RESUMEN
The kinetics and pathway of most catalyzed reactions depend on the existence of interface, which makes the precise construction of highly active single-atom sites at the reaction interface a desirable goal. Herein, we propose a thermal printing strategy that not only arranges metal atoms at the silica and carbon layer interface but also stabilizes them by strong coordination. Just like the typesetting of Chinese characters on paper, this method relies on the controlled migration of movable nanoparticles between two contact substrates and the simultaneous emission of atoms from the nanoparticle surface at high temperatures. Observed by in situ transmission electron microscopy, a single Fe3O4 nanoparticle migrates from the core of a SiO2 sphere to the surface like a droplet at high temperatures, moves along the interface of SiO2 and the coated carbon layer, and releases metal atoms until it disappears completely. These detached atoms are then in situ trapped by nitrogen and sulfur defects in the carbon layer to generate Fe single-atom sites, exhibiting excellent activity for oxygen reduction reaction. Also, sites' densities can be regulated by controlling the size of Fe3O4 nanoparticle between the two surfaces. More importantly, this strategy is applicable to synthesize Mn, Co, Pt, Pd, Au single-atom sites, which provide a general route to arrange single-atom sites at the interface of different supports for various applications.
RESUMEN
The design of an efficient catalytic system with low Pt loading and excellent stability for the acidic oxygen reduction reaction is still a challenge for the extensive application of proton-exchange membrane fuel cells. Here, a gas-phase ordered alloying strategy is proposed to construct an effective synergistic catalytic system that blends PtM intermetallic compounds (PtM IMC, M = Fe, Cu, and Ni) and dense isolated transition metal sites (M-N4 ) on nitrogen-doped carbon (NC). This strategy enables Pt nanoparticles and defects on the NC support to timely trap flowing metal salt without partial aggregation, which is attributed to the good diffusivity of gaseous transition metal salts with low boiling points. In particular, the resulting Pt1 Fe1 IMC cooperating with Fe-N4 sites achieves cooperative oxygen reduction with a half-wave potential up to 0.94 V and leads to a high mass activity of 0.51 A mgPt -1 and only 23.5% decay after 30 k cycles, both of which exceed DOE 2025 targets. This strategy provides a method for reducing Pt loading in fuel cells by integrating Pt-based intermetallics and single transition metal sites to produce an efficient synergistic catalytic system.
RESUMEN
Modifying the atomic and electronic structure of platinum-based alloy to enhance its activity and anti-CO poisoning ability is a vital issue in hydrogen oxidation reaction (HOR). However, the role of foreign modifier metal and the underlying ligand effect is not fully understood. Here, we propose that the ligand effect of single-atom Cu can dynamically modulate the d-band center of Pt-based alloy for boosting HOR performance. By in situ X-ray absorption spectroscopy, our research has identified that the potential-driven structural rearrangement into high-coordination Cu-Pt/Pd intensifies the ligand effect in Pt-Cu-Pd, leading to enhanced HOR performance. Thereby, modulating the d-band structure leads to near-optimal hydrogen/hydroxyl binding energies and reduced CO adsorption energies for promoting the HOR kinetics and the CO-tolerant capability. Accordingly, PtPdCu1/C exhibits excellent CO tolerance even at 1,000 ppm impurity.
RESUMEN
Coordination environment and site density have great impacts on the catalytic performance for single atoms (SAs). Herein, the site density of Mo-SAs on red polymeric carbon nitrides (RPCN) is modulated via a local carbonization strategy to controllably catch adventitious O atoms from open environment. The addition of melamine derivants with hydrocarbyl chains induces local carbonization during RPCN pyrolysis. These local carbonization regions bring abundant graphitic N3C to anchor Mo-SAs, and most of Mo-SAs catch the O atoms in air, forming the O2 -covered Mo-N3 coordination. The dopants of carbon source with different structures and amounts can modulate the site density of Mo-SAs, therefore controlling the amounts of coordinated O atoms. Furthermore, coordinated O atoms around Mo-SAs construct the catalytic environment with Lewis base and gather photo-generated electrons under light. Such O-covered Mo-SAs endow RPCN materials (Mo-RPCN) with a strong ability for hydrogen abstraction, leading to the 99.51% ratio (28.8 mmol min-1 g-1 ) rate for thioanisole conversion with H2 O2 assisted advance oxidation technology. This work brings a new sight on the coordinated atoms dominant oxidation process.
RESUMEN
Developing highly stable and efficient catalysts toward the oxygen reduction reaction is important for the long-term operation in proton exchange membrane fuel cells. Reported herein is a facile synthesis of two-dimensional coplanar Pt-carbon nanomeshes (NMs) that are composed of highly distorted Pt networks (neck width of 2.05±0.72â nm) and carbon. X-ray absorption fine structure spectroscopy demonstrated the metallic state of Pt in the coplanar Pt/C NMs. Fuel cell tests verified the excellent activity of the coplanar Pt/C NM catalyst with the peak power density of 1.21â W cm-2 and current density of 0.360â A cm-2 at 0.80â V in the H2 /O2 cell. Moreover, the coplanar Pt/C NM electrocatalysts showed superior stability against aggregation, with NM structures preserved intact for a long-term operation of over 30 000â cycles for electrode measurement, and the working voltage loss was negligible after 120â h in the H2 /O2 single cell operation. Density-functional theory analysis indicates the increased vacancy formation energy of Pt atoms for coplanar Pt/C NMs, restraining the tendency of Pt dissolution and aggregation.
RESUMEN
Organic acid is an important factor that accelerates the aging of cellulosic insulation materials. In this study, the interactions between cellulose and five acids, representative of what may be found in an aging transformer, were studied using molecular dynamics. The adsorption process of the five acids onto the surface of crystalline cellulose shows that the three low molecular acids are more readily adsorbed onto cellulose than the two high molecular acids. The deformation and adsorption energies of the acids all increase with an increase in molecular weight when they are stably interacting with cellulose. However, the differences between adsorption energies and deformation energies are positive for the three low molecular acids, whereas they are negative for the two high molecular acids. This indicates that the attachments onto cellulose of low molecular acids are considerably more stabilized than those of the high molecular acids. This is consistent with the experimental results. Furthermore, based on the calculated solubility parameters of acids, the experimental result that the three low molecular acids are to a large degree absorbed onto the cellulose, whereas the two high molecular acids remain in the oil, was theoretically elucidated using the theory of similarity and intermiscibility.
Asunto(s)
Ácidos/química , Celulosa/química , Simulación de Dinámica Molecular , Compuestos Orgánicos/química , Adsorción , Algoritmos , Interacciones Hidrofóbicas e Hidrofílicas , Modelos Químicos , Modelos Moleculares , Estructura Molecular , SolubilidadRESUMEN
The development of metal-N-C materials as efficient non-precious metal (NPM) catalysts for catalysing the oxygen reduction reaction (ORR) as alternatives to platinum is important for the practical use of proton exchange membrane fuel cells (PEMFCs). However, metal-N-C materials have high structural heterogeneity. As a result of their high-temperature synthesis they often consist of metal-Nx sites and graphene-encapsulated metal nanoparticles. Thus it is hard to identify the active structure of metal-N-C catalysts. Herein, we report a low-temperature NH4 Cl-treatment to etch out graphene-encapsulated nanoparticles from metal-N-C catalysts without destruction of co-existing atomically dispersed metal-Nx sites. Catalytic activity is much enhanced by this selective removal of metallic nanoparticles. Accordingly, we can confirm the spectator role of graphene-encapsulated nanoparticles and the pivotal role of metal-Nx sites in the metal-N-C materials for ORR in the acidic medium.
RESUMEN
Natural ester, as a new environmentally green insulating oil, has been widely used in transformer. In an oil-immersed transformer, the normal aging, thermal failure, and discharge failure could easily lead to the decomposition of the oil-paper insulation system and produce different kinds of gases. Studying gas dissolution in natural ester and mineral oil could provide assistance in applying criteria to make a diagnosis of different kinds of faults in the transformer. In this paper, the molecular dynamics method was used to investigate the diffusion behavior of seven fault characteristic gases (including H2, CO, CH4, C2H2, CO2, C2H4, C2H6) in natural ester and mineral oil. The simulation parameters of free volume, interaction energy, mean square displacement, and diffusion coefficient were compared between the natural ester and mineral oil. Meanwhile, the influence of temperature on the diffusion of gas molecules in two kinds of oils was also analyzed. Results showed that the free volume, the interaction energy, and the relative molecular mass of gas molecules were the factors influenced by the diffusion of gas molecules in natural ester and mineral oil. The order of the diffusion coefficients of gas molecules in natural ester was as follows: H2 > CH4 > CO > C2H2 > C2H4 > CO2 > C2H6 and that in mineral oil was as follows: H2 > CH4 > CO> C2H2 > C2 H4 > C2H6 > CO2. By comparing the diffusion behavior of gas molecules in natural ester and mineral oil, it was found that the smaller free volume and higher interaction energy of gas molecules in natural ester were the major reasons for the gas molecules to be more difficult to diffuse in natural ester. The rising temperature could enhance the free volume and reduce the interaction energy between gas molecules and oil. The diffusion coefficient of gas molecules increased exponentially with the follow of temperature. However, the temperature didn't affect the ordering of diffusion coefficient, free volume, and interaction energy of gas molecules in natural ester and mineral oil.
Asunto(s)
Ésteres/química , Gases/química , Aceite Mineral/química , Simulación de Dinámica Molecular , DifusiónRESUMEN
Single-atom catalysts (SACs) feature the maximum atom economy and superior performance for various catalysis fields, attracting tremendous attention in materials science. However, conventional synthesis of SACs involves high energy consumption at high temperature, complicated procedures, a massive waste of metal species, and poor yields, greatly impeding their development. Herein, a facile dangling bond trapping strategy to construct SACs under ambient conditions from easily accessible bulk metals (such as Fe, Co, Ni, and Cu) is presented. When mixing graphene oxide (GO) slurry with metal foam and drying in ambient conditions, the M0 would transfer electrons to the dangling oxygen groups on GO, obtaining Mδ+ (0 < δ < 3) species. Meanwhile, Mδ+ coordinates with the surface oxygen dangling bonds of GO to form MO bonds. Subsequently, the metal atoms are pulled out of the metal foam by the MO bonds under the assistance of sonication to give M SAs/GO materials. This synthesis at room temperature from bulk metals provides a versatile platform for facile and low-cost fabrication of SACs, crucial for their mass production and practical application in diverse industrial reactions.