Ambient air quality changes after stubble burning in rice-wheat system in an agricultural state of India.

Ground-based ambient air monitoring was conducted to assess the contribution of crop residue burning of wheat (Triticum aestivum) and rice (Oriza sativa) at different locations in three districts (Kaithal, Kurukshetra, and Karnal) of the agricultural state of Haryana in India for two successive years (2016 and 2017). The Air Quality Index (AQI) and concentration of primary pollutants (SOx, NOx, and PM2.5) were determined in rice and wheat crop season, for burning and non-burning periods. During crop residue burning periods, concentrations of SOx, NOx, and PM2.5 were exceeded the NAAQS values by 78%, 71%, and 53%, respectively. A significant increase in SOx (4.5 times), NOx (3.8 times), and PM2.5 concentration (3.5 times) was observed in stubble burning periods as compared to pre-burning (p < 0.05). A positive and significant correlation among the three pollutant concentrations was observed (p < 0.01). The AQI of KA site in Karnal district fell in severely polluted category during 2016 for rice as well as wheat residue burning period, and of KK site in Kaithal during wheat residue burning in year 2017. Results of present study indicate a remarkable increase in pollutant concentration (SOx, NOx, and PM2.5) during the crop residue burning periods. To the best of our knowledge, the outcomes of present study in this region have not been reported in earlier reports. Hence, there is an urgent need to curb air pollution by adopting sustainable harvesting technologies and management of residues.

Investigation of compound-independent calibration and partial molecular formula determination by gas chromatography-atomic-emission detection for characterisation of organophosphorus and organosulfur agents related to the chemical weapons convention.

Atomic-emission detection (AED) is a technique particularly-well suited to screening complex samples for multiple compounds containing heteroatoms such as phosphorus, sulfur, or nitrogen, which are especially relevant in verification of chemical disarmament. Among other GC detectors, AED has unique characteristics such as compound-independent calibration and possible raw-formula determination. Because contradictory results have been reported on these points, we set up a study with the objectives not only of applying these techniques to chemical weapons convention-related chemicals but of determining under which conditions they would yield satisfactory results. The extensive data collected in this study are evidence that the response of the detector, particularly for the phosphorus line, is very dependent on the molecular mass and concentration of the chemicals analysed whereas molecular structure seems to have less effect on the AED signal. Most interestingly, compound-independent calibration and subsequent partial molecular formula determination usually seem satisfactory when the reference compounds used to calibrate the system have GC retention times and molecular masses close to those of the unknown analytes (whose molecular mass may be determined by GC-CI-MS). We therefore suggest the use of a reference set of compounds covering a large chromatographic window, which enables the selection, within this set, of the most appropriate reference compound for calibration and for determination of the raw formula of an unknown analyte. For optimal performance, the use of a new discharge tube is also recommended.

Analysis of aromatic sulfur compounds in gas oils using GC with sulfur chemiluminescence detection and high-resolution MS.

The analysis of alkylbenzothiophenes (alkyl-BT) and alkyl-dibenzothiophenes (alkyl-DBT) in light cycle oil (LCO) and straight run (SR) gas oils is described. A detailed identification and quantitative analysis of alkyl-BT and alkyl-DBT present in LCO gas oils was carried out using GC-SCD. For the SR gas oils, the simultaneous presence of thiophenic and nonthiophenic compounds does not allow for a selective analysis of thiophenic compounds by GC-SCD. A new method using gas chromatography coupled with high-resolution mass spectrometry (GC-HRMS) is proposed to selectively detect and quantify the alkyl-BT and alkyl-DBT in SR gas oils. The development of the method and comparison of results between GC-SCD and GC-HRMS are presented.

Chinese life cycle impact assessment factors.

The methodological basis and procedures for determination of Chinese normalization references and weighting factors according to the EDIP-method is described. According to Chinese industrial development intensity and population density, China was divided into three regions and the normalization references for each region were calculated on the basis of an inventory of all of the region's environmental emissions in 1990. The normalization reference was determined as the total environmental impact potential for the area in question in 1990 (EP(j)90) divided by the population. The weighting factor was determined as the normalization reference (ER(j)90) divided by society's target contribution in the year 2000 based on Chinese political reduction plans, ER(j)T2000. This paper presents and discuss results obtained for eight different environmental impact categories relevant for China: global warming, stratospheric ozone depletion, acidification, nutrient enrichment, photochemical ozone formation and generation of bulk waste, hazardous waste and slag and ashes.