A Three-Reagent "Green" Paper-Based Analytical Device for Solid-Phase Spectrometric and Colorimetric Determination of Dihydroquercetin.

Microfluidic paper-based analytical devices (µPADs) represent one of the promising green analytical strategies for low-cost and simple determination of various analytes. The actual task is the development of such devices for quantitation of antioxidants, e.g., flavonoids. In this paper, possibilities of a novel three-reagent µPAD including silver nitrate, 4-nitrophenyldiazonium tetrafluoroborate, and iron(III) chloride as reagents are assessed with respect to the determination of dihydroquercetin. It is shown that all the three reagents produce different colorimetric responses that can be detected by a mini-spectrophotometer-monitor calibrator or by a smartphone. The method is applicable to direct measuring high contents of dihydroquercetin (the linearity range is 0.026-1 mg mL-1, and the limit of detection is 7.7 µg mL-1), which is favorable for many dietary supplements. The analysis of a food supplement was possible with the relative standard deviations of 9-26%, which is satisfactory for quantitative and semiquantitative determinations. It was found that plotting a calibration graph in 3D space of the three reagents' responses allows us to distinguish dihydroquercetin from its close structural analogue, quercetin.

Label-free silver triangular nanoplates for spectrophotometric determination of catecholamines and their metabolites.

A novel method towards spectrophotometric determination of catecholamines and their metabolites differing in their functional groups has been developed. This method is based on a change in morphology of silver triangular nanoplates upon the action of cateсholamines and their metabolites, which is manifested by the decrease of the nanoparticle local surface plasmon resonance (LSPR) band intensity or its shift to the short-wavelength region of the spectrum. The shift value of the LSPR band or the change of its intensity increases with increasing concentration of catecholamines or their metabolites, which is proposed for their spectrophotometric determination. The limits of detection of catecholamines and their metabolites under selected conditions increase in the series homovanillic acid < vanillylmandelic acid < L-epinephrine < L-norepinephrine < dopamine and are 0.25, 1.2, 3.0, 64, and 130 µmol L-1, respectively. The selectivity of the proposed method was assessed using vanillylmandelic acid as example. It was found that the determination of vanillylmandelic acid does is not interfered in the presence of 4000-fold excess of Na+, K+, CH3COO-, and 1000-fold excess of Mg2+, Ca2+, Al3+, NO3-. The method also allows for the selective determination of vanillylmandelic acid in the presence of a 1000-fold excess of structurally related substances that do not contain either a catechol fragment or an electron donor substituent. The proposed approach was successfully applied to the determination of catecholamines in pharmaceuticals and artificial urine. Graphical abstract.

An improved step-by-step airflow/paper-based colorimetric method for highly selective determination of halides in complex matrices.

An improved step-by-step colorimetric method for determination of halides has been developed. The method is based on successive selective oxidation of iodide, bromide and chloride into corresponding free halogens, their extraction by airflow and colorimetric detection with different paper test-strips. This procedure can be performed in a single analyzed solution and possesses high selectivity and good sensitivity due to the extraction step. Three types of paper test-strips were examined: paper modified with tetramethylammonium iodide and starch, paper modified with methyl orange and paper modified with silver triangular nanoplates. Limits of detection for iodide, bromide and chloride are 0.01, 0.02, and 0.04 mg L-1 respectively in case of the last mentioned paper. The method was applied to the analysis of samples having complex matrices, such as various seafood, preserves, bread, and natural waters, showing good accuracy of the analysis with recoveries of 95-105% and relative standard deviations not higher than 6%.

Early stages in the history of gas chromatography.

The creation of gas chromatography is traditionally associated with the names of Nobel Prize winner Archer Martin and his colleagues Richard Synge and Anthony James. However, sometimes references to their predecessors can be found. An investigation conducted by the authors of this article not only confirmed the reliability of these references; but in fact led to the conclusion that by 1952, which is commonly believed to be the year when gas chromatography was born, many research papers had already been devoted to this method, mainly, in its gas-solid version. These papers are considered in this article.

Towards highly selective detection using metal nanoparticles: A case of silver triangular nanoplates and chlorine.

The article describes a novel approach towards improving selectivity of volatile compounds detection using metal nanoparticles. It is based on combination of sensitive optical detection using convenient nanoparticle-modified paper test strips and dynamic gas extraction improving selectivity to volatile compounds. A simple and inexpensive setup allowing for realization of this combination is described. Analytical prospects of the approach are shown by the example of chlorine determination in highly salted aqueous solutions using silver triangular nanoplates and digital colorimetry. The limit of detection is equal to 0.03mgL-1 and the determination range is 0.1-2mgL-1. This determination can be successfully carried out in solutions containing at least 2·105 greater molar amounts of Na+, K+, Zn2+, Cl-, SO42-, and H2PO4- with no sample pretreatment. The approach seems to be compatible with different types of nanoparticles with respect to detection of various analytes, thus having good opportunities for further development.

Towards the development of solid-state platform optical sensors: aggregation of gold nanoparticles on polyurethane foam.

In this paper, we report on a novel type of nanocomposites based on gold nanoparticles (AuNPs) and polyurethane foam (PUF), which represents an ability of AuNP aggregation on solid polymer matrix with the strongly different selectivity in comparison with aggregation of the same AuNPs in solution. This may indicate that a new type of aggregation takes place, which can be called solid-phase aggregation. A systematic study using diffuse reflectance spectroscopy revealed features of the solid-phase aggregation. The PUF-AuNPs nanocomposites can be synthesized by a simple and low cost procedure based on adsorption of different type AuNPs from aqueous solution onto PUF. Prospects of obtained composite materials for sensing some organic compounds using diffuse reflectance spectroscopy or colorimetry are shown. This nanocomposites have the increased selectivity to thiols allowing for their determination with limits of detection of 0.01-0.05µgmL-1 and relative standard deviations of 3-5%. Charged species that affect AuNPs in solution do not influence them on PUF.

Facile synthesis of magnetic hypercrosslinked polystyrene and its application in the magnetic solid-phase extraction of sulfonamides from water and milk samples before their HPLC determination.

In this study, a novel magnetic solid-phase extraction (MSPE) sorbent, magnetic hypercrosslinked polystyrene (HCP/Fe3O4), was prepared and used for preconcentration of four sulfonamides (sulfamethoxypyridazine, sulfamethazine, sulfamethoxazole and sulfachloropyridazine) from natural water and milk samples. This material was prepared by sorption of pre-synthesized Fe3O4 nanoparticles (NPs) onto HCP. A number of sorbents with varying Fe3O4NPs content were prepared, and their structural, magnetic and sorption properties were studied. Various experimental parameters affecting the extraction efficiencies such as the amount of the magnetic nanocomposite, extraction time, pH of the sample solution and desorption conditions were studied and optimized. Under the optimal conditions, a convenient and efficient method for the determination of sulfonamides in water and milk samples was developed by combining MSPE and high-performance liquid chromatography with amperometric detection. The results showed that the recoveries of these compounds were in the range of 84-105% with the relative standard deviations ranging between 3% and 10%; the limit of detection were in the range of 0.21-0.33 ng mL(-1) for water and 2.0-2.5 ng mL(-1) for milk.

Determination of the total content of some sulfonamides in milk using solid-phase extraction coupled with off-line derivatization and spectrophotometric detection.

A simple screening method for isolation and determination of the total content of some sulfonamides in milk using solid-phase extraction and a color reaction is described. This procedure is based on SPE of sulfonamides on hypercrosslinked polystyrene, elution with acetonitrile and off-line derivatization with p-dimethylaminocinnamaldehyde in acetonitrile followed by spectrophotometric determination. The reaction produces intense violet-red color and can be easily used both for quantitation of sulfonamides using spectrophotometry and for naked-eye semi-quantitative estimation. Maximum absorption of the reaction product was determined at 540 nm. The Lambert-Beer's law was obeyed in the range of 0.07-3.0 µg mL(-1) in eluate, with the squared correlation coefficient (R(2)) of 0.9875-0.9995, and the relative standard deviation (RSD) of 3-4%. The limits of SAs detection using preconcentration were of 0.02-0.03 µg mL(-1). The proposed method can be recommended as a routine screening method for quantitation of sulfonamides in milk.

Recent advances in sample preparation techniques and methods of sulfonamides detection - A review.

Sulfonamides (SAs) have been the most widely used antimicrobial drugs for more than 70 years, and their residues in foodstuffs and environmental samples pose serious health hazards. For this reason, sensitive and specific methods for the quantification of these compounds in numerous matrices have been developed. This review intends to provide an updated overview of the recent trends over the past five years in sample preparation techniques and methods for detecting SAs. Examples of the sample preparation techniques, including liquid-liquid and solid-phase extraction, dispersive liquid-liquid microextraction and QuEChERS, are given. Different methods of detecting the SAs present in food and feed and in environmental, pharmaceutical and biological samples are discussed.

Label-free gold nanoparticles for the determination of neomycin.

A new spectrophotometric method for the determination of neomycin has been developed. The method is based on aggregation of label-free gold nanoparticles leading to change in absorption spectra and color of the solution. Influence of different factors (the concentration of ethylenediaminetetraacetate (EDTA), pH, the concentrations of neomycin and the nanoparticles) on the aggregation and analytical performance of the method was investigated. EDTA plays an important role not only as a masking agent to eliminate interferences of metal cations but strongly affects the sensitivity of the nanoparticles relative to neomycin. The method allows to determine neomycin with detection limit of 28ngmL(-1). It was applied to analysis of eye- and ear-drops. The sample pretreatment is simply done by diluting the formulation with water.

Kinetic approach for evaluation of total antioxidant activity.

We propose a novel approach for assessment of total antioxidant activity by monitoring kinetics of hydrogen peroxide (H(2)O(2)) scavenging after its injection into liquid sample under study. H(2)O(2) is known to be the strongest oxidant, really presented in human body in contrast to the majority of the model oxidative systems used for evaluation of antioxidant activity. In addition, kinetic approach, being more informative than the commonly used determination of the final product, obviously provides better discrimination of potential antioxidants. Prussian Blue based sensor due to its high sensitivity and operational stability allowed to monitor kinetics of hydrogen peroxide consumption in turbid and colored samples. The pseudo-first order kinetic constants of hydrogen peroxide scavenging in the presence of different food additives correlated with total antioxidant activity of these samples evaluated via standard procedure based on lipid peroxidation. However, in contrast to the standard method, the proposed kinetic approach is expressed and does not require fresh biological tissues.

Dissolution of cellulose in ionic liquids as a way to obtain test materials for metal-ion detection.

Cellulose films containing entrapped analytical reagents suitable for metal-ion detection are produced by joint dissolution of cellulose and the reagents in ionic liquids then precipitation with water. The conditions of preparation of these test materials have been optimized and their properties have been studied. The film obtained by use of the ionic liquid 1-butyl-3-methylimidazolium chloride and 1-(2-pyridylazo)-2-naphthol has been used for colorimetric determination of divalent zinc, manganese, and nickel with detection limits at the 10(-6) mol L-1 level.