition to being one of the most cultivated fish in the Rondônia state. The aimed was to evaluate the physicomechanical resistance, histological and morphological aspects in different directions of the fibers of the paiche to evaluate the tanning with chromium oxide and vegetable tannin. Paiches with an average weight of 12.0 kg were used, skins were made and tanned using chromium and vegetable tannin as techniques. After tanning, 20 specimens were removed in longitudinal, transverse and diagonal directions to the fish body, to determine resistance in dynamometer and leather for histological analysis, scanning electron microscopy and physical-chemical analysis. The average thickness of the specimens of the leathers ranged 1.79mm to 2.82mm, in addition, there was no interaction between the type of tanning agent and the directions obtained for strength, traction and elongation. Regarding the progressive tearing test, there was also no interaction effect. However, the defined factors had relevant differences for the maximum and average amount applied, and the leathers tanned with vegetable tannin expanded to larger dimensions 110.19 and 85.52 N. According to the images obtained by histology and scanning microscopy, they presented that in the longitudinal and transverse direction the collagen fibers are presented in layers parallel to the leather surface and in the diagonal direction the interlacing is more intense, that is, in addition to the overlapping layers intercalated thinner, close to the surface, fiber bundles can also be seen crossing each other. It is concluded that leathers tanned with vegetable tannin have less resistance than leathers tanned with chromium salts for traction to rupture and greater resistance to tear.