The recovery of Au(III) from solution using adsorbents in the form of granules or powders is challenging due to issues such as instability during the recovery process or mass loss caused by small particle size. This study introduces a PEI-TCT/PVDF composite membrane designed to intercept and capture Au(III) in wastewater. Experimental results demonstrated that the PEI-TCT/PVDF membrane exhibits a broad pH range (1-8) and a high retention efficiency for Au(III) of 97.8%, with a maximum adsorption capacity of 294.5 mg/g. The mechanism of Au(III) adsorption on the PEI-TCT/PVDF membrane was mainly through electrostatic adsorption, which caused AuCl4- to aggregate on the surface of the membrane and gradually reduced to Au0 and Au+. Furthermore, the membrane can be entirely regenerated within 20 min and maintains its performance in subsequent adsorption cycles. This study highlights the potential of PEI-TCT/PVDF membranes for the recovery of precious Au(III).
The recovery of valuable gold from wastewater is of great interest because of the widespread use of the precious metal in various fields and the pollution generated by gold-containing wastes in water. In this paper, a water-insoluble cross-linked adsorbent material (TE) based on cyanuric chloride (TCT) and ethylenediamine (EDA) was designed and used for the adsorption of Au(III) from wastewater. It was found that TE showed extremely high selectivity (D = 49,213.46) and adsorption capacity (256.19 mg/g) for Au(III) under acidic conditions. The adsorption rate remained above 90% eVen after five adsorption-desorption cycles. The adsorption process followed the pseudo-first-order kinetic model and the Freundlich isotherm model, suggesting that physical adsorption with a multilayer molecular overlay dominates. Meanwhile, the adsorption mechanism was obtained by DFT calculation and XPS analysis, and the adsorption mechanism was mainly the electrostatic interaction and electron transfer between the protonated N atoms in the adsorbent (TE) and AuCl4-, which resulted in the redox reaction. The whole adsorption process was the result of the simultaneous action of physical and chemical adsorption. In conclusion, the adsorbent material TE shows great potential for gold adsorption and recovery.
