In situ and ex situ study of the enhanced modification with iron of clinoptilolite-rich zeolitic tuff for arsenic sorption from aqueous solutions.

Adsorption methods have been developed for the removal of arsenic from solution motivated by the adverse health effects of this naturally occurring element. Iron exchanged natural zeolites are promising materials for this application. In this study we introduced iron species into a clinoptilolite-rich zeolitic tuff by the liquid exchange method using different organic and inorganic iron salts after pretreatment with NaCl and quantified the iron content in all trials by XRF spectroscopy. The materials were characterized by XRD, FTIR, FTIR-DR, UV-vis, cyclic voltammetry, ESR and Mössbauer spectroscopies before and after adsorption of arsenite and arsenate. The reached iron load in the sample T+Fe was %Fe(2)O(3)-2.462, n(Fe)/n(Al)=0.19, n(Si)/n(Fe)=30.9 using FeCl(3), whereby the iron leachability was 0.1-0.2%. The introduced iron corresponded to four coordinated species with tetrahedral geometry, primarily low spin ferric iron adsorbing almost 12 mug g(-1) arsenite (99% removal) from a 360 mug(As(III)) L(-1) and 6 mug g(-1) arsenate from a 230 mug(As(V)) L(-1). Adsorption of arsenite and arsenate reached practically a plateau at n(Fe)/n(Si)=0.1 in the series of exchanged tuffs. The oxidation of arsenite to arsenate in the solution in contact with iron modified tuff during adsorption was observed by speciation. The reduction of ferric iron to ferrous iron could be detected in the electrochemical system comprising an iron-clinoptilolite impregnated electrode and was not observed in the dried tuff after adsorption.

Chemically modified maize cobs waste with enhanced adsorption properties upon methyl orange and arsenic.

The surface chemistry of maize naturasorbent was altered in this work by the modifying agents: phosphoric acid and different amines (triethanolamine, diethylenetriamine and 1,4-diaminobutane). Removal of methyl orange (25 mg l(-1)) was <50% by maize corn cobs modified by phosphorylation and higher by the quaternized samples: 68% with the 1,4-diaminobutane and 73% with the diethylenetriamine modificators. Adsorption of arsenite by the samples modified with phosphoric acid/ammonia was 11 microg g(-1), which corresponds to 98% removal from a 550 microg As l(-1) solution for an adsorbent dose of 50 mg ml(-1). The samples modified by phosphoric acid/urea removed 0.4 microg g(-1) arsenate from a 300 mug As l(-1) solution. Adsorption of methyl orange, arsenite and arsenate was superior by the chemically modified maize cobs judged against the initial naturasorbent. For comparison, removal by the commercial anion exchanger was 100% for methyl orange, 45% (5 microg g(-1)) for arsenite and 99% (5 microg g(-1)) for arsenate.

Stability and determination of aflatoxins by high-performance liquid chromatography with amperometric detection.

A method based on reversed-phase high-performance liquid chromatography (RP-HPLC) with amperometric detection with a glassy carbon electrode at a constant potential of 1.4 V is reported for the separation and identification of aflatoxins B1, B2, G1 and G2 in a model mixture. The chromatography was performed on a PAH-Baker column with a ternary mobile phase containing methanol, acetonitrile and aqueous LiClO4 electrolyte. Aflatoxin G1 showed the highest electroactivity in the compound series studied. Calibration curves of aflatoxins G1 and B2 were linear up to 0.2 and 0.3 mmol/l, respectively. Sensitivity varied between 7 and 10 ng for the different aflatoxins. The combination of different HPLC detectors in the analysis of these compounds was applied to investigate the stability of aflatoxins G1 and B2.