Production of highly antioxidant lignin nanoparticles from a hardwood technical lignin.

Eucalypt kraft lignin isolated in a LignoBoost™ pilot plant was characterized by GC-MS, ICP-OES, DSC, HPSEC, 31P NMR, and HSQC 2D-NMR to be used without any further processing to produce lignin nanoparticles (LNPs) by nanoprecipitation. Tetrahydrofuran (THF) was used as a solvent, and water as a non-solvent. Microscopic analysis (TEM) showed that LNPs were regularly spherical with some hollow particles dispersed in-between, and sizes were tunable by changing the solvent dripping rate onto the non-solvent. LNP particle sizes had a bimodal distribution, with the largest population having an average apparent hydrodynamic diameter ranging from 105.6 to 75.6 nm. Colloidal dispersions of LNPs in water presented good stability in different dilutions without significant size changes upon storage at pH close to neutral for as long as 45 days. Zeta potentials around -40 mV were obtained for LNP suspensions at pH ranging from 7 to 9. The high carbohydrate content (circa 10 % on a dry basis, mostly xylans) of the lignin precursor did not interfere in LNP formation, whose antioxidant activity was expressive as demonstrated by the ABTS assay at pH 7.4, with an EC50 of 4.04 µg mL-1. Also, the Trolox® equivalent antioxidant capacity (TEAC) of LNPs reached 1.90 after 40 min reaction time.

Towards epigenetic regulation of triple-negative breast cancer via ligand-mediated nanoparticles.

Aims: Develop and analyze triple-negative breast cancer targeted nanoparticles loaded with the demethylating agent decitabine. Materials & methods: The polymers were synthesized by ring-opening polymerization of D,L-lactide and formulated into nanoparticles via emulsion-evaporation method. The nanoparticles were characterized by physicochemical analysis as well as in vitro using breast cancer cell lineages. Results & conclusion: The targeted nanoparticles exhibited a hydrodynamic diameter of 75 ± 12 nm, zeta potential -6.3 ± 0.2 mV and spherical morphology, and displayed greater in vitro accumulation into MDA-MB-231 (triple-negative breast cancer cell-line) compared with MCF7 and HB4A cell lineages as verified by fluorescence confocal microscopy and significant demethylating effects via ADAM33 screening by PCR.

Ethanol organosolv pretreatment of sugarcane bagasse assisted by organic acids and supercritical carbon dioxide.

The scCO2-assisted organosolv pretreatment of sugarcane bagasse was carried out using aqueous ethanol and organic acid catalysts. Variables involved were temperature (150-190 °C), time (0-60 min), type of catalyst (acetic, citric, and oxalic acids), amount of CO2 (25-50 g), ethanol titer in water (0-80 vol%), and catalyst concentration (0.5 to 1.5 % w·v-1). The best delignification (86 wt%) and glucan retention (89 wt%) were achieved at 170 °C for 15 min using 60 vol% ethanol in water, 1 wt% oxalic acid, and 25 g CO2. Organic acid esterification was a limitation for pretreatment operations using ethanol titers above 60 vol%. Enzymatic hydrolysis of pretreated materials at 1 % (w·v-1) glucans released 74.3 ± 0.2 % glucose in 96 h using Cellic CTec3 (Novozymes) at 9.89 FPU·gglucans-1. The concentrated pretreatment liquor allowed lignin recovery by water precipitation in high yields, while the aqueous supernatant contained low levels of fermentation inhibitors.

Supercritical Fluids: A Promising Technique for Biomass Pretreatment and Fractionation.

Lignocellulosic biomasses are primarily composed of cellulose, hemicelluloses and lignin and these biopolymers are bonded together in a heterogeneous matrix that is highly recalcitrant to chemical or biological conversion processes. Thus, an efficient pretreatment technique must be selected and applied to this type of biomass in order to facilitate its utilization in biorefineries. Classical pretreatment methods tend to operate under severe conditions, leading to sugar losses by dehydration and to the release of inhibitory compounds such as furfural (2-furaldehyde), 5-hydroxy-2-methylfurfural (5-HMF), and organic acids. By contrast, supercritical fluids can pretreat lignocellulosic materials under relatively mild pretreatment conditions, resulting in high sugar yields, low production of fermentation inhibitors and high susceptibilities to enzymatic hydrolysis while reducing the consumption of chemicals, including solvents, reagents, and catalysts. This work presents a review of biomass pretreatment technologies, aiming to deliver a state-of-art compilation of methods and results with emphasis on supercritical processes.