3D-printed electrodes using graphite/carbon nitride/polylactic acid composite material: A greener platform for detection of amaranth dye in food samples.

The production of sustainable materials with properties aimed at the additive manufacturing of electrochemical sensors has gained prestige in the scientific scenario. Here, a novel lab-made composite material using graphite (G) and carbon nitride (C3N4) embedded into polylactic acid (PLA) biopolymer is proposed to produce 3D-printed electrodes. PLA offers printability and mechanical stability in this composition, while G and C3N4 provide electrical properties and electrocatalytic sites, respectively. Characterizations by Raman and infrared spectroscopies and Energy Dispersive X-rays indicated that the G/C3N4/PLA composite was successfully obtained, while electron microscopy images revealed non-homogeneous rough surfaces. Better electrochemical properties were achieved when the G/C3N4/PLA proportion (35:5:60) was used. As a proof of concept, amaranth (AMR), a synthetic dye, was selected as an analyte, and a fast method using square wave voltammetry was developed. Utilizing the 3D-printed G/C3N4/PLA electrode, a more comprehensive linear range (0.2 to 4.2 µmol/L), a 5-fold increase in sensitivity (9.83 µmol-1 L µA), and better limits of detection (LOD = 0.06 µmol/L) and quantification (LOQ = 0.18 µmol/L) were achieved compared to the G/PLA electrode. Samples of jelly, popsicles, isotonic drinks, and food flavoring samples were analyzed, and similar results to those obtained by UV-vis spectrometry confirmed the method's reliability. Therefore, the described sensor is a simple, cost-effective alternative for assessing AMR in routine food analysis.

Modified dry bean pod waste (Phaseolus vulgaris) as a biosorbent for fluorescein removal from aqueous media: Batch and fixed bed studies.

This study presents the use of dry bean pods as a solid phase for fluorescein removal from water. The non-pretreated solid phase did not display any sorption properties for the chosen dye. However, interesting sorption properties were observed following a chemical derivative treatment with nitric acid. The study was carried out using both batch and column approaches. Regarding the batch study, all parameters that influence sorption capacity, such, as pH, adsorbent mass, ionic strength, temperature and contact time, were evaluated. A sorptive capacity of 36.80 mg g-1 was obtained in the optimized condition. In the fixed column bed study, the influence of particle size, flow rate and initial concentration of the dye were evaluated through breakthrough curves and a sorptive capacity of 4.35 mg g-1 was obtained. Thermodynamic studies revealed that the adsorption is exothermic and spontaneous. Four different models, Langmuir, Freundlich, Temkin and Redlich-Patterson, were employed. The Akaike information criterion (AIC) was employed to rank the best equilibrium model, which was determined as the Freundlich isotherm. The method was applied to a real sample and the same removal rate was obtained, thus indicating its suitability to wastewater treatment.