The expression of anaerobic metabolites in sweat and sebum from human skin subjected to intermittent and continuous mechanical loading.

Pressure ulcers (PUs) represent a substantial burden to both patients and healthcare providers. Accordingly, effective prevention strategies should follow early detection of PUs. Anaerobic metabolites, such as lactate and pyruvate, are promising noninvasive biomarkers indicative of tissue ischaemia, one of the major mechanisms leading to PU development. The aim of this study was to investigate if the temporal release profile of these metabolites in sweat and sebum is sensitive to detect local tissue changes resulting from prolonged mechanical loads. The sacrum of healthy volunteers was subjected to two different loading protocols. After a baseline measurement, the left and right side of the sacrum were subjected to continuous and intermittent loading regimen, respectively, at a pressure of 100 mmHg. Biomarker samples were collected every 20 min, with a total experimental time of 140 min. Sweat was collected at 37 ∘C and 80% relative humidity, and sebum at ambient conditions, from 11 to 13 volunteers, respectively. Both samples were analysed for lactate and pyruvate concentrations using ultra-high performance supercritical fluid chromatography mass spectrometry. Prior to analysis metabolite concentrations were normalized to individual baseline levels and, in the case of sweat, additional normalization was performed to an unloaded control site to account for fatigue of sweat glands. Although substantial variability was present, the temporal release profiles of both sweat and sebum metabolites reflected the applied loading regimen with increased levels upon load application, and recovery to baseline levels following load removal. Highest relative increases were 20% and 30% for sweat lactate and pyruvate, respectively, and 41% for sebum lactate. Sebum pyruvate was not present in quantifiable amounts. There was a linear correlation between the individual responses to intermittent and continuous loading. The present study revealed that metabolite biomarkers in both sweat and sebum were sensitive to the application of mechanical loads, indicative of local ischaemia within skin and soft tissues. Similar trends in metabolic biomarkers were observed in response to intermittent and continuous loading regimens in both sweat and sebum. Metabolites represent a potential means to monitor the health of loaded skin and soft tissues informing timely interventions of PU prevention.

Polyhydroxyalkanoate (PHA) biosynthesis from structurally unrelated carbon sources by a newly characterized Bacillus spp.

A newly acquired polyhydroxyalkanoate (PHA) producing Bacillus spp. was identified to be a strain of Bacillus cereus using a range of microbiological and molecular techniques. This strain, named B. cereus SPV, was found to be capable of using a wide range of carbon sources including glucose, fructose, sucrose, various fatty acids and gluconate for the production of PHAs, an advantage for the commercial production of the polymers. The media used for the polymer production was novel in the context of the genus Bacillus. The PHA, once produced, was found to remain at a constant maximal concentration, without any degradation, a great advantage for the commercial production of the PHAs. This particular strain of Bacillus spp. was able to synthesize various PHAs with 3-hydroxybutyrate (3HB), 3-hydroxyvalerate (3HV) and 4-hydroxybutyrate (4HB)-like monomer units from structurally unrelated carbon sources such as fructose, sucrose and gluconate. This is the first report of the incorporation of a 4HB related monomer containing PHA by the genus Bacillus and from structurally unrelated carbon sources. The PHAs isolated had molecular weights ranging between (0.4 and 0.8) x 10(6) and low polydispersity index values (M(W)/M(N)) ranging from 2.6 to 3.4.

Simplified sample preparation for the analysis of oligonucleotides by matrix-assisted laser desorption/ionisation time-of-flight mass spectrometry.

Matrix-assisted laser desorption/ionisation time-of-flight mass spectrometry (MALDI-TOFMS) for the analyses of oligonucleotides has generally been carried out using negative ionisation conditions, usually following ammonium ion-exchange chromatography and the addition of ammonium buffers to the MALDI matrix. The molecular ion region is complex, due to the varying degrees of ammoniation of the phosphate backbone of the oligonucleotide. This gives rise to an overall decrease in sensitivity compared with similar size peptides and can cause ambiguity of assignment of the relative molecular mass of the sample. This study describes the use of H(+) ion exchange resin in situ as the means of removing alkali metal ions from the phosphate backbone of the oligonucleotide. An increase in resolution, sensitivity and identification of the molecular species is reported, with little or no difference in sensitivity observed between positive or negative ionisation spectra. This method is now used for routine screening of synthetic oligonucleotides with a gain in sensitivity of 1-2 orders of magnitude compared with previous methods, and mass assignment errors of +/-0.1% are routinely recorded for externally calibrated data.