We demonstrate high-output-power and high-efficiency operation of 1.3-µm-wavelength InP-based photonic-crystal surface-emitting lasers (PCSELs). By introducing a metal reflector and adjusting the phase of the reflected light via optimization of the thickness of the p-InP cladding layer, we successfully achieve an output power of approximately 400â mW with the slope efficiency of 0.4 W/A and the wall-plug efficiency of 20% under CW conditions. In addition, this PCSEL exhibits a narrow circular beam with a divergence angle below 1.6° even at high output powers under CW conditions at temperatures from 15°C to 50°C. We have also demonstrated an output power of over 12 W under pulsed conditions at room temperature.
We demonstrate high-power continuous-wave (CW) lasing oscillation of 1.3-µm wavelength InP-based photonic-crystal surface-emitting lasers (PCSELs). Single-mode operation with an output power of over 100â mW, a side-mode suppression ratio (SMSR) of over 50â dB, and a narrow single-lobe beam with a divergence angle of below 1.2° are successfully achieved by using a double-lattice photonic crystal structure consisting of high-aspect-ratio deep air holes. The double lattice is designed to enhance both the in-plane optical feedback and the surface radiation effects in the photonic crystal. The coupling coefficients for 180 ∘, +90 ∘, and -90 ∘ diffractions are estimated from the measurements of the photonic band structure as κ1D = 417 cm-1, κ2D+ = 135 cm-1, and κ2D- = 65 cm-1, respectively. The stable single-mode, high-beam-quality operation is attributed to these large coupling coefficients introduced by the asymmetric double-lattice structure.
