First-order derivative UV spectrophotometric method for simultaneous measurement of delapril and manidipine in tablets.

A first-order derivative spectrophotometric (1D-UV) method was developed and validated for simultaneous determination of delapril (DEL) and manidipine (MAN) in tablets. The 1D-UV spectra were obtained using change lambda = 4.0 nm and wavelength set at 228 nm for DEL and 246 nm for MAN. The method was validated in accordance with the ICH requirements, involving the specificity, linearity, precision, accuracy, robustness and limits of detection and quantitation. The method showed high specificity in the presence of two drugs and formulation excipients and was linear over the concentration range of 18-54 microg mL(-1) (r2 = 0.9994) for DEL and 6-18 microg mL(-1) (r2 = 0.9981) for MAN with adequate results for the precision (< or = 1.47%) and accuracy (98.98% for DEL and 100.50% for MAN). Moreover, the method proved to be robust by a Plackett-Burman experimental design evaluation. The proposed 'D-UV method was successfully applied for simultaneous analysis of DEL and MAN in tablets and can be used as alternative green method to separation techniques. The results were compared with the validated liquid chromatography, capillary electrophoresis and liquid chromatography-tandem mass spectrometry methods, showing non-significant difference.

Determination of rupatadine in pharmaceutical formulations by a validated stability-indicating MEKC method.

A stability-indicating MEKC was developed and validated for the analysis of rupatadine in tablet dosage forms, using nimesulide as internal standard. The MEKC method was performed on a fused-silica capillary (50 microm id; effective length, 40 cm). The BGE consisted of 15 mM borate buffer and 25 mM anionic detergent SDS solution at pH 10. The capillary temperature was maintained at 35 degrees C and the applied voltage was 25 kV. The injection was performed using the hydrodynamic mode at 50 mbar for 5 s, with detection by photodiode array detector set at 205 nm. The method was linear in the range of 0.5-150 microg/mL (r2=0.9996). The specificity and stability-indicating capability of the method were proven through degradation studies inclusive by MS, and showing also that there was no interference of the excipients and no increase of the cytotoxicity. The accuracy was 99.98% with bias lower than 1.06%. The LOD and LOQ were 0.1 and 0.5 microg/mL, respectively. The proposed method was successfully applied for the quantitative analysis of rupatadine in pharmaceutical formulations, and the results were compared to a validated RP-LC method, showing non-significant difference (p>0.05).

Validation of the antifactor Xa and antifactor IIa assays for the potency assessment of nadroparin in pharmaceutical formulations.

The low-molecular weight heparin nadroparin calcium is used clinically for the prevention and treatment of venous and arterial thrombosis. The antifactor Xa and antifactor IIa assays were validated by investigating the parameters of range, linearity (r2 = 0.9905 and r2 = 0.9914, respectively) precision, accuracy, and robustness. The 2 methods incorporated a chromogenic endpoint and detection at 405 nm, yielding good results with detection limits of 0.004 and 0.01 IU/mL and quantitation limits of 0.01 and 0.03 IU/mL, respectively, for the antifactor Xa and antifactor IIa assays. Nadroparin calcium pharmaceutical products were evaluated by the antifactor Xa assay and the antifactor IIa assay, giving potencies between 93.86 and 109.88%, with an antifactor Xa/antifactor IIa ratio between 3.2 and 3.7. The results demonstrated the validity of the assays that are useful methodologies for the routine quality control of nadroparin in pharmaceutical formulations.