Real-time transmission of 16 Tb/s over 1020km using 200Gb/s CFP2-DCO.

We demonstrate real-time transmission of 16 Tb/s (80x200Gb/s) over 1020km TeraWave ULL fiber with 170km span length using the world's first 200Gb/s CFP2-DCO module with a record low power consumption less than 0.1W/Gbps.

800Gb/s (8x128Gb/s) unrepeatered transmission over 515-km large-area ultra-low-loss fiber using 2nd-order Raman pumping.

We demonstrate unrepeatered transmission of 8x128Gb/s PDM-QPSK signals over a 515k-m fiber link. This ultra-long distance of 800 Gb/s unrepeatered transmission in a single fiber configuration is achieved by employing enabling techniques such as large-effective-area ultra-low-attenuation fibers, co-propagating and counter-propagating 2nd-order-pumped distributed Raman amplification, and remote optically pumped amplifier (ROPA). The ROPA itself is also counter-propagating 2nd-order Raman pumped. The designs and characteristics of the ROPA and 2nd-order pumped distributed Raman amplification are described, and optimization of the transmission performance of this ultra-long reach 800Gb/s unrepeatered transmission fiber link is discussed in this paper.

All-fiber mode-group-selective photonic lantern using graded-index multimode fibers.

We demonstrate the first all-fiber mode-group-selective photonic lantern using multimode graded-index fibers. Mode selectivity for mode groups LP(01), LP(11) and LP(21)+LP(02) is 20-dB, 10-dB and 7-dB respectively. The insertion loss when butt coupled to multimode graded-index fiber is below 0.6-dB. The use of the multimode graded-index fibers in the taper can significantly reduce the adiabaticity requirement.

Mode-multiplexed transmission over conventional graded-index multimode fibers.

We present experimental results for combined mode-multiplexed and wavelength multiplexed transmission over conventional graded-index multimode fibers. We use mode-selective photonic lanterns as mode couplers to precisely excite a subset of the modes of the multimode fiber and additionally to compensate for the differential group delay between the excited modes. Spatial mode filters are added to suppress undesired higher order modes. We transmit 30-Gbaud QPSK signals over 60 WDM channels, 3 spatial modes, and 2 polarizations, reaching a distance of 310 km based on a 44.3 km long span. We also report about transmission experiments over 6 spatial modes for a 17-km single-span experiment. The results indicate that multimode fibers support scalable mode-division multiplexing approaches, where modes can be added over time if desired. Also the results indicate that mode-multiplexed transmission distance over 300 km are possible in conventional multimode fibers.

Wavelength-selective switch with direct few mode fiber integration.

The first realization of a wavelength-selective switch (WSS) with direct integration of few mode fibers (FMF) is fully described. The free-space optics FMF-WSS dynamically steers spectral information-bearing beams containing three spatial modes from an input port to one of nine output ports using a phase spatial light modulator. Sources of mode dependent losses (MDL) are identified, analytically analyzed and experimentally confirmed on account of different modal sensitivities to fiber coupling in imperfect imaging and at spectral channel edges due to mode clipping. These performance impacting effects can be reduced by adhering to provided design guidelines, which scale in support of higher spatial mode counts. The effect on data transmission of cascaded passband filtering and MDL build-up is experimentally investigated in detail.

Left ventricular assist device as a bridge to patient and myocardial recovery.

This article reviews the effects of chronic left ventricular assist device implantation on functional changes in patients with end-stage heart disease. Functional recovery can be measured by using response to exercise, quality-of-life surveys, improvements in noncardiac organ function, or changes in metabolic and neurohormonal levels. Recovery in intrinsic function of the heart can be assessed by changes in cardiac pump function or in baseline histological or biochemical abnormalities. Improvements in all of these areas have been found, although many reported studies are limited by a small sample size from selected subsets of patients rather than consecutive series.

Comparison of functional capacity in patients with end-stage heart failure following implantation of a left ventricular assist device versus heart transplantation: results of the experience with left ventricular assist device with exercise trial.

BACKGROUND: Use of a permanent left ventricular assist device (LVAD) has been proposed as an alternate treatment of patients with end-stage heart failure. The purpose of this study was to compare the functional capacity of patients following implantation of a LVAD vs heart transplant (HTx). METHODS: Eighteen patients from 6 centers who received an intracorporeal LVAD as a bridge to HTx underwent treadmill testing 1 to 3 months post-LVAD and again post-HTx. Baseline and peak measurements, including oxygen consumption, blood pressures, and respiratory rate were made during each treadmill test. RESULTS: Peak oxygen consumption was 14.5+/-3.9 ml/kg/minute post-LVAD and 17.5+/-5.0 ml/kg/minute post-HTx (p < .005). The percentage of the predicted peak oxygen consumption based on gender, weight, and age was 39.5%+/-5.5% post-LVAD and 47.7%+/-10.9% post-HTx (p < .005). Exercise duration was lower post-LVAD than post-HTx (10.3+/-4.2 minute vs 12.5+/-5.4 minute, p < .05). After LVAD implantation, peak total oxygen consumption correlated with peak LVAD rate and output. Eight patients reached an LVAD rate of 120 beats per minute (bpm) before the conclusion of exercise, the maximum rate for the outpatient electric device. The peak respiratory exchange ratio post-LVAD was 1.15+/-0.22 and post-HTx was 1.15+/-0.18, consistent with a good effort in both groups. CONCLUSIONS: Patients demonstrated a lower functional capacity post-LVAD than post-HTx. For some patients functional capacity post-LVAD may be improved by a higher maximum LVAD rate and output.

Long-term survival with use of percutaneous extracorporeal life support in patients presenting with acute myocardial infarction and cardiovascular collapse.

Up to 10% of patients who arrive at the hospital with acute myocardial infarction (AMI) present with or develop cardiogenic shock. Some patients, despite inotropes and intra-aortic balloon pump (IABP) placement, are not hemodynamically stable enough to undergo emergent revascularization. The use of percutaneous extracorporeal life support (ECLS) can stabilize patients to allow effective therapy. In a retrospective review of the first 100 patients emergently placed on ECLS by a nurse-supported physician insertion technique at Sharp Memorial Hospital, 10 patients underwent placement of ECLS after out-of hospital AMI. All AMI patients required intubation for respiratory failure and temporary CPR for cardiovascular collapse before initiation of ECLS. Of the 10 AMI patients placed on ECLS, four (40%) are currently long-term survivors (5.1 +/- 4.2 years; range, 6 months to 11 years). All survivors underwent successful revascularization after placement on ECLS. The cause of death in the other six patients was neurologic insufficiency in two, ineffective ECLS in two, and recurrent cardiovascular collapse after weaning from bypass in two. Total CPR time before initiation of cardiopulmonary bypass was 17 +/- 10.3 minutes for the survivors and 54.2 +/-11.1 minutes for the nonsurvivors (p < 0.001). The average time on ECLS was 29 +/- 26 hours for the survivors and 30 +/-67 hours for the nonsurvivors (p = NS). Leg complications were common among long-term survivors, associated with the use of ECLS (three ischemia, one infection). After AMI and cardiovascular collapse, insertion of ECLS may permit long-term patient survival.

Femtosecond dynamics of electrons on surfaces and at interfaces.

Two-photon photoemission is a promising new technique that has been developed for the study of electron dynamics at interfaces. A femtosecond laser is used to both create an excited electronic distribution at the surface and eject the distribution for subsequent energy analysis. Time- and momentum-resolved two-photon photoemission spectra as a function of layer thickness fully determine the conduction band dynamics at the interface. Earlier clean surface studies showed how excited electron lifetimes are affected by the crystal band structure and vacuum image potential. Recent studies of various insulator/metal interfaces show that the dynamics of excess electrons are largely determined by the electron affinity of the adsorbate. In general, electron dynamics at the interface are influenced by the substrate and adlayer band structures, dielectric screening, and polaron formation in the two-dimensional overlayer lattice.