Environmental process descriptors for TNT, TNT-related compounds and picric acid in marine sediment slurries.

Process descriptors were determined for picric acid, TNT, and the TNT-related compounds 2,4DNT, 2,6DNT, 2ADNT, 4ADNT, 2,4DANT, 2,6DANT, TNB and DNB in marine sediment slurries. Three marine sediments of various physical characteristics (particle size ranging from 15 to >90% fines and total organic carbon ranging from <0.10 to 3.60%) were kept in suspension with 20ppt saline water. Concentrations of TNT and its related compounds decreased immediately upon contact with the marine sediment slurries, with aqueous concentrations slowly declining throughout the remaining test period. Sediment-water partition coefficients could not be determined for these compounds since solution phase concentrations were unstable. Kinetic rates and half-lives were influenced by the sediment properties, with the finer grained, higher organic carbon sediment being the most reactive. Aqueous concentrations of picric acid were very stable, demonstrating little partitioning to the sediments. Degradation to picramic acid was minimal, exhibiting concentrations at or just above the detection limit.

Dissolution and transport of TNT, RDX, and composition B in saturated soil columns.

Low-order detonations and blow-in-place procedures on military training ranges can result in residual solid explosive formulations to serve as distributed point sources for ground water contamination. This study was conducted to determine if distribution coefficients from batch studies and transport parameters of pure compounds in solution adequately describe explosive transport where compounds are present as solid particles in formulations. Saturated column transport experiments were conducted with 2,4,6-trinitrotoluene (TNT), hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX), and the explosive formulation, Composition B (Comp B) (59.5 +/- 2.0% RDX, 39.5 +/- 2.3% TNT, and 1% wax) in solid and dissolved forms. The two soils used were Plymouth loamy sand (mesic, coated Typic Quartzipsamments) from Camp Edwards, MA and Adler silt loam (coarse-silty, mixed, superactive, thermic Fluvaquentic Eutrudepts) from Vicksburg, MS. Interrupted flow experiments were used to determine if explosives were at equilibrium distribution between soil and solution phases. The HYDRUS-1D code was used to determine fate and transport parameters. Results indicated that sorption of high explosives was rate limited. The behavior of dissolved Comp B was similar to the behavior of pure TNT and RDX. Behavior of solid Comp B was controlled by dissolution that depended on physical properties of the Comp B sample. Adsorption coefficients determined by HYDRUS-1D were different from those determined in batch tests for the same soils. Use of parameters specific to formulations will improve fate and transport predictions.

Comparison of environmental fate and transport process descriptors of explosives in saline and freshwater systems.

Environmental process descriptors are necessary to evaluate the fate and transport of munitions constituents that have been introduced into the environment. An extensive database exists for freshwater environments; however, explosives fate and transport parameters such as dissolution rates, transformation rates, and adsorption of explosives have not been evaluated under both freshwater and saline conditions to determine the applicability of the freshwater data to saline environments. The objective of this study was to determine if freshwater fate and transport processes were similar to those determined under saline water conditions. We evaluated TNT, RDX, and HMX dissolution rates, transformation rates, and adsorption under freshwater and saline conditions in batch tests. Results showed a generally close agreement. Therefore, the existing freshwater database for explosives fate and transport process descriptors can be used in marine environments.

Vapor-phase transport of explosives from buried sources in soils.

The fate and transport of explosives in the soil pore vapor spaces affects both the potential detection of buried ordnance by chemical sensors and vadose zone transport of explosives residues. The efficacy of chemical sensors and their potential usefulness for detecting buried unexploded ordnance (UXO) is difficult to determine without understanding how its chemical signatures are transported through soil. The objectives of this study were to quantify chemical signature transport through soils under various environmental conditions in unsaturated soils and to develop a model for the same. Flux chambers, large soil containers, and batch tests were used to determine explosives signature movement and process descriptors for model development. Low signatures were observed for explosives (2,4-dinitrotoluene, 2,6-dinitrotoluene, and 1,3-dinitrobenzene) under all environmental conditions. A diffusion model was used to describe the chemical transport mechanism in the soil pore air. The soil-air partition constant was treated as a fit parameter in the model owing to the uncertainty in its a priori estimation. The model predictions of the trends in experimental fluxes and the soil concentration were only marginal at best. It was concluded that better estimates of the partition constant are required for more accurate estimation of the chemical concentration at the soil-air interface. Chemical sensors will need to be very sensitive because of low signatures. However, this may result in many false alarms because of explosives residues not associated with UXO on firing ranges. Low explosives signatures also should result in insignificant air environmental exposures.

Volatilization of contaminants from suspended sediment in a water column during dredging.

Remedial dredging of contaminated bed sediments in rivers and lakes results in the suspension of sediment solids in the water column, which can potentially be a source for evaporation of hydrophobic organic compounds (HOCs) associated with the sediment solids. Laboratory experiments were conducted in an oscillating grid chamber to simulate the suspension of contaminated sediments and flux to air from the surface of the water column. A contaminated field sediment from Indiana Harbor Canal (IHC) and a laboratory-inoculated University Lake (UL) sediment, Baton Rouge, LA, were used in the experiments, where water and solids concentration and particle size distribution were measured in addition to contaminant fluxes to air. A transient model that takes into account contaminant desorption from sediment to water and evaporation from the water column was used to simulate water and sediment concentrations and air fluxes from the solids suspension. In experiments with both sediments, the total suspended solids (TSS) concentration and the average particle diameter of the suspended solids decreased with time. As expected, the evaporative losses were higher for compounds with higher vapor pressure and lower hydrophobicity. For the laboratory-inoculated sediment (UL), the water concentrations and air fluxes were high initially and decreased steadily implying that contaminant release to the water column from the suspended solids was rapid, followed by evaporative decay. For the field sediments (IHC), the fluxes and water concentrations increased initially and subsequently decreased steadily. This implied that the initial desorption to water was slow and that perhaps the presence of oil and grease and aging influenced the contaminant release. Comparison of the model and experimental data suggested that a realistic determination of the TSS concentration that can be input into the model was the most critical parameter for predicting air emission rates.

Vapor phase transport of unexploded ordnance compounds through soils.

Unexploded ordnance (UXO) is a source of concern at several U.S. Department of Defense (DOD) sites. Localization of munitions and fate and transport of the explosive compounds from these munitions are a major issue of concern. A set of laboratory experiments were conducted in specially designed flux chambers to measure the evaporative flux of three explosive compounds (2,4-dinitrotoluene, 2,6-dinitrotoluene, and 1,3-dinitrobenzene) from three different soils. The effect of different soil moisture contents, the relative humidity of air contacting the soil surface, and soil temperature on the chemical fluxes were evaluated. A diffusion model was used to describe the chemical transport mechanism in the soil pore air. The soil-air partition constant was treated as a fit parameter in the model because of the uncertainty in the a priori estimation. The model predicts the qualitative trends of the experimental fluxes satisfactorily. Under extremely dry conditions, the flux decreased more rapidly than that predicted by the model. The fluxes from soils at 24 degrees C were higher than those at 14 degrees C, indicating a larger volatilization driving force at the higher temperature.