Design of an activity and stability improved carbonyl reductase from Candida parapsilosis.

The carbonyl reductase from Candida parapsilosis (CPCR2) is an industrially attractive biocatalyst for producing chiral alcohols from ketones. The homodimeric enzyme has a broad substrate spectrum and an excellent stereoselectivity, but is rapidly inactivated at aqueous-organic interfaces. The latter limits CPCR2's application in biphasic reaction media. Reengineering the protein surface of CPCR2 yielded a variant CPCR2-(A275N, L276Q) with 1.5-fold increased activity, 1.5-fold higher interfacial stability (cyclohexane/buffer system), and increased thermal resistance (ΔT50=+2.7 °C). Site-directed and site-saturation mutagenesis studies discovered that position 275 mainly influences stability and position 276 governs activity. After single site-saturation of position 275, amino acid exchanges to asparagine and threonine were discovered to be stabilizing. Interestingly, both positions are located at the dimer interface and close to the active site and computational analysis identified an inter-subunit hydrogen bond formation at position 275 to be responsible for stabilization. Finally, the variant CPCR2-(A275S, L276Q) was found by simultaneous site-saturation of positions 275 and 276. CPCR2-(A275S, L276Q) has compared to wtCPCR2 a 1.4-fold increased activity, a 1.5-fold higher interfacial stability, and improved thermal resistance (ΔT50=+5.2 °C).

Encapsulation of synthetically valuable biocatalysts into polyelectrolyte multilayer systems.

Layer-by-Layer (LbL) technology recently turned out to be a versatile tool for the encapsulation of bioactive entities. In this study, the factual potential of this technology to encapsulate synthetically valuable biocatalysts, that is enzymes and whole cells expressing a specific catalytic activity, was investigated. The biocatalysts were embedded into a polyelectrolyte multilayer system involving poly(allylamine) hydrochloride (PAH) and poly(styrene sulfonate) sodium salt (PSS). The enzymes were adsorbed to CaCO3 or DEAE-cellulose previous to encapsulation. A slight increase (32%) of the catalytic performance was observed for lipase B from Candida antarctica when four layers of polyelectrolytes were applied. On the whole, however, the residual activity of the investigated enzymes after encapsulation was rather low. Similar results were obtained with whole-cell biocatalysts. It was found that the activity decrease can be attributed to mass transfer restrictions as well as direct interactions between polyelectrolytes and catalytically active molecules. Both effects need to be understood in more detail before LbL technology can be advanced to technically efficient biocatalysis.

Biphasic mini-reactor for characterization of biocatalyst performance.

Biphasic reaction media are extending the scope of technical biocatalysis. Thorough investigation of the factors affecting catalyst performance under these conditions is of key importance for the successful implementation of catalytic processes. Here, we present a reactor setup suitable for comprehensive systematic characterization and optimization of biocatalyzed reactions in biphasic systems with distinct phases. It is distinguished by small volumes allowing reproducible experimentation with minimum amounts of solvent and catalyst. The interfacial area is kept constant and independent stirring of both phases is allowed in order to minimize superimposing effects. Evaporation of low-volatile organic solvents is prevented by use of airtight construction. The broad applicability of this mini-reactor is demonstrated with regard to determination of mass transfer, enzyme productivity, and enzyme stability in both batch and continuous mode.