Flow cytometry of Escherichia coli on microfluidic devices.

Flow cytometry of the bacterium Escherichia coli was demonstrated on a microfabricated fluidic device (microchip). The channels were coated with poly(dimethylacrylamide) to prevent cell adhesion, and the cells were transported electrophoretically by applying potentials to the fluid reservoirs. The cells were electrophoretically focused at the channel cross and detected by coincident light scattering and fluorescence. The E. coli were labeled with a membrane-permeable nucleic acid stain (Syto15), a membrane-impermeable nucleic acid stain (propidium iodide), or a fluorescein-labeled antibody and counted at rates from 30 to 85 Hz. The observed labeling efficiencies for the dyes and antibody were greater than 94%.

Electroosmotically induced hydraulic pumping with integrated electrodes on microfluidic devices.

Electroosmotic manipulation of fluids was demonstrated using thin metal electrodes integrated within microfluidic channels at the substrate and cover plate interface. Devices were fabricated by photolithographically patterning electrodes on glass cover plates that were then bonded to polymeric substrates into which the channels were cast. Polymeric substrates were used to provide a permeable membrane for the transport and removal of gaseous electrolysis products generated at the electrodes. Electroosmotic flow between interdigitated electrodes was demonstrated and provided electric field-free pumping of fluids in sections of the channel outside of the electrode pairs. The resultant pumping velocities were shown to be dependent on the applied voltage, not on the applied field strength, and independent of the length of the electroosmotically pumped region.

Two-dimensional electrochromatography/capillary electrophoresis on a microchip.

A two-dimensional separation system on a microfabricated device was demonstrated using open-channel electrochromatography as the first dimension and capillary electrophoresis as the second dimension. The first dimension was operated under isocratic conditions, and the effluent from the first dimension was repetitively injected into the second dimension every few seconds. A 25-cm separation channel with spiral geometry for open-channel electrochromatography was chemically modified with octadecylsilane and coupled to a 1.2-cm straight separation channel for capillary electrophoresis. Fluorescently labeled products from tryptic digests of beta-casein were analyzed in 13 min with this system.

Integrated microchip-device for the digestion, separation and postcolumn labeling of proteins and peptides.

A microchip device was demonstrated that integrated enzymatic reactions, electrophoretic separation of the reactants from the products and post-separation labeling of proteins and peptides prior to detection. A tryptic digestion of oxidized insulin B-chain was performed in 15 min under stopped flow conditions in a heated channel, and the separation was completed in 1 min. Localized thermal control of the reaction channel was achieved using a resistive heating element. The separated reaction products were then labeled with naphthalene-2,3-dicarboxaldehyde (NDA) and detected by laser-induced fluorescence. A second reaction at elevated temperatures was also demonstrated for the on-chip reduction of disulfide bridges using insulin as a model protein. This device represents one of the highest levels, to date, of monolithic integration of chemical processes on a microchip.

Microchip devices for high-efficiency separations.

We have fabricated a 25-cm-long spiral-shaped separation channel on a glass microchip with a footprint of only 5 cm x 5 cm. Electrophoretic separation efficiencies for dichlorofluoroscein (DCF) on this chip exceeded 1,000,000 theoretical plates and were achieved in under 46 s at a detection point 22.2 cm from the injection cross. The number of theoretical plates increased linearly with the applied voltage, and at a separation field strength of 1,170 V/cm, the rate of plate generation was approximately 21,000 plates/s. The large radii of curvature of the turns minimized the analyte dispersion introduced by the channel geometry as evidenced by the fact that the effective diffusion coefficient of DCF was within a few percent of that measured on a microchip with a straight separation channel over a wide range of electric field strengths. A micellar electrokinetic chromatography separation of 19 tetramethylrhodamine-labeled amino acids was accomplished in 165 s with an average plate number of 280,000. The minimum resolution between adjacent peaks for this separation was 1.2.

Effects of the electric field distribution on microchip valving performance.

Valving characteristics on microfluidic devices were controlled through manipulation of the electric field strengths during both the sample loading and dispensing steps. Three sample loading profiles for the constant volume valve (pinched injection) in conjunction with four dispensing schemes were investigated to study valving performance. The sample confinement profiles for the sample loading step consisted of a weakly pinched sample, a medium pinched sample, and a strongly pinched sample. Four dispensing schemes varied the electric field strengths in the sample and sample waste channels relative to the analysis channel to control the volume of the sample dispensed from the valve. The axial extent of the sample plug decreased as the electric field strengths in the sample and sample waste channels were raised relative to the analysis channel. In addition, a trade-off existed between sample plug length and sensitivity.

Microchip flow cytometry using electrokinetic focusing.

Flow cytometry of fluorescently labeled and unlabeled latex particles is demonstrated on a microfabricated device. The latex particles were detected and counted using laser light scattering and fluorescence coincidence measurements. Sample confinement was accomplished using electrokinetic focusing at a cross intersection, and detection occurred 50 µm downstream from the intersection. Particles with diameters of 1 and 2 µm were analyzed and distinguished from each other based on their light scattering intensity and fluorescence. A maximum sample throughput of 34 particles/s was achieved. Sample mixtures with varying proportions of fluorescently labeled and unlabeled particles were also analyzed and found to be within experimental error of the expected ratios.

Lowering the UV Absorbance Detection Limit in Capillary Zone Electrophoresis Using a Single Linear Photodiode Array Detector.

A new approach for lowering the UV absorbance detection limit in capillary electrophoresis is presented. This approach involves the use of a photodiode array in which each of the diodes in the array is treated as an independent detector. Over the course of a run, therefore, an electropherogram is generated for each diode in the array. Averaging the electropherograms generated from 1500 diodes in a diode array resulted in a signal-to-noise ratio 85 times that of an electropherogram generated from any one diode in the array. These signal-to-noise improvements are discussed, and the detection limits are compared to the detection limits obtained from a commercial single-point detector. The array detector improves the detection limit by a factor of 3.8 (±0.4).

Synthesis and pharmacology of irreversible affinity labels as potential cocaine antagonists: aryl 1,4-dialkylpiperazines related to GBR-12783.

As part of a program aimed at designing irreversible antagonists of the stimulant and reinforcing properties of cocaine, derivatives of GBR-12783 containing electrophilic substituents were synthesized. GBR-12783, a potent and selective inhibitor of both stimulant binding and dopamine transport, was modified to incorporate either isothiocyanate or maleimido groups at the meta- or para-positions in one phenyl ring of the geminal diphenyl portion of the molecule. The effect of these compounds, as well as their respective amino- or nitro-substituted precursors, on stimulant binding to rat striatal tissue was studied using the [3H]methylphenidate radioreceptor assay. Under the assay conditions used, the compounds were found to have IC50s (nM) ranging from 11.9 (m-nitro) to 1677 (p-maleimido); the parent compound, GBR-12783, had an IC50 of 12.0. Using a washout technique (repeated washing with 100 mM KCl) which completely removed the tightly bound, but reversible GBR-12783, both the m- and p-isothiocyanate compounds were found to irreversibly inhibit binding of [3H]methylphenidate to the stimulant recognition site. The m-maleimido derivative also irreversibly inhibited binding, albeit with lower efficacy than was observed with the isothiocyanate compounds. Neither the p-maleimido, nor the amino or nitro intermediates, were capable of irreversible inhibition.