ABSTRACT
This study investigated the effect of calcium chloride (CaCl2) combined with acetic acid (AA) pretreatment on the oil absorption of potato chips and explored the possible mechanisms influencing oil absorption. Results indicated that compared with hot water blanching, the combination of 0.3% CaCl2 blanching and AA soaking for 2-8 h pretreatment was found to reduce oil content by 10.52%-12.68% and significantly improve the crispness and color of fried potato chips. Microstructural and textural analyses revealed that the main reason for the reduction in oil content was the promotion of pectin gelation in the cell wall by CaCl2 and AA. However, it was observed that prolonged AA soaking time and high-concentration CaCl2 blanching led to an increase in total oil content and decrease in brittleness. Based on the results of surface roughness and moisture content analyses, it was suggested that the CaCl2 and AA pretreatments affected surface roughness and moisture content, thereby increasing oil absorption and reducing brittleness during frying.
Subject(s)
Acetic Acid , Calcium Chloride , Cooking , Solanum tuberosum , Acetic Acid/chemistry , Solanum tuberosum/chemistry , Calcium Chloride/chemistry , Plant Oils/chemistry , Hot Temperature , Food Handling , AbsorptionABSTRACT
We demonstrated a high-performance partially corrugated waveguide distributed feedback (PCW-DFB) laser with high output power, low relative intensity noise (RIN) and narrow linewidth. By introducing offset quantum-well structure that provides enough threshold gain difference for single transverse mode operation, the laser can achieve single mode behavior with an 8-µm-wide ridge waveguide. The laser has been designed by the simulation model based on the coupled wave equations, and the fabricated PCW-DFB laser with the cavity length of 1.3 mm exhibited an output power higher than 190â mW. Stable single mode characteristics have been achieved with a side-mode suppression-ratio (SMSR) over 55â dB. The RIN was less than -160.5â dB/Hz at an injection current of 470â mA, and the linewidth reached 45 kHz.
ABSTRACT
Surface profiles are important evaluation indices for oil absorption behavior of fried foods. This research established two intelligent models of partial least-squares regression (PLSR) and back propagation artificial neural network (BP-ANN) for monitoring the oil absorption behavior of French fries based on the surface characteristics. Surface morphology and texture of French fries by rapeseed oil (RO) and high-oleic peanut oil (HOPO) at different temperatures were investigated. Results showed that oil content of samples increased with frying temperature, accounting for 37.7% and 41.4% of samples fried by RO and HOPO respectively. The increase of crust ratio, roughness and texture parameters (Fm, Nwr, fwr, Wc) and the decrease of uniformity were observed with the frying temperature. Coefficients of prediction set of PLSR and BP-ANN models were more than 0.93, which indicated that surface features combined with chemometrics were rapid and precise methods for determining the oil content of French fries.
Subject(s)
Cooking , Solanum tuberosum , Cooking/methods , Rapeseed Oil , Peanut Oil , Hot TemperatureABSTRACT
The ancient anti-alcohol drug disulfiram (DSF) has gained widespread attention for its highly effective anti-tumor effects in cancer treatment. Our previous studies have developed liposome of Cu (DDC)2 to overcome the limitations, like the poor water solubility. However, Cu (DDC)2 liposomes still have shown difficulties in severe hemolytic reactions at high doses and systemic toxicity, which have limited their clinical use. Therefore, this study aims to exploratively investigate the feasibility of using DSF or DDC in combination also can chelate Zn2+ to form zinc diethyldithiocarbamate (Zn (DDC)2). Furthermore, this study prepared stable and homogeneous Zn (DDC)2 liposomes, which were able to be released in the tumor microenvironment (TME). The released Zn (DDC)2 was converted to Cu (DDC)2 with the help of endogenous Cu2+-switch enriched in the TME, which has a higher stability constant compared with Zn (DDC)2. In other words, the Cu2+-switch is activated at the tumor site, completing the conversion of the less cytotoxic Zn (DDC)2 to the more cytotoxic Cu (DDC)2 for effective tumor therapy so that the Zn (DDC)2 liposomes in vivo achieved the comparable therapeutic efficacy and provided a safer alternative to Cu (DDC)2 liposomes in cancer therapy.