RESUMEN
The goal of this research is to see how the amount and particle size of calcium carbonate (CaCO3) used in the foamed layer in use for PVC-coated textiles affects the thermal properties of the material. Two different particle sizes were used at various concentrations. The impact of different CaCO3 loadings and particle sizes on the PVC foamed layer's thermal properties were examined. Thermogravimetry (TGA and DTG) and differential scanning calorimetry (DSC) measurements were utilized to investigate the thermal properties of the PVC foamed layer and the samples have been also characterized by FTIR spectroscopy. According to the findings, the thermal stability of the foamed layer was improved with the addition of calcium carbonate. Through the higher surface area between the filler and the PVC matrix, smaller particle sizes have produced the best results. The PVC foamed layer shows also changes in FTIR spectra after adding CaCO3, and the intensity of peaks increases with decreasing CaCO3 particle size.
RESUMEN
The growing interest in environmentally friendly materials is leading to a re-evaluation of natural fibers for industrial applications in order to meet sustainability and low-cost objectives, especially for thermal insulation of buildings. This paper deals with the chemical and physical characterization of fibers extracted from seagrass (Posidonia oceanica) and alfa grass (Stipa tenacissima) for a possible substitution of synthetic materials for thermal insulation. Hemp (Cannabis sativa), a fiber broadly used, was also studied for comparison. The parameters characterized include porosity, thermal degradation, elemental composition, skeletal and particle density of the fibers as well as investigation of the thermal conductivity of fiber-based panels. Several technologies were involved in investigating these parameters, including mercury intrusion, thermogravimetric analysis, fluorescence spectroscopy, and fluid pycnometry. The fibers showed a degradation temperature between 316 and 340 °C for Posidonia, between 292 and 326 °C for alfa, and between 300 and 336 °C for hemp fibers. A high porosity allied with a reduced pore size was revealed for Posidonia (77%, 0.54 µm) compared to hemp (75%, 0.61 µm) and alfa (57%, 2.1 µm) raw fibers, leading to lower thermal conductivity values for the nonwoven panels based on Posidonia (0.0356-0.0392 W/m.K) compared to alfa (0.0365-0.0397 W/m.K) and hemp (0.0387-0.0427 W/m.K). Bulk density, operating temperature, and humidity conditions have been shown to be determining factors for the thermal performance of the panels.
RESUMEN
A new ascomycete fungus X5, a hyperproducer (9000â¯U/mL) of a serine alkaline protease (SAPTEX) was identified as Penicillium chrysogenum. The experimental purification protocol comprises three steps: heat treatment (10â¯min at 80⯰C) followed by an ammonium sulfate precipitation (30-50%)-dialysis, and a UNO Q-12 anion exchange chromatography using the FPLC system. The chemical characterizations performed include physico-chemical determination and spectroscopic analysis. The MALDI-TOF/MS analysis revealed that the purified enzyme was a monomer with a molecular mass of 43,074.11â¯Da. The 25 residue NH2-terminal sequence of the enzyme showed high homology with Penicillium proteases. The optimum pH and temperature values for protease activity were pHâ¯10 and 80⯰C, respectively. Compared to other proteases (SPTC; Flavourzyme® 500â¯L; Proteinase, type XXIII; Proteinase K; and Alcalase® 2.4â¯L), SAPTEX has the highest catalytic efficacy, hydrolysis degree, and a powerful stability toward some commercial detergents. According to morphological, physico-chemical [scanning electron microscopy (SEM), energy dispersive X-Ray analysis (EDX), and FTIR-Fourier transform infrared spectroscopy], and mechanical evaluation, SAPTEX has no destructive impact on fibers after the enzyme treatment and a very slight effect on textile support. Obtained results suggested that SAPTEX may be considered as a potential candidate as a protein stain removal product for textile supports.
