RESUMEN
Mixed-halide wide-band gap perovskites (WBPs) still suffer from losses due to imperfections within the absorber and the segregation of halide ions under external stimuli. Herein, we design a multifunctional passivator (MFP) by mixing bromide salt, formamidinium bromide (FABr) with a p-type self-assembled monolayer (SAM) to target the nonradiative recombination pathways. Photoluminescence measurement shows considerable suppression of nonradiative recombination rates after treatment with FABr. However, WBPs still remained susceptible to halide segregation for which the addition of 25% p-type SAM was effective to decelerate segregation. It is observed that FABr can act as a passivating agent of the donor impurities, shifting the Fermi-level (Ef) toward the mid-band gap, while p-type SAM could cause an overweight of Ef toward the valence band. Favorable band bending at the interface could prevent the funneling of carriers toward I-rich clusters. Instead, charge carriers funnel toward an integrated SAM, preventing the accumulation of polaron-induced strain on the lattice. Consequently, n-i-p structured devices with an optimal MFP treatment show an average open-circuit voltage (VOC) increase of about 20 mV and fill factor (FF) increase by 4% compared with the control samples. The unencapsulated devices retained 95% of their initial performance when stored at room temperature under 40% relative humidity for 2800 h.
RESUMEN
We identify nanoscale spatial distribution of PbI2 on the (FAPbI3)0.85(MAPbBr3)0.15 perovskite thin film and investigate the local passivation effect using confocal based optical microscopy of steady state and time-resolved photoluminescence (PL). Different from a typical scanning electron microscope (SEM) morphology study, confocal based PL spectroscopy and microscopy allow researchers to map the morphologies of both perovskite and PbI2 grains simultaneously, by selectively detecting their characteristic fluorescent bands using band-pass filters. In this work, we compare the perovskite samples without and with excess PbI2 incorporation and unambiguously reveal PbI2 distribution for the PbI2-rich sample. In addition, using the nanoscale time-resolved PL technique we show that the PbI2-rich regions exhibit longer lifetime due to suppressed defect trapping, compared to the PbI2-poor regions. The measurement on the PbI2-rich sample indicates that the passivation effect of PbI2 in perovskite film is effective, especially in localized regions. Hence, this finding is important for further improvement of the solar cells by considering the strategy of excess PbI2 incorporation.
RESUMEN
The past 2 years have seen the uniquely rapid emergence of a new class of solar cell based on mixed organic-inorganic halide perovskite. Grain boundaries are present in polycrystalline thin film solar cell, and they play an important role that could be benign or detrimental to solar-cell performance. Here we present efficient charge separation and collection at the grain boundaries measured by KPFM and c-AFM in CH3NH3PbI3 film in a CH3NH3PbI3/TiO2/FTO/glass heterojunction structure. We observe the presence of a potential barrier along the grain boundaries under dark conditions and higher photovoltage along the grain boundaries compare to grain interior under the illumination. Also, c-AFM measurement presents higher short-circuit current collection near grain boundaries, confirming the beneficial roles grain boundaries play in collecting carriers efficiently.
