We measured the anelastic, dielectric and structural properties of the metal-free molecular perovskite (ABX3) (MDABCO)(NH4)I3, which has already been demonstrated to become ferroelectric below TC= 448 K. Both the dielectric permittivity measured in air on discs pressed from powder and the complex Young's modulus measured on resonating bars in a vacuum show that the material starts to deteriorate with a loss of mass just above TC, introducing defects and markedly lowering TC. The elastic modulus softens by 50% when heating through the initial TC, contrary to usual ferroelectrics, which are stiffer in the paraelectric phase. This is indicative of improper ferroelectricity, in which the primary order parameter of the transition is not the electric polarization, but the orientational order of the MDABCO molecules. The degraded material presents thermally activated relaxation peaks in the elastic energy loss, whose intensities increase together with the decrease in TC. The peaks are much broader than pure Debye due to the general loss of crystallinity. This is also apparent from X-ray diffraction, but their relaxation times have parameters typical of point defects. It is argued that the major defects should be of the Schottky type, mainly due to the loss of (MDABCO)2+ and I-, leaving charge neutrality, and possibly (NH4)+ vacancies. The focus is on an anelastic relaxation process peaked around 200 K at â¼1 kHz, whose relaxation time follows the Arrhenius law with τ0 â¼ 10-13 s and E≃0.4 eV. This peak is attributed to I vacancies (VX) hopping around MDABCO vacancies (VA), and its intensity presents a peculiar dependence on the temperature and content of defects. The phenomenology is thoroughly discussed in terms of lattice disorder introduced by defects and partition of VX among sites that are far from and close to the cation vacancies. A method is proposed for calculating the relative concentrations of VX, that are untrapped, paired with VA or forming VX-VA-VX complexes.
We studied the influence of water on the structural stability and transformations of MAPI and FAPI by anelastic and dielectric spectroscopies under various temperature and H2O partial pressure protocols. Before discussing the new results in terms of interstitial water in MAPI and FAPI, the literature is briefly reviewed, in search of other studies and evidences on interstitial water in hybrid halide perovskites. In hydrated MAPI, the elastic anomaly between the cubic α and tetragonal ß phases may be depressed by more than 50%, demonstrating that there are H2O molecules dispersed in the perovskite lattice in interstitial form, that hinder the long range tilting of the PbI6 octahedra. Instead, in FAPI, interstitial water accelerates in both senses the reconstructive transformations between 3D α and 1D δ phases, which is useful during the crystallization of the α phase. On the other hand, the interstitial H2O molecules increase the effective size of the MA and FA cations to which are bonded, shifting the thermodynamic equilibrium from the compact perovskite structure to the open δ and hydrated phases of loosely bonded chains of PbI6 octahedra. For this reason, when fabricating devices based on hybrid metal-organic halide perovskites, it is important to reduce the content of interstitial water as much as possible before encapsulation.
This work aims to investigate more sustainable reaction conditions for the synthesis of metallophthalocyanines. Anisole, glycerol and their mixtures have been investigated as reaction media for the tetramerization of phthalonitriles. Acetates of three divalent first-transition metal cations, Co(II), Cu(II) and Zn(II), were used and several bases were tested, depending on the chosen substrates and reaction conditions, with a view to making the whole process more sustainable while ensuring its scalability. Unsubstituted phthalocyanines were synthesized to analyze the behavior of the different metal ions in terms of reactivity in the new reaction media, resulting in a general Cu > Co > Zn trend, while the nonpolar tetra-tert-butyl substitution was investigated to evaluate the synthesis of soluble derivatives in the new conditions. Furthermore, the potassium hydroxide (KOH)-aided statistical synthesis of the unsymmetrical 9(10), 16(17), 23(24)-tri-tert-butyl-2-iodophthalocyaninato zinc(II), starting from 4-tert-butylphthalonitrile and 4-iodophthalonitrile in a glycerol/anisole mixture, proceeded with a satisfactory 26% yield. Our results provide insights into the investigation of new reaction environments and the understanding of their strengths and weaknesses, with a view to further increasing the sustainability of the synthesis of metallomacrocycles with high added value while lowering their production cost.
The [1]benzothieno[3,2-b][1]benzothiophene (BTBT) planar system was used to functionalize the phthalocyanine ring aiming at synthesizing novel electron-rich π-conjugated macrocycles. The resulting ZnPc-BTBT and ZnPc-(BTBT)4 derivatives are the first two examples of a phthalocyanine subclass having potential use as solution-processable p-type organic semiconductors. In particular, the combination of experimental characterizations and theoretical calculations suggests compatible energy level alignments with mixed halide hybrid perovskite-based devices. Furthermore, ZnPc-(BTBT)4 features a high aggregation tendency, a useful tool to design compact molecular films. When tested as hole transport materials in perovskite solar cells under 100â mA cm-2 standard AM 1.5G solar illumination, ZnPc-(BTBT)4 gave power conversion efficiencies as high as 14.13 %, irrespective of the doping process generally required to achieve high photovoltaic performances. This work is a first step toward a new phthalocyanine core engineerization to obtain robust, yet more efficient and cost-effective materials for organic electronics and optoelectronics.
The photophysics of 9(19),16(17),23(24)-tri-tert-butyl-2-[ethynyl-(4-carboxymethyl)phenyl]phthalocyaninatozinc(ii) and its H-aggregates is studied in different solvents by means of ultrafast non-linear optical spectroscopy and computational modeling. In non-coordinating solvents, both stationary and time-resolved spectroscopies highlight the formation of extended molecular aggregates, whose dimension and spectral properties depends on the concentration. In all the explored experimental conditions, time-resolved transient absorption experiments show multi exponential decay of the signals. Additional insights into the excited state relaxation mechanisms of the system is obtained with 2D electronic spectroscopy, which is employed to compare the deactivation channels in the absence or presence of aggregates. In ethanol and diethylether, where only monomers are present, an ultrafast relaxation process among the two non-degenerate Q-states of the molecule is evidenced by the appearance of a cross peak in the 2D-maps. In chloroform or CCl4, where disordered H-aggregates are formed, an energy transfer channel among aggregates with different composition and size is observed, leading to the non-radiative decay towards the lower energy dark state of the aggregates. Efficient coupling between less and more aggregated species is highlighted in two-dimensional electronic spectra by the appearance of a cross peak. The kinetics and intensity of the latter depend on the concentration of the solution. Finally, the linear spectroscopic properties of the aggregate are reproduced using a simplified structural model of an extended aggregate, based on Frenkel Hamiltonian Calculations and on an estimate of the electronic couplings between each dimer composing the aggregate computed at DFT level.
We have investigated the formation and the properties of ultrathin films of ruthenium phthalocyanine (RuPc)2 vacuum deposited on graphite by scanning tunneling microscopy and synchrotron photoemission spectroscopy measurements, interpreted in close conjunction with ab initio simulations. Thanks to its unique dimeric structure connected by a direct Ru-Ru bond, (RuPc)2 can be found in two stable rotameric forms separated by a low-energy barrier. Such isomerism leads to a peculiar organization of the molecules in flat, horizontal layers on the graphite surface, characterized by a chessboard-like alternation of the two rotamers. Moreover, the molecules are vertically connected to form π-stacked columnar pillars of akin rotamers, compatible with the high conductivity measured in (RuPc)2 powders. Such features yield an unprecedented supramolecular assembly of phthalocyanine films, which could open interesting perspectives toward the realization of new architectures of organic electronic devices.
Organometallic Compounds/chemistry , Microscopy, Scanning Tunneling , Photoelectron Spectroscopy , Quantum Theory
A number of studies have investigated the properties of monomeric and double-decker phthalocyanines (Pcs) adsorbed on metal surfaces, in view of applications in spintronics devices. In a combined experimental and theoretical study, we consider here a different member of the Pcs family, the (RuPc)2 dimer, whose structure is characterized by two paired up magnetic centers embedded in a double-decker architecture. For (RuPc)2 on Ag(111), we show that this architecture works as a preserving cage by shielding the Ru-Ru pair from a direct interaction with the surface atoms. In fact, while noticeable surface-to-molecule charge transfer occurs with the ensuing quenching of the molecular magnetic moment, such phenomena occur here in the absence of a direct Ru-Ag coupling or structural rearrangement, at variance with other Pcs and thanks to the above shielding effect. These unique properties of the (RuPc)2 architecture are expected to permit an easy control of the surface-to-molecule charge-transfer process as well as of the molecular magnetic properties, thus making the (RuPc)2 dimer a significant paradigm for innovative "cage" structures as well as a promising candidate for applications in spintronics nano or single-molecule devices.
A new unsymmetrical zinc phthalocyanine sensitizer has been synthesised. The anchoring of the molecule to nanocrystalline TiO(2) films is realised by a carboxylic group connected to a phenyl ethynyl moiety. Density Functional Theory (DFT) calculations show significant and positive effects of such a functionalization. Electron injection into the semiconductor and photocurrent generation in DSSC are also presented.
