Impact of native vegetation and soil moisture dynamics on evapotranspiration in green roof systems.

Evapotranspiration (ET) is an important water budget term for understanding the recovery of stormwater retention in green roof systems (GRs). However, ET evaluations, particularly in full-scale GRs, remain challenging. This study investigated ET dynamics within a GR in the City of Pittsburgh, USA, using a water balance based on continuously monitored soil moisture from moisture sensors over 15 months. Results suggest under well-watered soil conditions, daily moisture loss correlated with solar radiation, temperature, and humidity, in decreasing order of correlation strength, while wind speed had limited effects. Compared to sensor-informed moisture loss (using moisture-based water balance), the Hargreaves and FAO-56 Penman-Monteith equations predicted cumulative ET that was 1.8 and 2.1 times higher, respectively. When soil moisture declined and approached the temporary wilting points, a noticeable reduction in daily moisture loss was observed. This suggests the necessity of using a water stress coefficient alongside a crop coefficient to represent actual ET based on FAO-56 Penman-Monteith estimates. Seasonal crop coefficients from dominant native plant species present at our monitored location, eastern bluestar (Amsonia tabernaemontana) and creeping woodsorrel (Oxalis corniculata), had mean values of 0.48, 0.62, and 0.65 for fall, spring, and summer, respectively. The impact of water stress on ET could be characterized by a linear relationship with moisture content. Our results highlight the importance of soil moisture in regulating ET processes and demonstrate the utility of soil moisture data for evaluating ET in GRs and informing irrigation practices.

Evaluating the Thiessen polygon approach for efficient parameterization of urban stormwater models.

Catchment discretization plays a key role in constructing stormwater models. Traditional methods usually require aerial or topographic data to manually partition the catchment, but this approach is challenging in areas with poor data access. Here, we propose an alternative approach, by drawing Thiessen polygons around sewer nodes to construct a sewershed model. The utility of this approach is evaluated using the EPA's Storm Water Management Model (SWMM) to simulate pipe flow in a sewershed in the City of Pittsburgh. Parameter sensitivities and model uncertainties were explored via Monte Carlo simulations and a simple algorithm applied to calibrate the model. The calibrated model could reliably simulate pipe flow, with a Nash-Sutcliffe efficiency (NSE) of 0.82 when compared to measured flow. The potential influence of sewer data availability on model performance was tested as a function of the number of nodes used to build the model. No statistical differences were observed in model performance when randomly reducing the number of nodes used to build the model (up to 40%). Based on our analyses, the Thiessen polygon approach can be used to construct urban stormwater models and generate good pipe flow simulations even for sewer data limited scenarios.